Summary of the content on the page No. 1
Henny Penny
Cold Bases
Model CBC/CBR-103
Model CBC/CBR-104
Model CBC/CBR-105
Model CBC/CBR-106
Model CBC/CBR-107
OPERATOR’S MANUAL
Summary of the content on the page No. 2
Model CBC/CBR-103,104,105,106,107 LIMITED WARRANTY FOR HENNY PENNY APPLIANCES Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacement parts: NEW EQUIPMENT: Any part of a new appliance, except lamps and fuses, which proves to be defective in material or workmanship within two (2) years from date of original installation, will be repaired or replaced without charge F.O.B. factor
Summary of the content on the page No. 3
Model CBC/CBR-103,104,105,106,107 TABLE OF CONTENTS Section Page Section 1. INTRODUCTION ................................................................................................................... 1-1 1-1. Henny Penny Cold Bases ............................................................................................ 1-1 1-2. Features ....................................................................................................................... 1-1 1-3. Proper Care ........
Summary of the content on the page No. 4
Model CBC/CBR-103,104,105,106,107 SECTION 1. INTRODUCTION 1-1. COLD BASES The Henny Penny cold bases are self-serve units, designed to hold chilled, or refrigerated products. The units are electronically controlled for easy use and for consistent operation. 1-2. FEATURES • Can be matched with hot or cold merchandisers in all lengths • Electronic controls • Stackable units • Low speed air circulation • Easily maintained • T8 fluorescent lighting with electronic ballast (CE-magnetic bal
Summary of the content on the page No. 5
Model CBC/CBR-103,104,105,106,107 1-5. SAFETY The Henny Penny cold bases have many safety features incorporated. However, the only way to ensure a safe operation is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures. Where information is of particular importance or safety related, the words NOTICE, CAUTION, and WARNING, are used. Their usage is described below.
Summary of the content on the page No. 6
Model CBC/CBR-103,104,105,106,107 SECTION 2. INSTALLATION 2-1. INTRODUCTION This section provides the installation and unpacking instructions for the Henny Penny cold bases. Installation of this unit should be performed only by a qualified service technician. Do not puncture the unit with any objects such as drills or screws, or component damage or electrical shock could result. 2-2. UNPACKING The Henny Penny cold base has been tested, inspected, and expertly packed to insure arrival a
Summary of the content on the page No. 7
Model CBC/CBR-103,104,105,106,107 2-2. UNPACKING (Continued) Take care when moving the unit to prevent personal injury or damage to the refrigeration system. The units weigh between 400 (182 kg) and 580 lbs. (263 kg). 4. Peel off any protective covering from exterior of the cabinet. 5. Install the grids into unit. 6. Your cold base is now ready for operation. 2-3. ELECTRICAL The cold base is available as a 120 VAC, 60 Hz. or 230VAC, 50Hz, single phase unit, both for domestic
Summary of the content on the page No. 8
Model CBC/CBR-103,104,105,106,107 2-4. LOCATION Place the cold bases in an area where product can be loaded and unloaded without interruption. For proper operation, level the unit by adjusting the bolts under the base, and leave 3 feet (91.44 cm) clearance behind the unit for ventilation and service. For maximum efficiency, units should be operated in an air-condi- tioned environment, with maximum air temperature of 75° F (24° C), and 55% relative humidity. Wait at least 4 hours before p
Summary of the content on the page No. 9
Model CBC/CBR-103,104,105,106,107 2-7. COMPRESSOR SIZE Model CBC Motor HP CBR Motor HP AND LOAD CBC/ BTU Load UL CE UL CE CBR R-22 R-134a R-22 R-134a 103 2830 1/3 1/2 Remote 104 2830 1/3 1/2 Compressor 105 3840 1/2 1/2 Supplied 106 3840 1/2 1/2 By Other 107 3840 1/2 1/2 BTU load sized at evaporator temperature + 20 F or -6 C. 2-8. FOOT PRINT DRAWING CBR MODELS DRAIN & REFRIGERATION CONNECTIONS 2-4 403
Summary of the content on the page No. 10
Model CBC/CBR-103,104,105,106,107 2-9. FLUORESCENT LIGHTING No. AND LAMP REPLACEMENT Model of Lights Size CBR/CBC-103 1 36 in. (.914 m) CBR/CBC-104 1 48 in. (1.22 m) CBR/CBC-105 1 24 in. (.610 m) 1 36 in. (.914 m) CBR/CBC-106 2 36 in. (.914 m) CBR/CBC-107 1 36 in. (.914 m) 1 48 in. (1.22 m) Replacement: UL Units 1. Pull the lamp out of the sockets. 2. Remove the lamp guard caps. 3. Install new fluorescent bulb in reverse order. CE Units 1. Remove the lamp cover. 2. Rotate the lamp.
