Summary of the content on the page No. 1
Operator′s manual
P 520D
P 525D
Please read the operator’s manual carefully and make sure yo u
understand the instructions before using the machine.
E E E En n n ng g g glllliiiis s s sh h h h
Summary of the content on the page No. 2
CONTENTS Cleaning the air filter .................................................... 24 Contents Replacing the air filter .................................................. 24 CONTENTS Cleaning the engine and muffler .................................. 24 Contents ...................................................................... 2 Check the safety system .............................................. 25 Service journal Replacing the
Summary of the content on the page No. 3
Service journal 14 Tell customer about: Pre-delivery service The requirement and advantages of servicing the 1 Charge the battery for at least 4 hours at max. 3 machine according to the service plan amp. Servicing and the influence of this journal on the 2 Check coolant level and antifreeze. second-hand value of the machine. 3 Check and adjust tyre pressure (150 kPa, 1,5 bar, The transmission guarantee is only valid if the 21,8 PSI). synchronisation of the front and rear whe
Summary of the content on the page No. 4
INTRODUCTION Dear Customer, Thank you for choosing a Husqvarna Rider. Husqvarna Riders are built to a unique design with a front-mounted cutting unit and a patented articulated steering. Riders are designed for maximum efficiency even in small or confined areas. The closely grouped controls and pedal-operated hydrostatic transmission also contribute to the performance of this machine. This operator’s manual is a valuable document. By following its instructions (on operati
Summary of the content on the page No. 5
INTRODUCTION Good service Husqvarna products are sold all over the world and ensures that you, the customer, get the best support and service. For example, before this machine was delivered it was inspected and adjusted by your dealer. See the certificate in the Service Journal in this manual. When you need spare parts or advice on service issues, warranty terms, etc., contact: This Operator’s Manual belongs to machine with Engine Transmission serial number: On the machine's rating pl
Summary of the content on the page No. 6
KEY TO SYMBOLS Warning: rotating parts. Keep hands and feet Symbols clear. These symbols are on the machine and in the instructions. WARNING! Careless or incorrect use can result in serious or fatal injury to the Watch your hands and other body parts operator or others. so they do not get caught and crushed between the belt and belt pulley. Please read the operator’s manual carefully and make sure you understand Rotary blades Keep hands and feet the instructions before using the
Summary of the content on the page No. 7
WHAT IS WHAT? 12 11 10 9 8 7 6 5 4 3 2 1 19 24 25 13 14 15 16 17 18 20 21 22 23 Location of the controls 1 Knob for seatback angle 14 Counter 2 Throttle trigger 15 Temperature gauge 3 Power outlet 16 Knob for adjustment of the seat suspension 4 Switch for the power outlet 17 Lever for longitudinal seat adjustment 5 Control for cutting unit drive 18 Bypass valve front axle 6 Lever for hydraulic lift of attachments 19 Product and serial number plate 7 Parking brake 20 Fuel gauge 8 Swit
Summary of the content on the page No. 8
SAFETY INSTRUCTIONS • Remember that the driver is responsible for dangers or Safety instructions accidents. These instructions are for your safety. Read them carefully. • Never carry passengers. The machine is only intended to be used by one person. Insure your Rider • Check the insurance coverage for your new Rider. • Contact your insurance company. • You should have fully comprehensive insurance including: third party, fire, damage, theft and liability General use •
Summary of the content on the page No. 9
SAFETY INSTRUCTIONS • Never allow children or other persons not trained in the This is what you do use of the machine to use or service it. Local laws may • Remove obstacles such as stones, branches, etc. regulate the age of the user. • Mow upwards and downwards, not sideways. • Do not use the machine on ground that slopes more than 10°. • Take extra care if any attachments are fitted that can change the stability of the machine. WARNING! You must use approved personal pro
Summary of the content on the page No. 10
SAFETY INSTRUCTIONS • Electrical shocks can cause injuries. Do not touch cables Children when the engine is running. Do not test the ignition system with your fingers. • Serious accidents may occur if you fail to be on your guard for children in the vicinity of the machine. Children are often attracted to the machine and mowing. Never WARNING! The engine and the exhaust assume that children will remain where you last saw them. system become very hot during operation. ! • Keep children away
Summary of the content on the page No. 11
