Summary of the content on the page No. 1
VHF Wireless Microphone System
Summary of the content on the page No. 2
CONTENTS CONTENTS ....................................................................................................2 INTRODUCTION .............................................................................................2 USING THIS MANUAL .....................................................................................2 SYSTEM FEATURES ..........................................................................................3 ENCORE I RECEIVER .......................................
Summary of the content on the page No. 3
SYSTEM FEATURES • A vailable on selected frequencies in the VHF high band (171‑216 MHz) for interferencefree, long ‑ ‑range performance • Proprietar y companding circuitr y for an industr y-best 120dB Dynamic Range, and the clearest, most natural sound available • Operating Range: Up to 250 feet typical (depending on site conditions) — up to 500+ feet line-of-sight • Noise-free transmitter ON-OFF operation ENCORE I RECEIVER • Half-rack receiver design with retractable front panel anten
Summary of the content on the page No. 4
ENCORE I RECEIVER 1. Rackmounting the Receiver There are two options available for rackmounting the Encore I receiver: singly or side‑by‑side with another Encore Series receiver. a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of the receiver (as shown) and slide in the optional ERM-12 RACK EARS (9). b. Side-by-side double mounting: After removing the SIDE MOUNT CLIPS (1) from both Encore receivers, join the two receivers with the EJC-2 JOINING CLIP (10) and att
Summary of the content on the page No. 5
5. Connecting the Audio Output The Encore I receiver provides both a fixed mic level BALANCED AUDIO OUTPUT XLR (14) and an adjustable line level UNBALANCED AUDIO OUTPUT 1/4” JACK (13). The level from the UNBALANCED OUTPUT is controlled by the rear panel VOLUME CONTROL (6). (Note: As when making any connection, make sure the amplifier or mixing board volume is at the minimum level before plugging in the receiver to avoid possible sound system damage. Also make sure that the phantom power o
Summary of the content on the page No. 6
16 7 8 4 5 12-15V VOLUME MUTE UNBALANCED OUT DC INPUT BALANCED OUT 13 11 6 14 2 15 1 9 9 1 12 10 12 6
Summary of the content on the page No. 7
WHT HANDHELD MICROPHONE TRANSMITTER 1. Unscrew the BATTERY COMPARTMENT COVER (17) and remove, exposing the BATTERY HOLDER (18). Insert a fresh 9V ALKALINE BATTERY (19), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery can last up to 16 hours in use, but in order to ensure optimum performance, it is recommended that you replace the batter y after ever y 10 hours of use. 2. Turn on t
Summary of the content on the page No. 8
21 20 18 19 17 8
Summary of the content on the page No. 9
WLT LAVALIER/LAPEL OR HEADWORN MICROPHONE BODYPACK TRANSMITTER 1. Snap open the BATTERY COMPARTMENT (22) and insert a fresh 9V BATTERY (23), observing the correct polarity. Close the compartment. 2. The WLT is provided with a 3.5 mm LOCKING JACK (24) for connecting the microphone. Plug in either the LAVALIER/LAPEL (25) or the HEADWORN MICROPHONE (26), as supplied. To secure the connection, turn the metal slip ring on the plug clockwise to thread it on to the jack. T o unplug, reverse the
Summary of the content on the page No. 10
24 29 28 27 22 25 26 22 Opening Battery Compartment 23 10 BAT HI LOW MIC OFF/STANDBY/ON
Summary of the content on the page No. 11
WGT INSTRUMENT BODYPACK TRANSMITTER 1. Snap open the BATTERY COMPARTMENT (30) and insert a fresh 9V BATTERY (31), observing the correct polarity. Close the compartment. The WGT is provided with a 3.5 mm LOCKING JACK (32) for connecting the INSTRUMENT CABLE (35). To secure the connection, turn the metal slip ring on the plug clockwise to thread it on to the jack. T o unplug, reverse the process. Slip the transmitter into a pocket or clip on to your clothes or instrument strap. (Note: As th
Summary of the content on the page No. 12
35 34 33 32 30 30 Opening Battery Compartment 31 12
Summary of the content on the page No. 13
SPECIFICATIONS ENCORE I OVERALL SYSTEM PERFORMANCE Frequency Response 25-20,000 Hz, +/-3dB Dynamic Range 120dB Total Harmonic Distortion < 0.3% RF Carrier Frequency Range 169‑216 MHz Frequency Stability +/- 0.005%, cr ystal controlled Modulation FM (F3E), +/-20KHz max. Operating Range Up to 250 ft. typical (depending on site conditions); up to 500+ feet optimum line-of-sight ENCORE I RECEIVER Controls Power ON/OFF, volume control, mute control Connectors Balanced XLR and unb
Summary of the content on the page No. 14
SERVICE INFORMATION In the U.S. If you are experiencing operational problems with your system, please refer to the Support page at www.nady.com for assistance. Should your wireless system require ser vice, please contact the Nady Ser vice Depar tment at (510) 652‑2411 to obtain a Return Authorization (R/A) Number and service quote (if out of warranty). Make sure the R/A Number is clearly marked on the outside of the package that you are returning. If your unit is out of warranty, please en
Summary of the content on the page No. 15
ONE-YEAR LIMITED WARRANTY Nady Systems, Inc. warrants to the original consumer purchaser that the unit is free from any defects in material or workmanship for a period of one year from the date of original retail purchase. If any such defect is discovered within the warranty period, Nady Systems, Inc. will repair or replace the unit free of charge, subject to verification of the defect or malfunction upon return to Nady Systems. Please do not return your Nady product to the store where it w
Summary of the content on the page No. 16
Nady W ireless Systems are type accepted under FCC rules par ts 90, 74 and 15. The device complies with RSS-210 of Industr y & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause har mful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. 6701 Shellmound Street | Emeryville, CA USA 94608 | | T 510.652.2411 F 510.652.5075 www.nady.com
