Rover 425621x108A user manual

Summary of the content on the page No. 1

Owner’s Manual model 425621x108A
̸·­ ײ­¬®«½¬·±² Þ±±µ ½±²¬¿·²­ ·²º±®³¿¬·±² º±® ­»ª»®¿´ ³±¼»´­ò
λ¿¼ ¿²¼ µ»»° ¬¸·­ ¾±±µ º±® º«¬«®» ®»º»®»²½»ò
̸·­ ¾±±µ ½±²¬¿·²­ ·³°±®¬¿²¬ ·²º±®³¿¬·±² ±²
ÍßÚÛÌÇô ßÍÍÛÓÞÔÇô ÑÐÛÎßÌ×ÑÒô ßÒÜ Óß×ÒÌÛÒßÒÝÛò
ÐÎÑÜËÝÌ ×ÒÚÑÎÓßÌ×ÑÒ
̸» ±©²»® ³«­¬ ¾» ½»®¬¿·² ¬¸¿¬ ¿´´
¬¸» °®±¼«½¬ ·²º±®³¿¬·±² ·­ ·²½´«¼»¼ ©·¬¸ ¬¸» «²·¬ò
̸·­ ·²º±®³¿¬·±² ·²½´«¼»­
¬¸» ×ÒÍÌÎËÝÌ×ÑÒ ÞÑÑÕÍô
¬¸» ÎÛÐÔßÝÛÓÛÒÌ ÐßÎÌÍ ¿²¼ ¬¸» ÉßÎÎßÒÌ×ÛÍò
̸·­ ·²º±®³¿¬·±² ³«­¬ ¾» ·²½´«¼»¼ ¬± ³¿µ» ­«®» ­¬¿¬» ´¿©­ ¿²¼ ±¬¸»® ´¿

Summary of the content on the page No. 2

TABLE OF CONTENTS OPERATING TIPS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 MOWING AND BAGGING TIPS . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 RESPONSIBILITY OF THE OWNER . . . . . . . . . . . . . . . . . . 3 MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 SAFETY RULES . . . . . . . . . . . . . . . . . . . . . . . . . .

Summary of the content on the page No. 3

OWNER’S INFORMATION This instruction book is for several different models. The instructions are written for a person with some mechanical ability. Like most ser- vice books, not all the steps are described. Steps on how to loosen or tighten fasteners are steps anyone can follow with some mechanical ability. Read and follow these instructions before you use the unit. Engine Exhaust, some of its constituents, and Know your product: If you understand the unit and how the unit oper- certain vehicle

Summary of the content on the page No. 4

OWNER’S INFORMATION b. Limit loads to those you can safely control. c. Do not turn sharply. Use care when backing. d. Use counterweights or wheel weights when suggested in the Instruction Book. 19. Do not operate this machine if you are taking drugs or other medication which can cause drowsiness or affect your ability to operate this machine. 20. Do not use this machine if you are mentally or physically unable to operate this machine safely. 21. Data indicates that operators, age 60 years and

Summary of the content on the page No. 5

SAFE MOWING GUIDE Each person that operates power controls and how they work. In an equipment must learn to use correct and emergency, how fast you can stop the safe mowing procedures. To help you blade is important. Learn how to control learn, carefully read the following the mower at all times. pages. Most of the time the operator was Many engines are started by hand. When not correctly shown or did not read the you use a pull start or rope start, place instructions on the unit or in the Instr

Summary of the content on the page No. 6

SAFE MOWING GUIDE store, you must still check the mower engine and transmission cool before When you mow, remember that children according to the assembly instructions. servicing the mower. Remember, exhaust are attracted to the mower. Always use Make sure the mower is correctly fumes are dangerous. Never operate the caution when mowing around obstacles assembled and that all fasteners are tight. engine inside a building. like trees or shrubs or when moving Make sure the engine has the correct b

Summary of the content on the page No. 7

SAFE MOWING GUIDE Also, the grass bagger will function better feel new or excessive vibration, a blade that is not sharp or at a slow when the engine is operating at maximum immediately stop the engine and check for engine speed you can damage the grass. speed. On slopes, decrease the ground the problem. Vibration can be a warning of Move the throttle control to the FAST speed and use care making sure the a problem. Keep all nuts, bolts and screws position when mowing and using the grass mower f

Summary of the content on the page No. 8

STEPS TO FOLLOW BEFORE MOWING Be sure to dress correctly. Wear hard shoes, not sandals or tennis shoes. Examine the blade. A blade that is bent, cracked, or damaged must be replaced with a factory replacement blade. Fill the fuel tank outside. Clean off spilled fuel. Read and follow the Owner’s Manual, the instructions with the engine, and the instructions with any attachments. Owner’s Manual instructions are for your safety and the safety of others. Exhaust fumes are dangerous. Start the engine

Summary of the content on the page No. 9

INTERNATIONAL PICTORIALS INTERNATIONAL PICTORIALS IMPORTANT: Some of the following pic- 5 Flush Eyes Immediately With Water. 10 DANGER: No Step. torials are located on your unit or on Get Medical Help Fast. 11 DANGER: Keep Feet And Hands literature supplied with the product. Be- 6 IMPORTANT: Read Owner’s Manual Away From Rotating Blade. fore you operate the unit, learn and un- Before Operating This Machine. 12 DANGER: Keep Hands Away From derstand the purpose for each pictorial. Rotating Blade.

