Nady Systems UHF 10 user manual

Summary of the content on the page No. 1

Summary of the content on the page No. 2

CONTENTS INTRODUCTION Thank you for purchasing a Nady UHF 10 Diversity Wireless Microphone System and congratulations on your choice. The UHF 10 is the best perfor- mance and price value available in UHF wireless systems and is loaded with features: • Clear channel operation on the wide open, uncluttered UHF band CONTENTS ............................................................................1 for interference-free performance in any application or locale INTRODUCTION .....................

Summary of the content on the page No. 3

UHF 10 RECEIVER 1. Powering the Receiver Plug the 12V AC/DC ADAPTER (12) provided into the DC INPUT JACK (6) on the back of the receiver. Then plug the power supply into an AC outlet.(Note: Any DC source with 300mA capability can also be used.) Press the POWER SWITCH (5) once to turn on the receiver. The POWER ON LED (1) will now light and the receiver is operational. 5 6 7 8 9 10 11 2. Antennas Extend ANTENNAS (4) fully to obtain maximum range. Optimal antenna 5. POWER SWITCH 6. DC INPUT JACK p

Summary of the content on the page No. 4

Microphone Connection (using the UB-10 transmitter with either a 3. The microphone is now ready to use. The A and/or B DIVERSITY LED headworn or lavalier microphone or the UH-10 handheld microphone INDICATORS (2) on the UHF 10 receiver should now be lit, indicating a transmitter) received signal from the transmitter. When ready to speak, slide the For microphone use, either the BALANCED MIC AUDIO OUTPUT XLR (11) transmitter switch to the ON position. Adjust the volume of the receiver as or the 1

Summary of the content on the page No. 5

UB-10 BODYPACK TRANSMITTER 1. Slide open the hinged BATTERY COMPARTMENT (18) and insert a fresh 9V ALKALINE BATTERY (19), observing the correct polarity. A fresh (Note: The INPUT LEVEL CONTROL (27) is deactivated and not used when alkaline battery can last up to 10 hours in use, but in order to ensure the UB-10 is in INSTRUMENT mode. Levels should be adjusted with the optimum performance, it is recommended that the battery be replaced volume control of your instrument.) after 7-8 hours of use. 2

Summary of the content on the page No. 6

tions. [Note: Observe care in selecting P.A. volume, transmitter location and speaker placement so that acoustic feedback (howling and screech- ing) will be avoided. Please also note the pickup pattern characteristics of the microphone selected. Omnidirectional mics pick up sound equally from all directions, and are prone to feedback if not used carefully. Unidirectional mics are more resistant to feedback, but pick up sound sources best that are directly in front of the mic. Also, mics that a

Summary of the content on the page No. 7

SPECIFICATIONS Frequency Response UHF 10 TRANSMITTERS 50 Hz - 15 KHz, +/– 3 dB Audio Inputs Dynamic Range UB-10 Bodypack: 3.5mm 120 dB locking mini-jack 3-way select Total Harmonic Distortion switch for inputs: instrument, < 0.6% headworn mic, or lavalier mic RF Carrier Frequency Range UH-10 Handheld: Integral Nady UHF, choice of single frequencies DM-10D neodymium dynamic Nady wireless systems are type accepted under FCC rules, parts from 794-820 MHz cartridge 90, 74 and 15. Frequency Stability

Summary of the content on the page No. 8