SAFETY INSTRUCTIONS • Stop and inspect the equipment if you run over or into anything. If necessary, make repairs before starting. • Never make adjustments with the engine running. • The machine is tested and approved only with the equipment originally provided or recommended by the manufacturer. • The blades are sharp and can cause cuts. Wrap the blades or wear protective gloves when handling them. • Check regularly that the parking brake works. Adjust and maintain as required. • Reduce th
Summary of the content on the page No. 12
PRESENTATION Presentation Counter Congratulations on your choice of an excellent quality product The chronometer shows how many hours the engine has that will give you great pleasure for many years. This been running. operator’s manual describes P 520D and P 525D. Any time when the engine is not running but the ignition is switched on is not registered. The last digit shows tenths of an hour (6 minutes). Parking brake Operate the parking brake by moving the handle forwards. P 520D and P 525D
Summary of the content on the page No. 13
PRESENTATION Pull the lever backwards to engage the transport position. The Adjusting the cutting height unit is then raised. The cutting height can be adjusted to seven different positions. Select the required cutting height (1-7) using the cutting height adjusters. Set the knobs horizontally so that they do not snag on bushes and the like. The cutting unit can be raised slightly with the blades rotating. This is to facilitate the mowing of extremely tall grass or uneven surfaces. Loweri
Summary of the content on the page No. 14
PRESENTATION • The lumbar support is adjusted with the knob on the left Seat side of seat back . The seat has a jointed attachment on the front edge and can be tipped forward. To fold the seat forward, the latch for the seat must be operated. Fueling The fuel level in the tank is shown by the gauge on top of the tank. WARNING! Take care so that hands are not trapped or injured by the locking hooks ! when the seat is folded back. WARNING! Do not adjust seat settings while driving. Risk of
Summary of the content on the page No. 15
PRESENTATION The power outlet is switched on and off using power switch on 2 Oil pressure, check oil level and top up if necessary. the control panel. 3 Ignition 4 Battery charging 5 Power transmission connected 6 Parking brake 7 Spotlight 8 Switch for the lights Bypass valves The power outlet works even if the ignition is turned off. Do Hydraulic pressure must be released in order for the ride-on not forget to disconnect the power outlet or remove the power mower to be moved when the engine
Summary of the content on the page No. 16
PRESENTATION ROPS (Roll Over Protective Auxiliary lift system Structure) The auxiliary lift system transfers the weight of the cutting unit pivot wheel to the machine's front wheel. ROPS is a protective frame that reduces the risk of injury in the event of overturning. Use ROPS and a safety belt when The effect of the auxiliary lift system can be adjusted by driving on slopes. moving the gas spring up or down. The frame can be folded down. Remove the two pins that hold Maximum effect is obtai
Summary of the content on the page No. 17
STARTING ENGINE 5 Turn the ignition key to the ignition position and hold it Before starting there until the indicator light on the instrument panel goes out. • Read the safety instructions and information concerning the placement of controls and functions before starting. • Perform daily maintenance before starting as set out in the Maintenance schedule. IMPORTANT INFORMATION The air intake grille in the engine cover must not be blocked by, for example, clothing, leaves, grass or dirt. Imp
Summary of the content on the page No. 18
STARTING ENGINE Starting the engine with a weak battery WARNING! Lead-acid batteries produce explosive gases. Avoid sparks, open flames ! and smoking close to batteries. Always wear protective glasses in the vicinity of batteries. If the battery is too weak to start the engine, it should be recharged. When jump leads are used for emergency starting, follow the procedure below: IMPORTANT INFORMATION Your Rider is equipped with a 12-volt system with negative earth. The other vehicle must al
Summary of the content on the page No. 19
DRIVING Turn off the cutting unit using the PTO button. Driving the Rider 1 Release the parking brake before driving 1 Apply the parking brake by moving the handle downward. 2 Carefully press down one of the pedals until the required speed is obtained. Pedal (1) is used to drive forwards, and pedal (2) to drive backwards. 1 2 2 Lift the cutting unit with the hydraulic lifting lever. 3 Lower the cutting unit by directly moving the lever forward to the float position where the lever stays put. 3
Summary of the content on the page No. 20
DRIVING Cutting tips WARNING! Clear the lawn from stones and other objects which can be thrown out by ! the blades. • Localise and mark stones and other fixed objects to avoid collision. • Start with a high cutting height and reduce down until the required mowing results are obtained. • The mowing result will be best with the highest permitted engine speed, see technical data, (the blades rotate rapidly) and low speed (the Rider moves slowly). If the grass is not too high and thick, the d