Summary of the content on the page No. 10

ASSEMBLY ASSEMBLY WARNING: Before doing any assembly or mainte- Read and follow the assembly and adjustment instructions for your nance to the mower, remove the wire from the spark mower. All fasteners are in the parts bag. Do not discard any parts plug. or material until the unit is assembled. NOTE: In this instruction book, left and right describe the loca- tion of a part with the operator on the seat. PARTS BAG CONTENTS The fasteners and other loose parts are shown below. The fasteners are s

Summary of the content on the page No. 11

ASSEMBLY HOW TO INSTALL THE FRONT WHEELS Use a knife and cut the four sides of the container. Install the front 2. Make sure the valve stem is to the outside of the tractor. Slide wheels in the container. the front wheel on the spindle. 3. Fasten each front wheel with washer, washer and cotter pin. NOTE: Use a piece of wood about 4 feet (1.25 meters) long to Bend the ends of the cotter pin appart to keep the front wheel raise the front of the tractor. If a piece of wood cannot be found, on the s

Summary of the content on the page No. 12

ASSEMBLY 3. Check the operating position of the seat. If the seat needs to HOW TO INSTALL THE SEAT be adjusted, loosen the two wing bolts. Slide the seat forward 1. Carefully remove the plastic bag from the seat. or backward along the seat adjusting holes as shown. Tighten Use the fasteners shown below to install the seat. The fasteners are the wing bolts (A). shown at full size. Seat Seat Hinge Seat Adjusting Hole B (A) (B) A 1001054 17x47 NOTE: Fasteners may be attached to seat for shipping p

Summary of the content on the page No. 13

ASSEMBLY HOW TO ASSEMBLE THE GAUGE WHEELS Use the fasteners shown below to install the gauge wheels. The fasteners are shown at full size. (A) (B) 31x11 17x91 Gauge Wheel Axle Bolt B 1. Attach the gauge wheels to the axle bolts with the fasteners. A Figure 4 NOTE: The axle bolt is mounted in the LOW position. To change the position to a higher cutting position, see “How To Adjust The Gauge Wheels” in the Maintenance section. 3. Use a 12 volt battery charger to charge the battery. Charge at MAINT

Summary of the content on the page No. 14

ASSEMBLY IMPORTANT! BEFORE YOU START MOWING Check the engine oil. WARNING: Before doing any assembly or mainte- nance to the mower, remove the wire from the spark Fill the fuel tank with gasoline. plug. Check the air pressure of the tires. Check the level of the mower housing. Make sure the battery cables are attached. NOTE: In this instruction book, left and right describe the Make sure the wire is attached to the spark plug. location of a part with the operator on the seat. IMPORTANT: This un

Summary of the content on the page No. 15

OPERATION Throttle Control Lever Blade Rotation Control Brake Pedal Speed Control Pedal Lift Lever Figure 6 LOCATION OF CONTROLS BLADE ROTATION CONTROL: Use the blade rotation AUTOMATIC DRIVE DISCONNECT: Use the auto- control to start and stop the rotation of the blade. matic drive disconnect, located under the seat, to disengage the transmission. BRAKE PEDAL: Use the brake pedal to quickly stop. LIFT LEVER: Use the lift lever to change the height of cut. PARKING BRAKE LEVER: Use the parking b

Summary of the content on the page No. 16

OPERATION 2. For transport and to tow pull behind attachments, control the ATTACHMENTS ground speed with the speed control pedal. This unit can use many different attachments. See the attachment 3. The engine governor is set at the factory for maximum perform- page in this book. This unit can pull attachments like a lawn ance. Do not adjust the governor to increase the speed of the sweeper, a lawn aerator, a hopper spreader or a small trailer. This engine. unit can not use attachments that engag

Summary of the content on the page No. 17

OPERATION HOW TO DRIVE IN REVERSE HOW TO USE THE SPEED CONTROL PEDAL 1. Look to the rear. The drive system uses a Hydrostatic Automatic Drive transmission. The Hydrostatic transmission is very easy to operate. This type of 2. Slowly push the speed control pedal to the REVERSE drive system does not require a shift lever or a clutch pedal. position. The speed and direction of travel is controlled by a single speed control pedal operated with your right foot. Do not use the left brake HOW TO CHANGE

Summary of the content on the page No. 18

OPERATION HOW TO SET THE PARKING BRAKE 1. Completely push the brake pedal forward. 2. Lift the parking brake lever (Figure 10). 3. Remove your foot from the brake pedal and then release the parking brake lever. Make sure the parking brake will hold the unit. 4. To release the parking brake, completely push the brake pedal forward. The parking brake will automatically release. WARNING: Before you leave the operator’s position, move the shift lever to the neutral (N) position. Set the parking brak

Summary of the content on the page No. 19

OPERATION ØÑÉ ÌÑ ÑÐÛÎßÌÛ É×ÌØ ÌØÛ ÓÑÉÛÎ ØÑËÍ×ÒÙ WARNING: The deflector is a safety device. Do not re- 4. Move the throttle control to the SLOW position. move the deflector. The deflector forces the dis- 5. Move the blade rotation control to the ENGAGE position. charged material toward the ground. Always keep the deflector in the down position. If the deflector is dam- 6. Move the throttle control to the FAST position. aged, replace the deflector with an original equipment part from an authorized

Summary of the content on the page No. 20

OPERATION CAUTION: A mixture of alcohol (ethanol or methanol) and BEFORE STARTING THE ENGINE gasoline (called gasohol), will attract moisture and cause acid deposits during storage. While the unit is in storage, the acids CHECK THE OIL in the fuel can damage the fuel system. NOTE: The engine was shipped from the factory filled with oil. Check the level of the oil. Add oil as needed. See the engine To prevent engine problems with the fuel system, empty the fuel manufacturer’s instructions for the