Summary of the content on the page No. 1
MODEL NO. PO175H42STA
17.5 HP 42 Inch
Lawn Tractor
For Parts and Service, contact our authorized distributor: call 1-800-849-1297
For Technical Assistance: call 1-800-829-5886
00420-poulan
190288 01.20.04 Rev. 1 RD
PRINTED IN U.S.A.
Summary of the content on the page No. 2
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS . FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. DO NOT: I. GENERAL OPERATION Do not turn on slopes unless necessary, and then, Read, understand, and follow all instructions in the turn slowly and gradually downhill, if possible. manual and on the machine before starting. Do not
Summary of the content on the page No. 3
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS Be sure the area is clear of other people before mowing. Stop WARNING: In order to prevent ac ci - machine if anyone enters the area. den tal starting when setting up, trans- Never carry passengers or children even with the blades por t ing, ad just ing or making repairs, off. alwa ys dis con nect spark plug wire Do not mow in reverse unless absolutely necessary. Al ways and place wire where it can not contact look
Summary of the content on the page No. 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu fac tured to give Gasoline Capacity 1.25 Gallons you the best possible dependability and performance. and type: Unleaded Regular Should you experience any problem you cannot easily rem- Oil Type (API-SF-SJ): SAE 30 (above 32°F) edy, please contact your nearest authorized service center/ SAE 5W-30 (below 32°F) department. We have com pe tent, well-trained tech ni cians O
Summary of the content on the page No. 5
UNASSEMBLED PARTS Steering Wheel Seat (1) Washer 17/32 x 1-3/16 x 12 Gauge Steering Boot (1) Lock Washer 1/2 Steering Steering Wheel Extension Insert (1) Bolt Shaft Steering Wheel Key Adapter (1) Large Flat Washer (1) Locknut 1/2-20 (2) Keys (1) Oil Drain Tube Slope Sheet (1) Locknut 1/4-28 (1) Hex Bolt 1/4-28 x 1-1/4 5
Summary of the content on the page No. 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY INSERT A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. 1/2 LOCK WASHER (1) 3/4" wrench Pliers LARGE FLAT (2) 7/16" wren
Summary of the content on the page No. 7
ASSEMBLY HOW TO SET UP YOUR TRACTOR INSTALL SEAT (See Fig. 2) SEAT PAN Adjust seat before tightening adjustment bolt. LABEL Remove adjustment bolt, lock washer and fl at washer se cur ing seat to cardboard packing and set aside for as sem bly of seat to tractor. Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard. Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan. Push down on seat to
Summary of the content on the page No. 8
ASSEMBLY ✓CHE CKLIST CHECK TIRE PRESSURE BEFORE YOU OPERATE AND ENJOY YOUR NEW TRAC- The tires on your tractor were overinfl ated at the factory TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE for shipping purposes. Correct tire pressure is important BEST PERFORMANCE AND SATISFACTION FROM THIS for best cutting performance. QUALITY PRODUCT. Reduce tire pressure to PSI shown in “PRODUCT PLEASE REVIEW THE FOLLOWING CHECKLIST: SPEC I FI CA TIONS” section of this manual. ✓ All assembly inst
Summary of the content on the page No. 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. REVERSE HIGH LOW FAST SLOW IGNITION NEUTRAL CHOKE P LIGHTSON ENGINEON ENGINESTART PARKINGBRAKE PARKINGBRAKE PARKINGBRAKE ENGINEOFF LOCKED UNLOCKED FUEL OILPRESSURE BATTERY REVERSE FORWARD OVERTEMP MOWERHEIGHT MOWERLIFT LIGHT 15 15 ATTACHMENT ATTACHMENT SLOPEHAZARDS CLUTCHENGAGED DANGER,KEEPHANDS KEEPAREACLEAR CLUTCHDISENGAGED ANDFEETAWAY (SEESAFETYRULESSECTION) DA
Summary of the content on the page No. 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. ATT ACH MENT CLUTCH LEVER LIGHT SWITCH IGNITION POSITION SWITCH AMMETER LIFT LEVER PLUNGER THROTTLE/CHOKE CONTROL ATTACHMENT LIFT LEVER CLUTCH/BRAKE PEDAL PARKING BRAKE MOTION FREE WHEEL CONTROL CONTROL LEVER FIG. 4 Our tractor
Summary of the content on the page No. 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your trac- tor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY HOW TO USE YOUR TRACTOR POSITION OTHER THAN "OFF" WILL CAUSE THE BATTERY TO BE DIS CHARGED, (DEAD). TO SET PARK
