Summary of the content on the page No. 1
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Otreap Or ’s Mlauna
Z-Force 54-KH
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA Form No. 769-05053
(October 21, 2009)
Summary of the content on the page No. 2
To The Owner 1 Thank You Thank you for purchasing a Cub Cadet Commercial Zero-Turn If you have any problems or questions concerning the machine, Tractor. It was carefully engineered to provide excellent phone your local Cub Cadet dealer or contact us directly. Cub performance when properly operated and maintained. Cadet’s Customer Support telephone numbers, website address and mailing address can be found on this page. We want to Please read this entire manual prior to operating the equipm
Summary of the content on the page No. 3
Important Safe Operation Practices 2 WARNING! This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol. HEED ITS WARNING! CALIFORNIA PROPOSITION 65 WARNING! Engine Exhaust, some of its constituents, and certain v
Summary of the content on the page No. 4
12. A missing or damaged discharge cover can cause blade 29. If situations occur which are not covered in this manual, use contact or thrown object injuries. care and good judgment. Contact your customer service representative for assistance. 13. Stop the blade(s) when crossing gravel drives, walks, or roads and while not cutting grass. Slope Operation 14. Watch for traffic when operating near or crossing Slopes are a major factor related to loss of control and tip-over roadways. This mach
Summary of the content on the page No. 5
• The fore/aft single-locking adjustment tracks operate on Children roller-bearings for smooth and almost effortless operation. 1. Tragic accidents can occur if the operator is not alert to the The lever for seat track actuation is near the right front presence of children. Children are often attracted to the corner of the seat bottom, and allows fore/aft adjustment machine and the mowing activity. They do not understand of 4”. the dangers. Never assume that children will remain where •
Summary of the content on the page No. 6
12. Do not change the engine governor settings or over-speed General Service the engine. The governor controls the maximum safe 1. Never run an engine indoors or in a poorly ventilated area. operating speed of the engine. Engine exhaust contains carbon monoxide, an odorless, 13. Maintain or replace safety and instruction labels, as and deadly gas. necessary. 2. Before cleaning, repairing, or inspecting, make certain the 14. Observe proper disposal laws and regulations for gas, oil, blad
Summary of the content on the page No. 7
Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manual(s) before attempting to assemble and operate WARNING— ROTATING BLADES Do not put hands or feet near rotating parts or under the cutting deck. Contact with the blade(s) can amputate hands
Summary of the content on the page No. 8
8 s ce ti On 2 — s eaf Otiepra On p rcatiecs Fold along dotted line (represents a 15° slope) Sight and hold this level with a vertical tree... or a corner of a building... or a fence post 15° Use this page as a guide to determine slopes where you may not operate safely. WARNING! Do not operate your lawn mower on such slopes. Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury. Op
Summary of the content on the page No. 9
Assembly & Set-Up 3 Contents of Crate • One Zero-Turn Tractor • One Tractor Operator’s • One Deck Wash Hose Coupler Manual • One Engine Operator’s Manual 2. Remove the two shoulder bolts, nuts and spacers securing Tractor Preparation the seat as shown in Fig. 3-2. Remove the upper crating material from the shipping pallet, and cut any bands or tie straps securing the tractor to the pallet. Use the lift handle to raise the deck to its highest position. Engage the transmission bypass rods on
Summary of the content on the page No. 10
4. Install lanyard using existing self-tapping screw. See Fig. Connecting the Battery Cables 3-4. CALIFORNIA PROPOSITION 65 WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling. Existing Self- tapping Screw CAUTION: When attaching battery cables, always connect the POSITIVE (Red) wire to its terminal first, followed by the NEGATIVE (Black) wire
Summary of the content on the page No. 11
Controls and Features 4 Throttle Control Choke Control SLOW FAST W A R N I N G START CHOKE ON NEUTRAL OFF W A R N I N G ON BRAKE Parking Brake Fuel Shut-Off Valve RH Drive Control Lever Fuel Tank Deck Lift Pedal LH Drive Control Lever PTO Switch Deck Height Index Hour Meter Ignition Switch Figure 4-1 NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that Deck Lift Pedal position on the tractor when facing forward while seated in the The deck lift pedal is located on the right fro
