Summary of the content on the page No. 1
Installation Instructions
Wine Dispensing System
Model DYWS4
Part No. 107376 Rev. C
Summary of the content on the page No. 2
Table of Contents Important Safety Instructions ..................................... 1 Installation Instructions ............................................... 6 Important Information About Safety Instructions ......... 1 Verify the Package Contents ....................................... 6 General Safety Precautions ........................................ 2 Unpacking the Appliance ............................................ 6 Installation Specifications .....................................
Summary of the content on the page No. 3
Important Safety Instructions Safety Symbols and Labels Important Information About Safety Instructions DAnger Immediate hazards that w ILL result in severe personal • The Important Safety Instructions and warnings in injury or death. these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or wArn Ing operating this or any other appliance. Hazards or unsafe practices that COuLD result in s
Summary of the content on the page No. 4
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: wArn Ing wArn Ing • If the appliance is damaged, immediately contact the • Do not place your hands or fingers in area of moving dealer. Do not install or use a damaged appliance. parts. NEVER place fingers or hands into the bottle bay assembly. Personal injury may result. Call a •
Summary of the content on the page No. 5
Installation Specifications wArn Ing • Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. • For safe and proper operation, all the requirements in the Installation Specifications section including, but not limited to, the electrical specifications, minimum clearances and cabinet specifications must be met or exceeded. All product tolerances are ±1/16” (±1.6 mm) Technical Specifications/Dimensions unl
Summary of the content on the page No. 6
Installation Specifications • The electrical outlet for the wine dispensing system Electrical Requirements must be located to allow for easy access when the unit is installed for easy disconnection. wArn Ing • Use an electrical outlet which cannot be turned off with a switch or pull chain. To prevent an electric shock hazard, the electrical outlet and supply must meet the specifications stated below. • Installation of an external UPS with backup battery is It is the owner’s responsibi
Summary of the content on the page No. 7
Installation Specifications 1” (2.5 cm) min. Allow for Proper Air Circulation All cabinet tolerances: +1/16” (+1.6 mm) -0 unless otherwise stated. 26 5/8” min. (67.6 cm) 16” min. (40.6 cm) 19 11/16” min. (50.0 cm) Minimum Clearance r equirements 5
Summary of the content on the page No. 8
Installation Instructions Unpacking the Appliance wArn Ing • If the electric outlet provided does not meet the 1. Move the box to the installation location. The wine specifications on pages 3 and 4, do not dispensing system is package with the display window proceed with the installation. Call a licensed facing up towards the box opening. electrician to install the proper electrical service before 2. Open the box along the taped closure. proceeding. 3. Remove the (4) four leveling feet fr
Summary of the content on the page No. 9
Installation Instructions 4. Plug the power cord (provided) into the power plug on Installation the power supply (black rectangular box) mounted on the back of the wine dispensing system. wArn Ing 5. If required, route the power cord though any access holes drilled in the adjoining cabinets. • To avoid personal injury, use only the included gas pressure regulator or a Dacor specified replacement. 6. Make sure the cable coming from the power supply (opposite the power cord that connects
Summary of the content on the page No. 10
Installation Instructions 8. Find the gas regulator assembly shipped with the unit. Regulator 9. Make sure the regulator adjustment knob is turned adjustment all the way in the OFF direction. knob 10. Plug the end of the gas tubing leading to the wine dispensing system into the gas regulator assembly. 11. Remove the plastic cap from the top of the argon gas cylinder (must be ordered separately, see page 6). 12. Insert the top of the gas cylinder into the bottom of the gas regulator asse
Summary of the content on the page No. 11
Installation Instructions Installation Checklist wArn Ing To ensure a safe and proper installation, the installer must complete the checklist below to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner. The importance of proper installation of your appliance cannot be overemphasized. Has enough space been provided around the unit to allow for proper ventilation? See page 5. Is the countertop strong enough to hold t
Summary of the content on the page No. 12
Dacor ● 14425 Clark A venue, City of Industry , CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www .dacor .com
