Summary of the content on the page No. 1
OPERATOR’S MANUAL
MODEL STT
PART NUMBER 03059
Summary of the content on the page No. 2
WARNING:
Summary of the content on the page No. 3
Section 1 GENERAL INFORMATION &
1.1 INTRODUCTION
)
! "#$%% #$&
Summary of the content on the page No. 4
Section 2 SAFETY INFORMATION 2.1 INTRODUCTION
2
%
*"$;< +,
0
0
1
Summary of the content on the page No. 5
Section 2 2.3 BEFORE OPERATION '9
$
CONSIDERATIONS (CONT'D)
6
" '' ?
@ A /
!
1
1
#
Summary of the content on the page No. 6
Section 2 '8 " 2.4 OPERATION CONSIDERATIONS (CONT'D) '> %
8 %
1
> # '6
Summary of the content on the page No. 7
Section 2 2.6 SAFETY AND INSTRUCTIONAL DECALS WARNING DANGER INSTALL BELT COVER BEFORE SPINNING BLADE OPERATING MACHINE READ OPERATOR'S MANUAL 481039 KEEP CLEAR CONTACT CAN INJURE FORWARD 48071 R F REVERSE WARNING 481568 ROTATING BLADES AND BELTS KEEP HANDS, FEET & CLOTHING CLEAR KEEP ALL GUARDS IN PLACE SHUT OFF ENGINE & DISENGAGE BLADE CLUTCH BEFORE SERVICING IMPORTANT ADJUSTMENT CLEAR AREA OF DEBRIS BEFORE MOWING PROCEDURES USE CAUTION IN DIRECTING DISCHARGE CAUTION KEEP BYSTANDERS, CHILDREN
Summary of the content on the page No. 8
Section 3 SPECIFICATIONS 3.1 ENGINE
! " !#$%&'() & ! " !#%*&$+) ,- ! ".%%'#/!( (') 0 ,-.%%' ,
Summary of the content on the page No. 9
Section 3 3.3 TRACTOR (CONT'D)
! A
., (#'(0
2
(#&0 3.4 CUTTER DECK A
Summary of the content on the page No. 10
Section 4 7
Summary of the content on the page No. 11
Section 4 OPERATING INSTRUCTIONS
CAUTION: ! Do not attempt to operate this mower unless you have read this manual. Learn the location and
" purpose of all controls and instruments before you
# operate this mower. $
% # $
Summary of the content on the page No. 12
Section 4 DUMP VALVE !! '
CONTROL LEVER
+
&
#
'
#
& % # " #! '
&
& '
#
%
'
Summary of the content on the page No. 13
Section 4 - 8
; 4.5 GROUND TRAVEL AND STEERING
4 <95 -IMPORTANT- = 8
%
# # 4 <=5 9 8
%
Summary of the content on the page No. 14
Section 4
# #
! # #
# #
, %
# #
#
'
$
Summary of the content on the page No. 15
Section 4 4.7 HILLSIDE OPERATION $ . WARNING: -
&
DO NOT operate on steep slopes. To check a slope,
attempt to back up it (with the cutter deck down). If the machine can back up the slope without the wheels slipping, reduce speed and use extreme = 8
%
#&
Summary of the content on the page No. 16
Section 4 ; +
4.10 REMOVING CLOGGED MATERIAL !
%
ROTATING BLADES > " # NEVER PUT YOUR HANDS INTO THE DISCHARGE CHUTE FOR ANY REASON! Shut off the engine and <
& remove the key and only then use a stick or similar @
!$@
Summary of the content on the page No. 17
Section 4 LANYARD PIN 4.13 ADJUSTING CUTTING HEIGHT
% &?
7/
>
76-/
#?
E WARNING: Do not adjust the cutting height with the mower blades rotating. Disengage the power to the cutter blades and then adjust cutting height. HEIGHT ADJUSTMENT PEDAL 390S0140 Figure 4-6 Adjusting Cutting Height 7 (
& - $
?
Summary of the content on the page No. 18
Section 5 TROUBLESHOOTING CUTTING CONDITIONS CAUSE CURE CONDITION Stringers - Occasional
Blades of Uncut Grass
Width of Deck ! " SGB020 Streaking - Strips of
Uncut Grass in Cutting Path #
Summary of the content on the page No. 19
Section 5 TROUBLESHOOTING (CONT'D) CAUSE CONDITION CURE Uneven Cut on Flat
Ground - Wavy High-Low !
Appearance, Scalloped Cut, or Rough Contour
&
' ( "
% ) )
*"
!
)
*"
Width of Deck SGB020 U
Summary of the content on the page No. 20
Section 5 TROUBLESHOOTING (CONT'D) CAUSE CURE CONDITION Scalping - Blades
Hitting Dirt or Cutting Very Close to
the Ground
)
.
%
)
.