Summary of the content on the page No. 12
Pull the throttle control handle rearward to decrease the engine Ignition Switch speed. The ignition switch is located on the RH console to the right of Choke Knob the operator’s seat. The ignition The choke knob is located on the left side of switch has three positions as the mower next to the operator’s seat. The follows: choke knob controls the position of the engine OFF — The engine and electrical choke. Pull the knob out to choke the engine; system is turned off. push the knob in t
Summary of the content on the page No. 13
Fuel Shut-Off Valve Transmission Bypass Rods (Not Shown) The fuel shut-off valve is located on top of the fuel tank. When The transmission bypass rods (one for each the RH and LH turned in a clockwise direction until it stops, it will shut off the transmission) are located beneath the frame platform, just inside flow of fuel to the engine. When turned in a counterclockwise each rear wheel. See Fig. 3-1 on page 9. direction it will open and allow fuel to flow to the engine. See When engaged, t
Summary of the content on the page No. 14
Operation 5 • Avoid driving too close to trees, creeks, ditches, sand traps, General Safety and other obstacles. • RECEIVE INSTRUCTION — Entirely read this operator’s • Slow down before turning and come to a complete stop manual. Learn to operate this machine SAFELY. Do not risk before any zero turn maneuver. INJURY or DEATH. Allow only those who have become • If you hit a solid object while mowing, turn off the PTO, competent in its usage to operate this tractor. place the steering levers
Summary of the content on the page No. 15
7. Check if deck is level. When correctly adjusted the mower 5. Pull the choke knob up into the CHOKE position. deck should be level side to side, and the front of the deck NOTE: If the engine is warmed up, it may not be necessary should be approximately 1⁄4” lower than the rear of deck. to choke the engine. If deck needs to be leveled, refer to the Maintenance & 6. Push the throttle control to the full forward position. Adjustments section. 7. Turn the ignition key clockwise to the “START”
Summary of the content on the page No. 16
START RUN STOP 3. Move the RH and LH drive control levers inward in the Stopping the Engine neutral position. Refer to Figure 5-1. 1. Place the PTO switch in the “OFF” position. 2. Move the RH and LH drive control levers to the neutral position. 3. Engage the parking brake. Control Lever Moved 4. Move the throttle control to midway between the SLOW Inward and in Neutral and FAST positions. 5. Turn the ignition key to the “OFF” position and remove the key from the ignition switch. NOTE:
Summary of the content on the page No. 17
START START RUN RUN STOP STOP START RUN STOP 1. To turn to the left, move the left drive control lever Driving the Tractor Forward rearward of the right lever. See Fig. 5-3. WARNING! Keep all movement of the drive control levers slow and smooth. Abrupt movement of the control levers can affect the stability of the tractor and could cause the tractor to flip over, which may Forward Left Turn result in serious injury or death to the operator. 1. Slowly and evenly move both drive control leve
Summary of the content on the page No. 18
START START RUN RUN STOP STOP START RUN STOP Driving the Tractor In Reverse Turning While Driving Rearward To turn the tractor while driving rearward, move the control WARNING! Always look behind and down on both levers as necessary so that one lever is forward of the other. The sides of the tractor before backing up. Always look tractor will turn in the direction of the forward control lever. behind while traveling in the reverse direction. 1. To turn to the left while traveling in revers
Summary of the content on the page No. 19
START START RUN RUN STOP STOP Executing a Zero Turn Executing a “Y” manuever For low traction conditions, follow these procedures for zero WARNING! When executing a zero turn, the tractor turns (the “Y-manuever”): MUST BE STOPPED. Executing a zero turn while the tractor is moving can significantly reduce your To turn clockwise (front of machine moves toward RIGHT) when control of the tractor and will cause severe turf traveling FORWARD: defacement to occur. 1. Come to a stop, 1. Stop the
Summary of the content on the page No. 20
9. To prevent rutting or grooving of the turf, if possible, Operating The PTO change the direction that the strips are mowed by Operate the PTO clutch as follows: approximately 45° for the next and each subsequent 1. Move the throttle control lever to approximately the mid mowing. throttle position. WARNING! Be careful when crossing gravel paths 2. Pull the PTO switch upward to the “ENGAGED” position. or driveways. Disengage the PTO and raise the deck to the highest position before cross
