Summary of the content on the page No. 1
B BASS REFLEX SPEAKER SYSTEM ASS REFLEX SPEAKER SYSTEM
DBB
DYNAMIC DBB
BOOST BASS BASS DYNAMIC
BOOST
VOLUME VOLUME
PAUSE S STO TOP. P.O OP PE EN N
PAUSE
TUNING TUNING
SEARCH SEARCH
FM AM FM AM
108 1700
108 1700
104 1041300
1300
104 104
1000 1000
90 90 800 800
92 630
92 630
88 88
530 530
PLAY
PLAY
CD SYNCHRO START RECORDING
CD SYNCHRO START RECORDING
RECORD RECORD
CD MODE CD MODE
AZ 1009 – AZ 1010 CD Radio Cassette Recorder
Instructions for use
Mode d’emploi
Instr
Summary of the content on the page No. 2
Important notes for users in the U.K. Norge Mains plug Typeskilt finnes på apparatens underside. This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet 1 Remove fuse cover and fuse. nettet så lenge apparatet er tilsluttet 2 Fix new fuse which should be a BS1362 5 Amp, nettkontakten. A.S.T.A. or BSI approved type. 3 Refit the fuse cover. For å re
Summary of the content on the page No. 3
Controls..................................4 CD player ...........................7–9 English Power supply .........................5 Cassette recorder..........10–11 Basic functions ......................6 General information.............12 Radio......................................6 Troubleshooting ...................13 Comandes ............................14 Lecteur de CD................17–19 Français Alimentation ........................15 Platine cassette.............20–21 Fonctions de base
Summary of the content on the page No. 4
English BASS REFLEX SPEAKER SYSTEM DBB DYNAMIC BASS BOOST VOLUME STOP.OPEN PAUSE TUNING SEARCH 108 1700 1041300 104 1000 90 800 92 630 88 530 FM AM PLAY CD SYNCHRO START RECORDING RECORD CD MODE CONTROLS 4 3 2 1 8 7 6 5 BASIC FUNCTIONS RADIO 1 POWER: 6 TUNING ................tunes to radio stations CD, TAPE, BAND....selects the sound source 1 BAND: FM, MW ...selects the wave band 2 DBB.......................enhances the bass 3 VOLUME ...............adjusts the volume level 7 CD P
Summary of the content on the page No. 5
POWER SUPPLY Batteries (optional) Open the battery compartment of the set and insert 6 batteries, type R20, UM-1 or D-cells (preferably alkaline). Remove batteries if they are flat or if the set is not going to be used for a long time. Batteries contain chemical substances, so they should be disposed of properly. Mains 1 Check whether the mains voltage as shown on the type plate corresponds to your local mains voltage. If it does not, consult A your dealer or service organisation. The type pla
Summary of the content on the page No. 6
English OFF BAND TAPE FM CD AM DBB DBB VOLUME FM AM 108 1700 104 1300 100 1000 800 98 97 630 POWER DYNAMIC BASS BOOST POWER DYNAMIC BASS BOOST CD SYNCHRO STAR CD SYNCHRO STAR HRO START RECORDING BASIC FUNCTIONS RADIO Switching the set on and off Set the POWER slider to the desired sound source: CD, TAPE, or BAND (for radio). The set is switched off when the POWER slider is set to O OF FF F/TAPE and the keys of the tape deck are released. Note: If you use batteries, switch
Summary of the content on the page No. 7
EC ORD SEARC H PLA CD MODE Y RECORD CD PLAYER Playing a CD 1 Set the POWER slider to CD. 2 Press / OPEN to open the CD compartment. 3 Insert an audio CD (printed side up) and close the CD compartment. ª The CD player starts and scans the contents list of the CD. Then, the CD player stops. Display indication: the total number of tracks. 4 Press the 2; button to start CD play. ª Display indication: the current track number. 5 Press the 9 button to stop CD play. ª Display indication: the total num
Summary of the content on the page No. 8
English CD MODE CD MODE CD PLAYER Search backward ° and forward ¤ Selecting another track Briefly press the ° or ¤ button once/several times to skip to the beginning of the current, previous or subsequent track(s). During CD play: CD play continues automatically with the selected track. When CD play is stopped: Press 2; to start CD play. ª Display indication: the selected track number. Searching for a passage during CD play 1 Hold down the ° or ¤ button to find a particular passage in a forward
Summary of the content on the page No. 9
CD MODE CD PLAYER CD MODE: Programming track numbers You can select a number of tracks and store these in the memory in the desired sequence. You can store any track more than once. A maximum of 20 tracks can be stored in the memory. 1 When CD play is stopped, select the desired track with ° or ¤. 2 As soon as the number of the desired track is displayed, press CD MODE to store the track in the memory. ª PROGRAM appears on the display. P lights up briefly, then the PROGRAM number of the stored
Summary of the content on the page No. 10
English PAUSE STOP¥REC ORD SEARC CD SYNCHRO START RECORDING H PLA Y RECORD CASSETTE RECORDER Playing a cassette 1 Set the POWER slider to TAPE. 2 Press STOP·OPEN 9 / to open the cassette compartment. 3 Insert a recorded cassette with the open side upwards and close the cassette compartment. 4 Press PLAY 1 to start playback. 5 Press 6 or 5 to rewind or fast forward the tape. 6 To stop the tape press STOP·OPEN 9 /. Note: The keys are released at the end of the tape. General information on recordin
Summary of the content on the page No. 11
