Cornelius Remcor 2849959200 user manual

Summary of the content on the page No. 1

IMI CORNELIUS INC  One Cornelius Place  Anoka, MN 55303-6234
Telephone (800) 238-3600 Facsimile (612) 422-3246
INSTALLATION INSTRUCTIONS
WHITE RODGERS ICE BANK CONTROL KIT (P/N 569000263)
ON
UNIVERSAL C–750 PRE–MIX DISPENSERS
KIT FITS MODELS 2849949200, 2849949020, 2849959200, and 2849959020
IMPORTANT: All old parts (Ice bank Control Module and Mounting Bracket, Ice Bank Control Probe, and
the Ice Bank Control Probe Holder) must be returned to IMI Co

Summary of the content on the page No. 2

NOTE: Only qualified Personnel should install this Kit. 1. Disconnect Unit product inlet lines from product tanks, then open dispensing valves to relieve systems pressures. 2. Disconnect electrical power from the Unit, open hinged top cover, then drain water tank. CAUTION: Never use an ice pick or other instrument to remove ice from the refrigeration system evaporator coils. Such practice can result in a punctured refrigeration circuit. 3. Allow ice to melt from the evaporator coils. Hot water m

Summary of the content on the page No. 3

5. Place product coils assembly back in position inside the Unit. Make sure ice bank control capillary tube is routed from ice bank control bulb up along right front side (facing front of Unit) of the Unit and on up to the ice bank control as shown in Figure 3. 6. Connect product tubes, connected to the product coils, to backs of the dispensing valves. 7. Place Unit product inlet fittings up through holes in the agitator motor assembly bracket and secure with white plastic washers and hex nuts

Summary of the content on the page No. 4

ICE BANK CONTROL ASSEMBLY (ITEM 1 and 2) NO. 2 COIL ICE BANK CONTROL BULB NO. 3 COIL 6.500 IN. FIGURE 1. ICE BANK CONTROL PROBE LOCATION O–RING (ITEM 7) O–RING (ITEM 7) ICE BANK CONTROL (ITEM 1) ICE BANK CONTROL ICE BANK CONTROL BULB BULB HOLDER (ITEM 6) RED WIRE CAPILLARY TUBE (ITEM 9) (TO ICE BANK CONTROL) BLACK WIRE (ITEM 8) FIGURE 2. ICE BANK CONTROL 569000264 4

Summary of the content on the page No. 5

SNAP BUSHING AGITATOR MOTOR (ITEM 11) BRACKET ICE BANK CONTROL ASSEMBLY (ITEMS 1 AND 2) UNIT WIRING HARNESS HAZARD SHOCK LABEL (ITEM 4) CAPILLARY GROMMET TUBE (ITEM 3) FIGURE 3. UNIT TOP VIEW 5 569000264

Summary of the content on the page No. 6

Summary of the content on the page No. 7

569000264 6 ICE BANK CONTROL BULB FIGURE 4. UNIT WIRING DIAGRAM