Summary of the content on the page No. 11
Model CBC/CBR-103,104,105,106,107 1. Remove bolts securing the top to the skid, and save bolts 2-10. HOT or COLD TOP ON A for later use. COLD BASE INSTALLA- TION INSTRUCTIONS 2. Carefully set top on top of the cold base. Take care when moving the unit to prevent personal injury or damage to the refrigeration system. The units weigh between 400 (181 kg) and 580 lbs. (263 kg). 3. Line up the 2 front holes and secure the top to the base using the bolts from step 1. F
Summary of the content on the page No. 12
Model CBC/CBR-103,104,105,106,107 SECTION 3. OPERATION 3-1. INTRODUCTION This section provides explanations of all controls, along with operating procedures and daily maintenance. Read the Introduction, Installation and Operation Sections before operating the unit. Wait at least 4 hours before plugging the unit into an electrical supply. The gases and oils in the refrigeration system need to settle before operating the compressor, or damage to the compressor could result. 3-2. OP
Summary of the content on the page No. 13
Model CBC/CBR-103,104,105,106,107 3-2. OPERATING CONTROLS (Continued) 3 2 1 Figure 3-1 4 5 303 3-2
Summary of the content on the page No. 14
Model CBC/CBR-103,104,105,106,107 3-3. BASIC OPERATION 1. Turn power switch to ON position. 2. Wait for temperature to reach operating temperature, 36 to 38° F (2.2 to 3.3° C). 3. Place chilled, prepackaged product into case. Do not stock product in the case beyond the load height limit of 9 inches (23 cm), or over the front edge. Prod- uct temperatures may become unsafe, and increase operating costs. Do not use mechanical devices or other means to quicken the defrosting process, other
Summary of the content on the page No. 15
Model CBC/CBR-103,104,105,106,107 3-4. CLEANING Every 3 Months: (Continued) 1. Remove all electrical power supplied to the unit by unplug- ging the power cord from the wall, or by turning off the wall circuit breaker. 2. Remove all product from the unit. 3. Remove the riser and trays from the unit and clean with soap and water at a sink. 4. Clean interior surfaces with a soft cloth, soap and water. Do not use steel wool, other abrasive cleaners or cleaners/sanitizers containi
Summary of the content on the page No. 16
Model CBC/CBR-103,104,105,106,107 3-5. PROGRAMMING 1. Press and hold for 4 seconds. The “DEF/SET” light flashes in display. Temperature Setpoint 2. Press the or to change the temperature setpoint, within 5 seconds. After 5 seconds, the last entered setpoint stays in memory. Other Parameters 3. Press to access the other parameters. Each press of the accesses the next parameter. The parameters are: d: (differential) (-15...15 range) LS: lower set; lower user-access
Summary of the content on the page No. 17
Model CBC/CBR-103,104,105,106,107 3-5. PROGRAMMING dS: (defrost system (computation)) dF=digifrost feature; Continued defrost start time based on total compressor running time. rt=real time; defrost start frequency, based on real time dI: (defrost interval) defrost frequency in hours, based on the selection of “dS” dE: (defrost endurance) total (maximum) length of a defrost cycle, expressed in minutes. (1...99 range) dL: (display lock) temperature display is locked during
Summary of the content on the page No. 18
Model CBC/CBR-103,104,105,106,107 DIAGRAM FOR CBC MODEL 3-7 303
Summary of the content on the page No. 19
Model CBC/CBR-103,104,105,106,107 DIAGRAM FOR CBR MODEL 303 3-8
Summary of the content on the page No. 20
Model CBC/CBR-103,104,105,106,107 230V-50Hz-1ph-CE 3-9 303