PAUSE STOP¥REC ORD SEARC CD SYNCHRO START RECORDING H PLA Y RECORD CASSETTE RECORDER Recording from the CD player – CD synchro start 1 Set the POWER slider to CD. 2 Insert a CD and, if desired, program the track numbers. 3 Press STOP·OPEN 9 / to open the cassette compartment. 4 Insert a blank, unprotected, cassette and close the cassette compartment. 5 Press RECORD 0 to start recording. ª Playing of the CD or program starts automatically. 6 For brief interruptions press PAUSE ;. Press the PAUSE
Summary of the content on the page No. 12
English CD RADIO CASSETTE RECORDER STOP OPEN SEARCH PLAY RECORD HSPEEDDUBBING GENERAL INFORMATION General maintenance Do not expose the set, batteries, CDs, or tapes to humidity, rain, sand, or excessive heat (caused by heating equipment or direct sunlight). The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated! You can clean the set with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effec
Summary of the content on the page No. 13
TROUBLESHOOTING If a fault occurs, first check the points listed WARNING below before taking the set for repair. Under no circumstance should you try to If you are unable to solve a problem by repair the set yourself as this will following these hints, consult your dealer or invalidate the guarantee. service center. Problem Possible cause Solution No sound, VOLUME is not adjusted. Adjust volume. no power Headphones are connected. Disconnect headphones. Mains cable is not securely connected. Conn
Summary of the content on the page No. 14
Français BASS REFLEX SPEAKER SYSTEM DBB DYNAMIC BASS BOOST VOLUME STOP.OPEN PAUSE TUNING SEARCH 108 1700 1041300 104 1000 90 800 92 630 88 530 FM AM PLAY CD SYNCHRO START RECORDING RECORD CD MODE COMMANDES 4 3 2 1 8 7 6 5 FONCTIONS DE BASE RADIO 1 POWER: 6 TUNING ................réglage des stations radio CD, TAPE, BAND....sélection de la source audio 1 BAND: FM, MW ...sélection de la bande de 2 DBB.......................amélioration des basses fréquence 3 VOLUME ...............r
Summary of the content on the page No. 15
ALIMENTATION Piles (en option) Ouvrez le compartiment à piles de l’appareil et insérez 6 piles de type R20, UM-1 ou D (alcalines de préférence). Retirez les piles lorsqu’elles sont usées ou si l’appareil doit rester inutilisé pendant une période prolongée. Les piles contiennent des substances chimiques et doivent donc être traitées comme des déchets spéciaux. Secteur 1 Vérifiez que la tension secteur figurant sur la plaque signalétique correspond bien à votre tension secteur locale. A Dans le
Summary of the content on the page No. 16
Français OFF BAND TAPE FM CD AM DBB DBB VOLUME FM AM 108 1700 104 1300 100 1000 98 800 97 630 POWER DYNAMIC BASS BOOST POWER DYNAMIC BASS BOOST CD SYNCHRO STAR CD SYNCHRO STAR HRO START RECORDING FONCTIONS DE BASE RADIO Mise en marche et arrêt Réglez le commutateur coulissant POWER sur la source audio voulue: CD, TAPE, or BAND (pour la radio). L’appareil est arrêté lorsque le commutateur coulissant POWER est en position O OF FF F/TAPE et que les touches des deux platines
Summary of the content on the page No. 17
EC ORD SEARC H PLA CD MODE Y RECORD LECTEUR DE CD Pour lire un CD 1 Réglez le commutateur coulissant POWER sur CD. 2 Appuyez sur / OPEN pour ouvrir le compartiment 3 Introduisez un CD audio (face imprimée vers le haut) et refermez le compartiment. ª Le lecteur d CD se met en marche et balaye la liste du contenu du CD, puis s’arrête. Affichage: nombre total de morceaux. 4 Appuyez sur la touche 2; pour démarrer la lecture du CD. ª Affichage: numéro du morceau en cours. 5 Appuyez sur la touche 9 p
Summary of the content on the page No. 18
Français CD MODE CD MODE LECTEUR DE CD Recherche en arrière ° et en avant ¤ Sélection d’un autre morceau Appuyez brièvement sur la touche ° ou ¤ à une ou plusieurs reprises pour sauter au début du morceau en cours ou d’un morceau précédent ou suivant. Pendant la lecture CD: La lecture continue automatiquement avec le morceau choisi. Si la lecture CD est arrêtée: Appuyez sur 2; pour démarrer la lecture CD. ª Affichage: numéro du morceau sélectionné. Recherche d’un passage en cours de lecture CD 1
Summary of the content on the page No. 19
CD MODE LECTEUR DE CD CD MODE: programmation des morceaux Vous pouvez sélectionner une série de morceaux et les enregistrer en mémoire dans l’ordre voulu. Vous pouvez programmer un morceau quelconque plus d’une fois. La mémoire peut enregistrer 20 morceaux au maximum. 1 La lecture CD étant arrêtée, sélectionnez le morceau voulu avec ° ou ¤. 2 Dès que le numéro du morceau voulu s’affiche, appuyez sur CD MODE pour enregistrer le morceau en mémoire. ª L’affichage indique PROGRAM. P s’allume brièv
Summary of the content on the page No. 20
Français PAUSE STOP¥REC ORD SEARC CD SYNCHRO START RECORDING H PLA Y RECORD PLATINE CASSETTE Lecture d’une cassette 1 Amenez le commutateur coulissant POWER en position TAPE. 2 Appuyez sur STOP·OPEN 9/ pour ouvrir un compartiment cassette. 3 Introduisez une cassette enregistrée, face ouverte vers le haut, et refermez le compartiment. 4 Appuyez sur PLAY 1 pour démarrer la lecture. 5 Appuyez sur les touches 6 ou 5 pour le rebobinage rapide ou le bobinage de la bande. 6 Pour arrêter la bande, appu
