Summary of the content on the page No. 1
Summary of the content on the page No. 2
TABLE OF CONTENTS Content Page Content Page Important Safe Operation Practices 3 Making Adjustments 13 Slope Gauge 6 Maintaining Your Lawn Mower 14 Contents of Hardware Pack 7 Off Season Storage 15 Assembling Your Lawn Mower 7 Trouble Shooting 16 Know Your Lawn Mower 11 Illustrated Parts List 18 Operating Your Lawn Mower 12 Warranty 20 FINDING MODEL NUMBER This Operator’s Manual is an important part of your new lawn mower. It will help you assemble, prepare and maintain the unit for best perfor
Summary of the content on the page No. 3
Summary of the content on the page No. 4
16. Home circuit – This mower should be operated on a 15 31. Only use parts and accessories made for this machine by AMP circuit. If you experience difficulty in starting with a the manufacturer. Failure to do so can result in personal standard 15 AMP fuse or circuit breaker, contact your injury. nearest authorized service facility. Do not use a higher 32. If situations occur which are not covered in this manual, rated fuse or breaker without consulting your power use care and good judgment.
Summary of the content on the page No. 5
Summary of the content on the page No. 6
Summary of the content on the page No. 7
Summary of the content on the page No. 8
Summary of the content on the page No. 9
Summary of the content on the page No. 10
Assembling Grass Catcher Attaching The Grass Catcher Lift the rear discharge door on the back of the WARNING: Never operate the mower without mower. Refer to Figure 8. the proper trail shield, discharge cover, grass catcher, blade/motor control or other safety protective devices in place and working. Never Grass Bag Assembly operate the mower with damaged safety devices. Failure to do so can result in personal injury. Insert the six clips on the underside of the bagger Channels cover
Summary of the content on the page No. 11
Summary of the content on the page No. 12
Summary of the content on the page No. 13
Stopping the Motor and Blade T = Obstacles WARNING: The blade continues to rotate for a few seconds after the motor is shut off. If the motor does not come to a stop when the motor/blade control handle is released, contact an authorized service dealer. To stop the motor and blade from spinning: Release the motor/blade control lever from its Outlet position against the upper handle and the blade (Start here) and motor will quickly come to a stop. NOTE: A high pitched noise may occur as th
Summary of the content on the page No. 14
Summary of the content on the page No. 15
Reinstall the blade as de scribed earlier in this Sharpening the Blade section making certain to torque the cutting blade to To sharpen the blade, first remove the blade as outlined specifications. in the previous section. DO NOT attempt to sharpen the blade while it is attached to the mower. The blade can be sharpened with a file or on a grinding wheel. Mower Deck When sharpening the blade, follow the original WARNING: To reduce the risk of electric angle of grind as a guide. It is e
Summary of the content on the page No. 16
SECTION 10: TROUBLE SHOOTING GUIDE Trouble Possible Cause(s) Corrective Action Mower not starting. Cord disconnected from the motor/ Reconnect the cord keeping the cord restraint close blade control. to the motor/blade control. Motor/blade control switch defective. Replace motor/blade control switch. Extension cord not connected to a Connect the extension cord to a 110-120 volt 60 source of power. cycle A.C. receptacle. Circuit breaker on the mower or in the Reset the circuit breaker
Summary of the content on the page No. 17
NOTES 17
Summary of the content on the page No. 18
Summary of the content on the page No. 19
Model C06 REF. NO. PART NO. DESCRIPTION 1 749-1042A Upper Handle 2 749-1312 Lower Handle 3 720-0369 Handle Plug 4 710-1718 Handle Bolt LH 5 736-0649 Lock Washer 6 712-0690 Hex Nut 7 710-1757 Screw 8 725-04075 Motor / Blade Control Switch 9 731-2427 Cord Insulator 10 731-2421-0638 Mower Housing (Incl. Ref# 39-41) 11 731-2088A-0637 Protection Cover 12 731-2224A Motor Cover 13 724-0310 Electric Motor 14 710-1756 Screw 15 631-0148 Blade Hub Assembly 16 742-0804 Cutting Blade 17 731-2452 Lock Washer
Summary of the content on the page No. 20
MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC with e. MTD does not extend any warranty for products sold or respect to new merchandise purchased and used in the exported outside of the United States, its possessions United States, its possessions and territories. and territories, except those sold through MTD’s authorized channels of export distribution. “MTD”warrants this product against defects in material and f. Replacement parts that are no
