Summary of the content on the page No. 1
03002
LGT2554
Owner's Manual
532 43 00-01 Rev. 4
Summary of the content on the page No. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, WARNING: In order to prevent ac- discharge guard, or other safety devices in place and ci den tal starting when setting up, working. trans port ing, ad just ing or making • Slow down before t
Summary of the content on the page No. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to • Keep all nuts and bolts tight to be sure the equipment is in safe working condition. the ma chine and the mowing activity. Never assume that children will remain where you last saw them. • Never tamper with safety devices. Check their proper • Ke
Summary of the content on the page No. 4
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. Gasoline Capacity 4 Gallons and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for and using your tractor. Oil Type (API-SG-SL): SAE 30 (above 32°F) SAE 5W-30 (below 32°F) • Follow the instructions under “Maintenance” and “Stor- age” sec tions of this own er’s manual. Oil Capacity: W/ Filter: 64 oz Spark Plug: Champion RC12YC WARNING: This tractor is equipped with an in
Summary of the content on the page No. 5
UNASSEMBLED PARTS Mower Mower Front Wheel (2) Rear Lift Link (5) 1-3/16 (1) Shoulder Bolt Assemblies (1) 1-1/4 O.D. O.D. Washers Washer (1) Small Retainer Springs (1) Front Lift Link (1) 3/8-16 Assembly (1) Wheel Locknut (5) Large Retainer Springs Slope Sheet (1) Oil Drain Tube If Equipped Keys (1) 3/4 O.D. (1) Anti-Sway Bar Washers (2) Keys (1) Small Retainer Springs ASSEMBLY Your new tractor has been assembled at the factory with ex- BEFORE REMOVING TRACTOR FROM ception of
Summary of the content on the page No. 6
ASSEMBLY TO INSTALL MOWER AND DRIVE BELT TO ADJUST SEAT (See Fig. 2): (See Figs. 3 - 15) • Grasp adjustment handle(A) and pull up, slide seat to desired po si tion and release adjustment handle. 1. SET PARKING BRAKE LEVER AND LOWER AT- TACHMENT LIFT (See Fig. 3) • Depress clutch/brake pedal all the way down and hold. • Pull parking brake lever up and hold, re lease pres sure from clutch/brake pedal, then release parking brake lever. Pedal should re main in brake position. Ensure parking
Summary of the content on the page No. 7
ASSEMBLY 4. SLIDE MOWER UNDER TRACTOR (See Fig. 7) 5. INSTALL ANTI-SWAY BAR (S) (IF EQUIPPED) (See Fig. 8 - 10) • Bring belt forward and check belt for proper routing in all mower pulley grooves. ANTI-SWAY BAR (S) NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor. TOWARDS TOWARDS TRANSAXLE MOWER DECK • Slide mower under tractor until it is centered under tractor. 90° END INTEGRATED WASHER END Fig. 8 Q • From right side of mower, first inse
Summary of the content on the page No. 8
ASSEMBLY 7. ATTACH REAR LIFT LINKS (C) (See Fig. 12) ANTI-SWAY BAR TRANSAXLE • Insert rod end of rear lift link (C) into hole (U) in tractor lift (S) LOCATION BRACKET (T) shaft suspension arm and pivot link down to mower. LOCATED • Lift rear corner of mower and position slot in link as- BETWEEN REAR TIRES sembly over pin on rear mower bracket (D) and secure with large washer and large retainer spring. • Repeat on opposite side of tractor. U C S C. REAR LIFT LINK(S) D. RIGHT SIDE REAR MOWE
Summary of the content on the page No. 9
ASSEMBLY 9 INSTALL BELT ON ENGINE CLUTCH PULLEY (M) (See Fig. 6 & 14) ✓CHECKLIST • Disengage belt tension rod (K) from locking bracket (L). BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE • Install belt onto engine clutch pulley (M). WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT. M PLEASE REVIEW THE FOLLOWING CHECKLIST: ✓ All assembly instructions have been com plet ed. ✓ No remaining loose parts in carton. ✓ Battery is properly prepared and charge
Summary of the content on the page No. 10
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON BATTERY CRUISE CONTROL FUEL REVERSE FORWARD PEDAL 15 15 ATTACHMENT DANGER, KEEP HANDS ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAF
Summary of the content on the page No. 11
