Summary of the content on the page No. 1
RE320
RE32
R32
For all customer enquiries or for replacement parts, contact:-
01325 300303
www.flymo.com
eop.customer.services@electrolux.co.uk
IMPORTANT INFORMATION
Read before use
& retain for future reference
Summary of the content on the page No. 2
1 Carton Contents start/stop lever switchbox cable clip lock off button nut (if washer applicable) upper handle bolt plastic handle lower handles knob grassbox safety flap upper grassbox lower lower handle fixing screws electric cable with motor cover moulded on plug spanner/scraper tool wheel assembly deck instruction manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Electrolux Outdoor Products C
Summary of the content on the page No. 3
2 General 4. Replace worn or damaged blades together with 1. Never allow children or people unfamiliar with their fixings in sets to preserve balance. these instructions to use the mower. Local reg- Use ulations may restrict the age of the operator. 1. Use the lawnmower only in daylight or good 2. Only use the lawnmower in the manner and for artificial light. the functions described in these instructions. 2. Avoid operating your lawnmower in wet grass, 3. Never operate the lawnmower when you are
Summary of the content on the page No. 4
3 CABLES MAINS PLUG REPLACEMENT IMPORTANT IMPORTANT 2 • Use only 1.00mm size cable up to 30 metres • If the plug supplied is cut off it should be length maximum. destroyed. There is an electric shock hazard if a Maximum rating : cut off plug is inserted into a 13 amp socket. 2 1.00mm size cable, 10 amps 250 volts AC. 1. No earth required. Flymo products are double • THE RE320/RE32/R32 IS SUPPLIED WITH insulated to EN60335 and under no circumstances CABLE WIRED DIRECTLY INTO THE PRODUCT. s
Summary of the content on the page No. 5
4 Cutting Height Adjustment E • Height of cut is adjusted by raising or lower- ing the wheels. • NOTE All 4 wheels must be adjusted to the same position: HEIGHT OF CUT WHEELS Low Hole 1 Medium Hole 2 High Hole 3 • NOTE to remove to fit A medium height of cut is recommended for turn anti-clockwise turn clockwise most lawns. 1. To remove the wheel assembly turn the wheel F hub in an anti-clockwise direction.(E) wheel 2. Select one of the 3 holes in the mounting plate and note it as the other 3 w
Summary of the content on the page No. 6
5 Starting and Stopping To Start your Lawnmower H J 1. Form loop in mains cable and push the loop through the slot. (H) 2. To secure, position loop over the hook and pull the cable back through the slot (J). 3. Connect plug to mains and switch on. 4. Tilt the handle downwards to slightly raise the front of the lawnmower and to reduce the risk of lawn damage whilst starting. The switchbox is provided with a lock-off button K L (K1) to prevent accidental starting. 5. Press and hold the lock-off bu
Summary of the content on the page No. 7
6 Caring for your Lawnmower Cleaning (Q) • USE GLOVES Q • IMPORTANT It is very important that you keep your lawnmower clean. Grass clippings left in any of the air intakes or under the deck could become a potential fire hazard. 1. Remove grass from under the deck with brush. 2. Using a soft brush - remove grass clippings from all air intakes, the discharge chute and the grass box. 3. Remove the blade, see Figure P, to gain access to the fan and clean with a soft brush. 4. Wipe over the surface
Summary of the content on the page No. 8
Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture Failures not covered by guarantee within the guarantee period, Electrolux Outdoor Products, * Replacing worn or damaged blades through its Authorised Service Repairers will effect the repair or * Failures as a result of not reporting an initial fault. replacement to the customer free of charge providing: * Failures as a result of sudden impact. (a) The fault is reported directly to the Authorised Repairer