Summary of the content on the page No. 1
Dirt QuaD
Owner’s Manual
read and understand this entire manual before using!
For assistance contact razor. DO nOt return tO stOre.
nOte: Manual illustrations are for demonstration purposes only.
illustrations may not reflect exact appearance of actual product.
specifications subject to change without notice.
Item Number:
Version1_04-11
25143060
Summary of the content on the page No. 2
cOntents Safety Warnings .................................................................................1 Troubleshooting Guide ........................................................................7 Before You Begin .................................................................................2 Dirt Quad Parts List .............................................................................8 Assembly and Set-Up ..........................................................................
Summary of the content on the page No. 3
BeFOre yOu Begin Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have warning: occurred during shipping. Because the Dirt Quad is 95 percent assembled and packed at the factory, there DO NOT USE NON-RAZOR should not be any problems, even if the box has a few scars or dents. PRODUCTS WITH YOUR RAZOR DIRT QUAD. The Dirt Quad MAKE SUR
Summary of the content on the page No. 4
asseMBly anD set-up q attaching the Handlebars Tools required: 6mm Allen wrench warning: Failing to properly adjust and tighten the bolts that affix the handlebars can cause you to lose control and crash. 3 Insert bolts and tighten 1 Using the 6mm Allen 2 Place handlebars in handle- securely. When properly bar clamp in upright, vertical wrench, remove bolts from tightened, the handlebars handlebar clamp. position. should not move forward or back. Note: Handlebar clamps are l
Summary of the content on the page No. 5
37-44 37-44 mm mm BeFOre riDing warning: q charging the Battery Rechargeable batteries are Your electric four wheeler may not have a fully charged battery; therefore it is a good idea to charge the only to be charged under adult battery prior to use. supervision. Always disconnect • Initial charge time: 12 hours • Run time: Up to 40 minutes of continuous ride time. your electric four wheeler from • Recharge time: up to 12 hours, Run time may vary depending on riding conditions
Summary of the content on the page No. 6
repair anD Maintenance q replacing the Fuse warning: To prevent shock, please follow the instructions accordingly and do not skip or combine any steps. 1 Make sure the power switch 2 Under the front fender and 3 Open the fuse cover to is turned OFF. through the frame, locate the expose the fuse. fuse box attached to the top of the battery. Amperage number 4 Remove the fuse and replace 5 Close the fuse cover. with a new one of equal amperage. Note: Amperage rating is located
Summary of the content on the page No. 7
repair anD Maintenance 7 Reset chain tensioner. 8 Position bottom half of the 9 Position top half of the chain chain guard to align mounting guard to align mounting holes holes and screw to frame. and screw to frame. 10 On the inside of the wheel 11 On the outside of the slide bolt through wheel and wheel replace washers and axle and secure with nut. secure with bolt. q chain and sprocket warning: The chain will typically have a “loose spot” and “tight spot” corresponding with
Summary of the content on the page No. 8
trOuBlesHOOting guiDe problem possible cause solution Product is rolling backwards Throttle will not engage if the product is rolling backwards. Come to a Product does not run complete stop and then activate the throttle. Undercharged battery Charge the battery. A new battery should have been charged for at least 12 hours before using the product for the first time and up to 12 hours after each subsequent use. Check all connectors. Make sure the charger connector is tightly plugged into th
Summary of the content on the page No. 9
Dirt QuaD p arts Keep your Dirt Quad running for years with genuine Razor parts. Visit our website or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 1 Handlebar grips (right/left) 12 Motor (350W) 2 Speed controller 13 Chain tensioner 2-1 Sleeve 14 Battery cover (right/left) 3 Handlebar 15 Rear wheel complete 4 Brake lever assembly 16 Caliper brake 5 Handlebar clamps 17 Disc brake 6 Shock 18 Chain 7 Front wheel com
Summary of the content on the page No. 10
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. 9
Summary of the content on the page No. 11
saFety reMinDers PRE-RIDE CHECKLIST Loose Parts Tire Inflation Check and secure all fasteners before every ride. Make sure Periodically inspect the tires for excess wear, and regularly q q steering clamp bolts are locked properly in place. There check the tire pressure and re-inflate as necessary. If you should not be any unusual rattles or sounds from loose get a flat tire, the inner tube can be patched or a new tube parts or broken components. If you are not sure, ask an can be purchased
