Summary of the content on the page No. 1
Owners Manual model 405012x108A
̸· ײ¬®«½¬·±² Þ±±µ ½±²¬¿·² ·²º±®³¿¬·±² º±® »ª»®¿´ ³±¼»´ò
λ¿¼ ¿²¼ µ»»° ¬¸· ¾±±µ º±® º«¬«®» ®»º»®»²½»ò
̸· ¾±±µ ½±²¬¿·² ·³°±®¬¿²¬ ·²º±®³¿¬·±² ±²
ÍßÚÛÌÇô ßÍÍÛÓÞÔÇô ÑÐÛÎßÌ×ÑÒô ßÒÜ Óß×ÒÌÛÒßÒÝÛò
ÐÎÑÜËÝÌ ×ÒÚÑÎÓßÌ×ÑÒ
̸» ±©²»® ³«¬ ¾» ½»®¬¿·² ¬¸¿¬ ¿´´
¬¸» °®±¼«½¬ ·²º±®³¿¬·±² · ·²½´«¼»¼ ©·¬¸ ¬¸» «²·¬ò
̸· ·²º±®³¿¬·±² ·²½´«¼»
¬¸» ×ÒÍÌÎËÝÌ×ÑÒ ÞÑÑÕÍô
¬¸» ÎÛÐÔßÝÛÓÛÒÌ ÐßÎÌÍ ¿²¼ ¬¸» ÉßÎÎßÒÌ×ÛÍò
̸· ·²º±®³¿¬·±² ³«¬ ¾» ·²½´«¼»¼ ¬± ³¿µ» «®» ¬¿¬» ´¿© ¿²¼ ±¬¸»® ´¿
Summary of the content on the page No. 2
TABLE OF CONTENTS MOWING AND BAGGING TIPS . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 RESPONSIBILITY OF THE OWNER . . . . . . . . . . . . . . . . . . 3 MAINTENANCE CHART . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 SAFETY RULES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 3
OWNERS INFORMATION This instruction book is for several different models. The instructions are written for a person with some mechanical ability. Like most ser- vice books, not all the steps are described. Steps on how to loosen or tighten fasteners are steps anyone can follow with some mechanical ability. Read and follow these instructions before you use the unit. Engine Exhaust, some of its constituents, and Know your product: If you understand the unit and how the unit oper- certain vehicle
Summary of the content on the page No. 4
OWNERS INFORMATION c. Do not turn sharply. Use care when backing. d. Use counterweights or wheel weights when suggested in the Instruction Book. 18. Do not operate this machine if you are taking drugs or other medication which can cause drowsiness or affect your ability to operate this machine. 19. Do not use this machine if you are mentally or physically unable to operate this machine safely. 20. Data indicates that operators, age 60 years and above, are involved in a large percentage of rid
Summary of the content on the page No. 5
SAFE MOWING GUIDE Each person that operates power controls and how they work. In an equipment must learn to use correct and emergency, how fast you can stop the safe mowing procedures. To help you blade is important. Learn how to control learn, carefully read the following the mower at all times. pages. Most of the time the operator was Many engines are started by hand. When not correctly shown or did not read the you use a pull start or rope start, place instructions on the unit or in the Instr
Summary of the content on the page No. 6
SAFE MOWING GUIDE mower was completely assembled at the of the mower. Stop the engine. Let the When you mow, remember that children store, you must still check the mower engine and transmission cool before are attracted to the mower. Always use according to the assembly instructions. servicing the mower. Remember, exhaust caution when mowing around obstacles Make sure the mower is correctly fumes are dangerous. Never operate the like trees or shrubs or when moving assembled and that all fastener
Summary of the content on the page No. 7
SAFE MOWING GUIDE Also, the grass bagger will function better feel new or excessive vibration, a blade that is not sharp or at a slow when the engine is operating at maximum immediately stop the engine and check for engine speed you can damage the grass. speed. On slopes, decrease the ground the problem. Vibration can be a warning of Move the throttle control to the FAST speed and use care making sure the a problem. Keep all nuts, bolts and screws position when mowing and using the grass mower f
Summary of the content on the page No. 8
STEPS TO FOLLOW BEFORE MOWING Be sure to dress correctly. Wear hard shoes, not sandals or tennis shoes. Examine the blade. A blade that is bent, cracked, or damaged must be replaced with a factory replacement blade. Fill the fuel tank outside. Clean off spilled fuel. Read and follow the Owners Manual, the instructions with the engine, and the instructions with any attachments. Owners Manual instructions are for your safety and the safety of others. Exhaust fumes are dangerous. Start the engine
Summary of the content on the page No. 9
INTERNATIONAL PICTORIALS INTERNATIONAL PICTORIALS IMPORTANT: Some of the following pic- 5 Flush Eyes Immediately With Water. 10 DANGER: No Step. torials are located on your unit or on Get Medical Help Fast. 11 DANGER: Keep Feet And Hands literature supplied with the product. Be- 6 IMPORTANT: Read Owners Manual Away From Rotating Blade. fore you operate the unit, learn and un- Before Operating This Machine. 12 DANGER: Keep Hands Away From derstand the purpose for each pictorial. Rotating Blade.
