Summary of the content on the page No. 1
02478
183397 3.20.02 JH
Printed in U.S.A.
Summary of the content on the page No. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. Avoid starting or stopping on a slope. If tires lose traction, I. GENERAL OPERATION disengage the blades and proceed slowly straight down • Read, understand, and follow all instructions in the manual the slope. and on the machine before starting. On
Summary of the content on the page No. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers Look for this symbol to point out im- portant safety precautions. It means Be sure the area is clear of other people before mowing. Stop machine if anyone enters the area. CAUTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED. Never carry passengers or children even with the blades off. Do not mow in reverse unless absolutely necessary. Al- CAUTION: In order to prevent acciden- ways look down and behind before and while backing. ta
Summary of the content on the page No. 4
CONGRATULATIONS on your purchase of a new Tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manufactured to give GASOLINE CAPACITY 2.0 GALLONS you the best possible dependability and performance. AND TYPE: UNLEADED REGULAR Should you experience any problem you cannot easily remedy, please contact your nearest authorized service OIL TYPE (API-SF-SJ): SAE 30 (above 32°F) SAE 5W-30 (below 32°F) center. We have competent, well-trained technicians and the proper tools to service
Summary of the content on the page No. 5
UNASSEMBLED PARTS Seat Steering Wheel Steering Wheel Insert (1) Washer 17/32 x 1-3/16 x 12 Gauge Steering Extension (1) Knob Shaft Steering Sleeve Slope Sheet Steering Adapter (1) Large Flat Washer (2) Keys (1) Oil Drain Tube (1) Locknut 1/4-28 For Future Use (2) Mulch Blades (1) Locknut 1/2-20 (1) Hex Bolt 1/4-28 x 1-1/4 5
Summary of the content on the page No. 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY INSERT A socket wrench set will make assembly easier. Standard wrench sizes are listed. 1/2 HEX NUT Utility knife Pliers (1) 3/4" wrenches Tire pressure gauge
Summary of the content on the page No. 7
ASSEMBLY NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the SEAT PAN tractor from the skid. TO ROLL TRACTOR OFF SKID (See Operation section, page 10, for location and function of controls) LABEL Press lift lever plunger and raise attachment lift lever to its highest position. Release parking brake by depressing clutch/brake pedal. Place freewheel control in freewheeling position to disengage transmission (See “TO TRANSPORT” in
Summary of the content on the page No. 8
ASSEMBLY CHECK TIRE PRESSURE IMPORTANT: FOR SHIPPING PURPOSES, THE MULCHER PLATE WAS PREATTACHED TO YOUR The tires on your tractor were overinflated at the factory for MOWER. THE MULCHER PLATE MUST ONLY BE USED shipping purposes. Correct tire pressure is important for best cutting performance. WITH THE MULCHING BLADES THAT CAME PACKED SEPARATELY IN THE CARTON. Reduce tire pressure to PSI shown in “PRODUCT SPECIFICATIONS” section of this manual. YOUR MOWER CAME FACTORY EQUIPPED WITH HIGH PERFO
Summary of the content on the page No. 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. BATTERY CAUTION OR REVERSE FORWARD FAST SLOW WARNING LIGHTS ON OVER TEMP ENGINE ON ENGINE OFF OIL PRESSURE LIGHT PARKING BRAKE UNLOCKED MOWER LIFT FUEL CHOKE MOWER HEIGHT LOCKED P ATTACHMENT REVERSE NEUTRAL HIGH LOW PARKING BRAKE CLUTCH ENGAGED 15 15 15 KEEP AREA CLEAR SLOPE HAZARDS ATTACHMENT (SEE SAFETY RULES SECTION) CLUTCH DISENGAGED IGNITION FREE WHEEL DANG
Summary of the content on the page No. 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. IGNITION LIGHT ATTACHMENT SWITCH SWITCH CLUTCH LEVER AMMETER POSITION CHOKE CONTROL LIFT LEVER PLUNGER THROTTLE CONTROL ATTACHMENT LIFT LEVER CLUTCH/BRAKE HEIGHT PEDAL ADJUSTMENT INDICATOR PARKING BRAKE MOTION FREE WHEEL CONTROL CONTROL
Summary of the content on the page No. 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY HOW TO USE YOUR TRACTOR POSITION OTHER THAN "OFF" WILL CAUSE THE BATTERY TO BE DISCHARGED, (DEAD). TO SET PARKING BRAKE (See
Summary of the content on the page No. 12
OPERATION TO ADJUST GAUGE WHEELS (See Fig. 7) "ENGAGED" POSITION Gauge wheels are properly adjusted when they are slightly ATTACHMENT off the ground when mower is at the desired cutting height in LIFT LEVER HIGH POSITION operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain ATTACHMENT CLUTCH LEVER conditions. LOW "DISENGAGED" POSITION NOTE:Adjust gauge wheels with tractor on a flat level POSITION surface. Adjust mower to desired cuttin
Summary of the content on the page No. 13
OPERATION CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to sepa- ration and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions f
Summary of the content on the page No. 14
OPERATION AUTOMATIC TRANSMISSION WARM UP Move motion control lever to neutral (N) position. Shut- off engine and set parking brake. Before driving the unit in cold weather, the transmission should be warmed up as follows: Engage transmission by placing freewheel control in driving position (See “TO TRANSPORT” in this section Be sure the tractor is on level ground. of manual). Place the motion control lever in neutral. Release Sitting in the tractor seat, start engine. After the engi
Summary of the content on the page No. 15
OPERATION MULCHING MOWING TIPS IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER MAX 1/3 HOUSING FREE OF BUILT-UP GRASS AND TRASH. CLEAN AFTER EACH USE. The special mulching blade will recut the grass clippings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass and not be noticed. Also, the mulched grass will biodegrade quickly to provide nutrients for the lawn. Always mulch with your highest engine (blade) speed as this will provide the best r
Summary of the content on the page No. 16
CUSTOMER RESPONSIBILITIES MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T R Check for Loose Fasteners 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air Filter N
Summary of the content on the page No. 17
CUSTOMER RESPONSIBILITIES TRACTOR MANDREL TRAILING ASSEMBLY EDGE UP Always observe safety rules when performing any mainte- BLADE nance. CENTER HOLE BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Adjustments section of this manual). LOCK WASHER STAR TIRES Maintain proper air pressure in all tires (See “PRODUCT SPECIFICATIONS” section of this manual). FLAT WASHER
Summary of the content on the page No. 18
CUSTOMER RESPONSIBILITIES SAE VISCOSITY GRADES BATTERY Your tractor has a battery charging system which is suffi- SAE 30 cient for normal use. However, periodic charging of the 5W-30 battery with an automotive charger will extend its life. -20 0 30 32 40 100 F 60 80 Keep battery and terminals clean. C -20 0 10 -30 -10 20 30 40 Keep battery bolts tight. TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE Keep small vent holes open. FIG. 14 Recharge at 6-10 amperes for 1 hour. NOT
Summary of the content on the page No. 19
CUSTOMER RESPONSIBILITIES MUFFLER CLEAN AIR SCREEN Inspect and replace corroded muffler and spark arrester (if Air screen must be kept free of dirt and chaff to prevent equipped) as it could create a fire hazard and/or damage. engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers. SPARK PLUGS CLEAN AIR INTAKE/COOLING AREAS Replace spark plugs at the beginning of each mowing To insure proper cooling, make sure the grass screen, sea
Summary of the content on the page No. 20
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: Depress clutch/brake pedal fully and set parking brake. Place motion control lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key to “STOP” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TRACTOR IMPO
