Summary of the content on the page No. 1
WMS 80
Wireless Microphone Systems
User Instructions
Summary of the content on the page No. 2
Contents Page FCC Statement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 1. Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 3. The WMS 80 Systems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 3.1. Handheld System . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Parts 74, 15, and 90 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip- ment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no g
Summary of the content on the page No. 4
1h AF/PEAK LEDs: Indicate the received audio level. each wireless channel by a different color. The green LED lighting and the red LED flashing occasionally 2e GAIN: This rotary pot allows you to match the microphone indicate optimum modulation. level to the transmitter’s audio section. If the LEDs do not light, the sensitivity setting on the transmitter 2f Battery Compartment: Refer to Section 9. Setting Up. is too low. 2g CHANNEL: This rotary switch selects the desired carrier fre- The red LED
Summary of the content on the page No. 5
3f CHANNEL: This rotary switch selects the desired carrier fre- on the same set of frequencies as your original equipment, be sure quency. to state the designation of your original Frequency Set (1k/1l, 2i, 3g Belt Clip for fixing the transmitter to your belt. 3k/3l) and the serial number of the original device. We need this 3h Battery Compartment: Refer to Section 9. Setting Up. information to make sure your new equipment will be compatible 3i Antenna: Permanently connected, flexible antenna. w
Summary of the content on the page No. 6
transmitter OFF. To activate the new carrier frequency, switch good condition, the status LED (3c) will continue glowing dimly. the transmitter back ON. (If you try to change the carrier frequen- When the status LED (3c) illuminates brightly the batteries will cy while power to the transmitter is on, the frequency will remain be dead within about 90 minutes. Replace the batteries with the same.) new ones as soon as possible. If the status LED (3c) fails to illuminate the batteries are dead. 9.2.
Summary of the content on the page No. 7
9.4.4. Connecting to Power Remedies: Switch the transmitter ON, move closer to the receiv- er, or turn the SQUELCH control (1c) CCW to the point that the 1. Unfold the two antennas (1e) and extend them fully to obtain MUTE LED (1f) will extinguish. optimum reception. 2. Set the SQUELCH control (1c) fully CCW. 9.5.1. Multichannel Systems 3. Check that the AC mains voltage stated on the sup- plied AC adapter is identical to the AC mains volt- If reception on the selected carrier frequency is distu
Summary of the content on the page No. 8
11. Specifications HT 80 PT 80 SR 80 Carrier frequency 710.2 to 860.9 MHz Modulation FM Audio bandwidth 50 to 20,000 Hz Frequency stability (-10°C to +50°C) ±10 ppm Rated deviation 30 kHz (US1a, US1b: 7.5 kHz) T.H.D. at 1 kHz <0.5% <0.4% Compander Yes Signal/noise ratio typ. 50 dB(A) >100 dB(A) Limiter Yes RF output 10 mW Current consumption typ. 130 mA 145 mA 200 mA Power requirement 2x1.5 V AA size batteries 120/230 V AC, 50/60 Hz Battery life >12 hours >10 hours Input sensitivity typ. -95 dBm
Summary of the content on the page No. 9
12. Frequenzliste - Frequency List - Liste des fréquences - Lista delle frequenze - Lista de frecuencias - Lista de freqüências Set: JPA (Japan Spot) Set: UK69A (UKSpot) Set: UK69B (UKSpot) CHANNEL FREQ. CHANNEL FREQ. CHANNEL FREQ. 0 OFF 0 OFF 0 OFF 1 802.500MHz* 1 854.900MHz* 1 858.200MHz* 2 803.000MHz* 2 855.275MHz* 2 860.400MHz* 3 804.000MHz 3 856.175MHz* 3 860.900MHz* 4 804.875MHz* 4 857.625MHz* 4 860.900MHz 5 805.500MHz* 5 857.625MHz 5 860.900MHz 6 805.500MHz 6 857.625MHz 6 860.900MHz 7 805
Summary of the content on the page No. 10
Set: EU60 Set: NZ1 Set: NZ2 CHANNEL FREQ. CHANNEL FREQ. CHANNEL FREQ. 0 OFF 0 OFF 0 OFF 1 785.600MHz 1 812.200MHz 1 833.200MHz 2 785.800MHz* 2 812.400MHz* 2 833.400MHz* 3 786.000MHz 3 812.600MHz 3 833.600MHz 4 786.200MHz 4 812.800MHz 4 833.800MHz 5 786.400MHz* 5 813.000MHz* 5 834.000MHz* 6 786.600MHz 6 813.200MHz 6 834.200MHz 7 786.800MHz 7 813.400MHz 7 834.400MHz 8 787.000MHz 8 813.600MHz 8 834.600MHz 9 787.200MHz* 9 813.800MHz* 9 834.800MHz* A 787.400MHz A 814.000MHz A 835.000MHz B 787.600MHz
Summary of the content on the page No. 11
WMS 80 W i reless Microphone System 1 e 1 e 1 d 1 a 1 c 1 g 1 i 1 h 1 b 1 f 1 j 1 o 1 q 1 n 1 p 1 m S R 8 0 0 0 0 0 Z 0 0 0 0 S N R : 0 1 0 0 1 A K G S e t : E U S . . HT 80 1:000.000 9:000.000 MHz 2:000.000 10:000.000 MHz 3:000.000 11:000.000 MHz 4:000.000 12:000.000 MHz 5:000.000 13:000.000 MHz A B C 1 k / 1 l 6:000.000 14:000.000 MHz 7:000.000 15:000.000 MHz HT 80 HT80 HT80 8:000.000 D E HT 80 HT80 2 d / 2 j
Summary of the content on the page No. 12
2 k 2 a 2 b 2 c HT 80 HT 80 HT 80 2 g HT 80 2 e 2 h / 2 i 2 f + / 2 j 2 x 1 . 5 V –
Summary of the content on the page No. 13
3 m 3 g 3 m P T 8 0 0 0 0 0 Z 0 0 0 0 S N R : 0 1 0 0 1 A K G S e t : E U S . . 1:000.000 9:000.000 MHz 2:000.000 10:000.000 MHz 3:000.000 11:000.000 MHz 4:000.000 12:000.000 MHz 5:000.000 13:000.000 MHz 6:000.000 14:000.000 MHz 7:000.000 15:000.000 MHz 8:000.000 3 k / 3 l 3 g I I I 3 g 3 j 3 f 2 x 1 . 5 V 3 h I I I I V