Summary of the content on the page No. 10
ASSEMBLY ASSEMBLY WARNING: Before doing any assembly or mainte- Read and follow the assembly and adjustment instructions for your nance to the mower, remove the wire from the spark mower. All fasteners are in the parts bag. Do not discard any parts plug. or material until the unit is assembled. NOTE: In this instruction book, left and right describe the loca- tion of a part with the operator on the seat. PARTS BAG CONTENTS The fasteners and other loose parts are shown below. The fasteners are s
Summary of the content on the page No. 11
ASSEMBLY HOW TO INSTALL THE FRONT WHEELS Use a knife and cut the four sides of the container. Install the front 2. Make sure the valve stem is to the outside of the tractor. Slide wheels in the container. the front wheel on the spindle. 3. Fasten each front wheel with washer, washer and cotter pin. NOTE: Use a piece of wood about 4 feet (1.25 meters) long to Bend the ends of the cotter pin appart to keep the front wheel raise the front of the tractor. If a piece of wood cannot be found, on the s
Summary of the content on the page No. 12
ASSEMBLY 3. Check the operating position of the seat. If the seat needs to HOW TO INSTALL THE SEAT be adjusted, loosen the two wing bolts. Slide the seat forward 1. Carefully remove the plastic bag from the seat. or backward along the seat adjusting holes as shown. Tighten Use the fasteners shown below to install the seat. The fasteners are the wing bolts (A). shown at full size. Seat Seat Hinge Seat Adjusting Hole B (A) (B) A 1001054 17x47 NOTE: Fasteners may be attached to seat for shipping p
Summary of the content on the page No. 13
ASSEMBLY 3. Use a 12 volt battery charger to charge the battery. Charge at MAINTENANCE FREE BATTERY a rate of 6 amperes for one hour. If you do not have a battery IMPORTANT: Before you attach the battery cables to the charger, have an authorized service center charge the battery. battery, check the battery date. The battery date tells if the 4. Install the battery and battery tray. Make sure the positive (+) battery must be charged. terminal is on the left side. 1. Check the top of the battery f
Summary of the content on the page No. 14
ASSEMBLY IMPORTANT! BEFORE YOU START MOWING Check the engine oil. WARNING: Before doing any assembly or mainte- nance to the mower, remove the wire from the spark Fill the fuel tank with gasoline. plug. Check the level of the mower housing. Check the air pressure of the tires. NOTE: In this instruction book, left and right describe the loca- Make sure the battery cables are attached. tion of a part with the operator on the seat. IMPORTANT: This unit is equipped with an internal combustion HOW T
Summary of the content on the page No. 15
OPERATION Blade Rotation Control Throttle Control Lever Clutch / Brake Pedal Shift Lever Lift Lever Figure 5 LOCATION OF CONTROLS BLADE ROTATION CONTROL: Use the blade rotation SHIFT LEVER: Use the shift lever to change the speed of the control to start and stop the rotation of the blade. unit. CLUTCH / BRAKE PEDAL: The pedal has two functions. LIFT LEVER: Use the lift lever to change the height of cut. The first function is a clutch. The second function is a brake. HEADLIGHT SWITCH: The headlig
Summary of the content on the page No. 16
OPERATION ATTACHMENTS Disengage This unit can use many different attachments. See the attachment Position page in this book. This unit can pull attachments like a lawn sweeper, a lawn aerator, a hopper spreader or a small trailer. This unit can not use attachments that engage the ground like a plow, a disk harrow, or a cultivator. For trailer and pull behind attachments or trailers, the maximum Blade Rotation Control gross weight is 250 pounds. Gross weight is the weight of the Engage Position a
Summary of the content on the page No. 17
OPERATION HOW TO SET THE PARKING BRAKE 1. Completely push the clutch/brake pedal forward. 2. Lift the parking brake lever (Figure 7). 3. Remove your foot from the clutch/brake pedal and then release the parking brake lever. Make sure the parking brake will hold the unit. 4. To release the parking brake, completely push the clutch/brake pedal forward. The parking brake will automatically release. WARNING: Before you leave the operators position, move the shift lever to the neutral (N) position
Summary of the content on the page No. 18
OPERATION ØÑÉ ÌÑ ÑÐÛÎßÌÛ É×ÌØ ÌØÛ ÓÑÉÛÎ ØÑËÍ×ÒÙ WARNING: The deflector is a safety device. Do not re- 4. Slowly move the blade rotation control to the ENGAGE move the deflector. The deflector forces the dis- position. charged material toward the ground. Always keep the 5. Push the clutch/brake pedal completely forward. deflector in the down position. If the deflector is dam- aged, replace the deflector with an original equipment 6. Move the shift lever to one of the speed settings. part from an
Summary of the content on the page No. 19
OPERATION CAUTION: A mixture of alcohol (ethanol or methanol) and BEFORE STARTING THE ENGINE gasoline (called gasohol), will attract moisture and cause acid deposits during storage. While the unit is in storage, the acids CHECK THE OIL in the fuel can damage the fuel system. NOTE: The engine was shipped from the factory filled with oil. Check the level of the oil. Add oil as needed. See the engine To prevent engine problems with the fuel system, empty the fuel manufacturers instructions for the
Summary of the content on the page No. 20
OPERATION OPERATING TIPS 1. Check the blade rotation control for correct adjustment. For the 5. Before you make an inspection, adjustment (except for the car- blade(s) to disengage correctly, the adjustment must be cor- buretor) or repair, make sure the wire from the spark plug is dis- rect. connected. 2. Before you use the unit, check the oil in the engine and add oil 6. For longer life of the battery on electric start models, charge the if necessary. battery every three months. 3. If the engin