Summary of the content on the page No. 12
OPERATION TO OPERATE MOWER (See Fig. 6) TO TRANSPORT (See Figs. 4 and 7) Your tractor is equipped with an operator presence sens- When pushing or towing your tractor, be sure to disengage ing switch. Any attempt by the operator to leave the seat transmission by placing freewheel control in free wheel ing with the engine running and the attachment clutch engaged po si tion. Free wheel control is located at the rear drawbar will shut off the engine. You must remain fully and centrally of
Summary of the content on the page No. 13
OPERATION COLD WEATHER STARTING ( 50° F and below) ADD GASOLINE When engine starts, allow engine to run with the Fill fuel tank to bottom of fi ller neck. Do not overfi ll. throttle control in the choke position until the engine Use fresh, clean, regular un lead ed gasoline with a runs roughly, then move throttle control to fast posi- minimum of 87 octane. (Use of leaded gasoline will tion. This may require an engine warm-up period from increase carbon and lead oxide deposits a
Summary of the content on the page No. 14
OPERATION Move motion control lever to neutral (N) position. Shut- off engine and set parking brake. Engage transmission by placing freewheel control in driving position (See “TO TRANSPORT” in this sec tion of manual). Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. With motion control lever in neutral (N) position, slowly disengage clutch/brake pedal. Slowly move motion control lever forward, after the
Summary of the content on the page No. 15
maint_sch-tractore.new1 MAINTENANCE MAINTENANCESCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T R Check for Loose Fasteners 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air
Summary of the content on the page No. 16
MAINTENANCE TRAILING TRACTOR MANDREL EDGE UP ASSEMBLY Always observe safety rules when performing any main- BLADE te nance. CEN TER HOLE BRAKE OPERATION If tractor requires more than six (6) feet stopping distance LOCK WASHER at high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Ad just ments section of this manual). STAR FLAT WASHER TIRES BLADE BOLT Maintain proper air pressure in all tires (See “PROD UCT SPECIFICATIONS” section of this
Summary of the content on the page No. 17
MAINTENANCE NOTE: The original equipment battery on your tractor is NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) maintenance free. Do not attempt to open or remove caps improve starting in cold weather, these multi-viscosity oils or covers. Adding or checking level of electrolyte is not will result in increased oil consumption when used above necessary. 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil. TO CLEAN BATTERY AN
Summary of the content on the page No. 18
MAINTENANCE IN-LINE FUEL FILTER (See Fig. 13) AIR FILTER The fuel fi lter should be replaced once each season. If fuel Your engine will not run properly using a dirty air fi lter. fi lter becomes clogged, ob struct ing fuel fl ow to car bu re tor, Service air cleaner more often under dusty conditions. re place ment is re quired. See Engine Manual. With engine cool, remove fi lter and plug fuel line sec- tions. MUFFLER Place new fuel fi lter in position in fuel line with arrow Ins
Summary of the content on the page No. 19
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR AD JUST - MENTS: Depress clutch/brake pedal fully and set parking brake. Place motion control lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key to “STOP” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in con- tact with plu
Summary of the content on the page No. 20
SERVICE AND ADJUSTMENTS SIDE-TO-SIDE ADJUSTMENT (See Figs. 15 and 16) Raise mower to its highest position. MANDREL At the midpoint of both sides of mower, measure height from bot tom edge of mower to ground. Distance “A” on both sides of mower should be the same or within "D" "D" 1/4" of each other. If adjustment is necessary, make adjustment on one FIG. 17 side of mower only. To raise one side of mower, tighten lift link ad just ment BOTH FRONT LINKS MUST BE EQUAL IN