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. D H P G E N F B Q A C J M Fig. 15 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise and lower (G) REVERSE OPERATION SYSTEM (ROS) "ON" the
Summary of the content on the page No. 12
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide vision safety mask worn over spectacles. NOTE: Failure to move throttle control between half and full HOW TO USE YOUR TRAC TOR speed (fast) position, before stopping, may cause engine to “backfi
Summary of the content on the page No. 13
OPERATION TO MOVE FORWARD AND BACKWARD TO ADJUST GAUGE WHEELS (See Fig. 21) (See Fig. 19) Gauge wheels are prop er ly ad just ed when they are slight ly off the ground when mower is at the desired cutting height in The direction and speed of movement is controlled by the operating position. Gauge wheels then keep the deck in prop- motion control lever. (J) er position to help prevent scalping in most terrain conditions. NOTE: Adjust gauge wheels with tractor on a flat level J surface. • Ad
Summary of the content on the page No. 14
OPERATION REVERSE OPERATION SYSTEM (ROS) TO TRANSPORT (See Fig. 15 and 24) (See Fig. 23) When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in free wheel ing Your tractor is equipped with a Reverse Operation System po si tion. Free wheel control is located at the rear drawbar (ROS). Any attempt by the operator to travel in the reverse of tractor. direction with the attachment clutch engaged will shut off • Raise attachment lift to highest
Summary of the content on the page No. 15
OPERATION TO START ENGINE (See Fig. 15) BEFORE STARTING THE ENGINE When starting the engine for the first time or if the engine CHECK ENGINE OIL LEVEL has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine. The engine in your tractor has been shipped, from the • Be sure freewheel control is in the transmission en gaged factory, already filled with sum mer weight oil. position. • Check engine oil with tractor on level ground. • Sit on seat in opera
Summary of the content on the page No. 16
OPERATION PURGE TRANSMISSION MOWING TIPS • Mower should be properly leveled for best mowing CAUTION: Never engage or disengage performance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual. freewheel lever while the engine is run ning. • The left hand side of mower should be used for trim ming. To ensure proper operation and performance, it is rec om- • Drive so that clippings are discharged onto the area mend ed that the transmission be purged before op
Summary of the content on the page No. 17
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 1,2 Change Engine Oil
Summary of the content on the page No. 18
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blades. main te nance. CAUTION: Use only a replacement blade ap- BRAKE OPERATION proved by the manufacturer of your tractor. If tractor requires more than five (5) feet to stop at highest Using a blade not approved by the manu- speed in high est gear on a level, dry concrete or paved facturer of your tractor is hazardous, could surface
Summary of the content on the page No. 19
MAINTENANCE TRANSAXLE MAINTENANCE OIL DRAIN VALVE The transmission fan and cooling fins should be kept clean to assure proper cooling. Do not attempt to clean fan or transmission while engine CLOSED AND is running or while the transmission is hot. To prevent pos- LOCKED si ble damage to seals, do not use high pressure water or POSITION steam to clean transmission. DRAIN TUBE • Inspect cooling fan to be sure fan blades are intact and clean. • Inspect cooling fins for dirt, grass clippings
Summary of the content on the page No. 20
00667 MAINTENANCE DECK WASHOUT PORT (See Fig. 31) IN-LINE FUEL FILTER (See Fig. 29) Your tractor’s deck is equipped with a washout port on The fuel filter should be replaced once each season. If fuel its surface as part of its deck wash system. It should be filter becomes clogged, ob struct ing fuel flow to car bu re tor, utilized after each use. re place ment is re quired. 1. Drive the tractor to a level, clear spot on your lawn, near • With engine cool, remove filter and plug fuel line
