Summary of the content on the page No. 1
Gasoline containing up to 10% ethanol (E10) is accept-
able for use in this machine. The use of any gasoline ex-
Operator’s Manual
ceeding 10% ethanol (E10) will void the product warranty .
Esta máquina puede utilizar gasolina con un contenido
Manual de Operario
de hasta el 10% de etanol (E10). El uso de una gasolina
que supere el 10% de etanol (E10) anulará la garantía
YTH22V42
del producto. the product warranty.
Please read the operator's manual carefully and make sure
you understand the
Summary of the content on the page No. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Never leave a running machine unattended. Always turn WARNING: In order to prevent ac ci den tal off blades, set parking brake, stop engine, and remove starting when setting up, trans port ing, keys before dismounting. ad just ing or making repair
Summary of the content on the page No. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers • If fuel is spilled on clothing, change clothing immediately. III. CHILDREN • Never overfill fuel tank. Replace gas cap and tighten securely. WARNING. CHILDREN CAN BE INJURED BY THIS EQUIPMENT. The American Academy GENERAL SERVICE of Pediatrics recommends that children be a • Never operate machine in a closed area. minimum of 12 year of age before operating • Keep all nuts and bolts tight to ensure the equipment is a pedestrian co
Summary of the content on the page No. 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu fac tured to give you the best possible dependability and performance. Gasoline Capacity 2.5 Gallons (9.46 L) and type: Unleaded Reqular Should you experience any problem you cannot easily remedy, please contact your nearest authorized service Oil Type: SAE 30 (above 32°F/0°C) center/department. We have com pe tent, well-trained tech ni- (API: SG-SL) SAE 5W30 (above 32°F/0°C
Summary of the content on the page No. 5
UNASSEMBLED PARTS Slope Sheet Key (1) Oil Drain Tube (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard LABEL wrench sizes are listed. (1) 1/2" wrench Tire pressure gauge (2) 7/16" wrenches Utility knife Pliers When right or left hand is mentioned in this man ual, it means when you are in the operating po si tion (se
Summary of the content on the page No. 6
ASSEMBLY ✓CHECKLIST NOTE: You may now roll your tractor off the skid. Follow the BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE instructions below to remove the tractor from the skid. WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS W ARNING: Before start ing, read, un der stand and fol low QUALITY PRODUCT. all in struc tions in the Op er a tion section of this man u al. Be sure tractor is in a well-ventilated area. Be sure the area in PLEASE REVIEW THE FOLLOWING
Summary of the content on the page No. 7
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON BATTERY CRUISE CONTROL FUEL REVERSE FORWARD PEDAL 15 15 ATTACHMENT DANGER, KEEP HANDS ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAF
Summary of the content on the page No. 8
OPERATION KNOW YOUR TRACTOR READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. P H G E B D F A K C M J L Fig. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise and lower (H) LIGHT SWITCH - Turns the headlights on
Summary of the content on the page No. 9
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide vision safety mask worn over spectacles. ENGINE - HOW TO USE YOUR TRAC TOR • Move throttle control (D) between half and full speed (fast) position. TO SET PARKING BRAKE (See Fig. 4) NOTE: Failur
Summary of the content on the page No. 10
OPERATION TO USE CRUISE CONTROL (J) (See Fig. 7) TO ADJUST GAUGE WHEELS (See Fig. 9) The cruise control feature can be used for forward travel Gauge wheels are prop er ly ad just ed when they are slight ly only. off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in prop- er position to help prevent scalping in most terrain conditions. K NOTE: Adjust gauge wheels with tractor on a flat level surface. • Adjust mower to desired cu
Summary of the content on the page No. 11
OPERATION TO TRANSPORT (See Figs. 3 and 11) REVERSE OPERATION SYSTEM (ROS) When pushing or towing your tractor, be sure to disengage Your tractor is equipped with a Reverse Operation System transmission by placing freewheel control in free wheel ing (ROS). Any attempt by the operator to travel in the reverse po si tion. Free wheel control is located at the rear drawbar direction with the attachment clutch engaged will shut off of tractor. the engine unless ignition key is placed in the R
Summary of the content on the page No. 12
OPERATION TO START ENGINE (See Fig. 3) BEFORE STARTING THE ENGINE When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move CHECK ENGINE OIL LEVEL fuel from the tank to the engine. The engine in your tractor has been shipped, from the • Be sure freewheel control is in the transmission en gaged factory, already filled with sum mer weight oil. position. • Check engine oil with tractor on level ground. • Sit on seat in operat
Summary of the content on the page No. 13
OPERATION PURGE TRANSMISSION MOWING TIPS • Tire chains cannot be used when the mower hous ing CAUTION: Never engage or disengage is attached to tractor. freewheel lever while the engine is run ning. • Mower should be properly leveled for best mowing performance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual. To ensure proper operation and performance, it is rec om- mend ed that the transmission be purged before operating • The left hand side of mower s
Summary of the content on the page No. 14
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Clean Debris Off Steering Plate 5 Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil
Summary of the content on the page No. 15
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blades. main te nance. CAUTION: Use only a replacement blade ap- BRAKE OPERATION proved by the manufacturer of your tractor. If tractor requires more than five (5) feet to stop at highest Using a blade not approved by the manu- speed in high est gear on a level, dry concrete or paved facturer of your tractor is hazardous, could surface
Summary of the content on the page No. 16
MAINTENANCE V-BELTS TO CHANGE ENGINE OIL (See Fig. 16 & 17) Check V-belts for deterioration and wear after 100 hours Determine temperature range expected before oil change. of operation and replace if necessary. The belts are not All oil must meet API service classification SG-SL. ad just able. Re place belts if they begin to slip from wear. • Ensure tractor is on level surface. • Oil will drain more freely when warm. TRANSAXLE COOLING • Catch oil in a suitable container. The transmission fa
Summary of the content on the page No. 17
MAINTENANCE ENGINE OIL FILTER CLEANING • Clean engine, battery, seat, finish, etc. of all foreign Replace the engine oil filter every season or every other oil matter. change if the tractor is used more than 100 hours in one year. See engine man u al. • Clean debris from steering plate. Debris can restrict clutch/brake pedal shaft movement, causing belt slip AIR FILTER and loss of drive. Your engine will not run properly using a dirty air filter. Ser- CAUTION: Avoid all pinch points and
Summary of the content on the page No. 18
MAINTENANCE DECK WASHOUT PORT (See Fig. 20) Your tractor’s deck is equipped with a washout port on its surface as part of its deck wash system. It should be utilized after each use. 1. Drive the tractor to a level, clear spot on your lawn, near enough to a water spigot for your garden hose to reach. IMPORTANT: Make certain the tractor’s discharge chute is directed AWAY from your house, garage, parked cars, etc. Remove bagger chute or mulch cover if attached. 2. Make sure the attachment clu
Summary of the content on the page No. 19
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTANT: IF AN ATTACHMENT OTHER THAN THE TO REMOVE MOWER (See Fig.
Summary of the content on the page No. 20
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Insert end of link (E) into hole in front mower bracket CHASSIS - Position hole in arm over pin (B) on outside and secure with washer and retainer spring (J). of tractor chassis and secure with retainer spring. E • Repeat on opposite side of tractor. A J F H B Fig. 24 • Hook end of clutch cable spring (Q) into hole in idler arm (R). Fig. 22 • Push clutch cable housing guide (P) into bracket, slide • ATTACH REAR LIFT LINKS (C
