Summary of the content on the page No. 1
Multimo 340XC
®
Multimo 360
Multimo 360XC
Multimo 420
Original Instructions
Multimo 420XC
Multimo 360XC
Multimo 340XC
Multimo 420XC
Multimo 360
Multimo 420
IMPORTANT INFORMATION
Read before use
& retain for future reference
Summary of the content on the page No. 2
Carton Contents lock off switchbox button Multimo 340XC cable clip x 2 Easi-Reel start/stop grassbox cable spool lever handle washer x 4 cam lock x 4 bolt grassbox upper upper handle barrel nut x 4 roller half x 2 lower handle x 2 grassbox half x 2 pivot block x 2 spring x 2 instruction electric cable mulching manual with moulded plug on plug lock off switchbox Multimo 360 button Multimo 420 cable clip x 2 start/stop grassbox lever handle washer grassbox x 4 upper cam lock x 4 bolt up
Summary of the content on the page No. 3
Carton Contents lock off switchbox button Multimo 360XC Multimo 420XC cable clip x 2 start/stop grassbox lever washer handle Easi-Reel x 4 cable spool cam lock x 4 bolt upper grassbox upper barrel handle nut x 4 roller half x 2 lower handle x 2 grassbox half x 2 pivot block x 2 spring x 2 instruction mulching manual electric cable plug with moulded on plug IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. The Loose Parts Pack is packa
Summary of the content on the page No. 4
Safety General 3. Before using the product and after any impact, 1. This product is not intended for use by persons check for signs of wear or damage and repair as (including children) with reduced physical, necessary. sensory or mental capabilities, or lack of 4. Replace worn or damaged blades together with experience and knowledge, unless they have their fixings in sets to preserve balance. been given supervision or instruction concerning Use the use of the product by a person responsible 1. U
Summary of the content on the page No. 5
Cables CABLES - IMPORTANT 1. No earth required. Flymo products are double 2 • Use only 1.00mm size cable up to 40 metres insulated to EN60335 and under no length maximum. circumstances should an earth be connected to Maximum rating : any part of the product. 2 1.00mm size cable, 10 amps 250 volts AC. 2. Ensure the mains voltage suits your product • YOUR PRODUCT IS SUPPLIED WITH AN 3. IMPORTANT! ELECTRIC MAINS CABLE FITTED WITH A FEMALE The wires in the mains lead are coloured in CONNECTOR
Summary of the content on the page No. 6
Assembly of Lower Handles to Lawnmower C1 C2 C3 1. Pull the lower handle bolt until it locks into position as 3. Insert the Pivot Block on to the Bolt (C3) illustrated in fig C1. Repeat for the other side. 2. Place the Spring over the Bolt (C2) D1 D2 4. Insert the Barrel Nut into the Cam Lock as illustrated Insert the Lower Handle, Washer and Cam Lock on to in fig D1. the Bolt (D3) and turn the Cam Lock 3 times 5. Ensuring the lower handle is in the correct position (D2) clockwise, as illus
Summary of the content on the page No. 7
Assembly of Upper Handles to Lower Handles E1 E2 E3 x3 1. Insert the Barrel Nut into the Cam Lock as illustrated illustrated in fig E2 in fig E1. 3. Turn the Cam Lock 3 times clockwise, as illustrated in 2. Attach the Upper Handle to the Lower Handle with the fig E3. Round Headed Bolt, Washer and Cam Lock as E4 E5 E6 4. Fold down the Cam Lock towards the Handle as 5. The Cam Lock can be unlocked and locked as illustrated in fig E4, and continue to turn clockwise illustrated in fig E6. (E5) until
Summary of the content on the page No. 8
How to Mow Your product can be used to cut grass using the following K methods:- 1. Grassbox Fitted:- grass is collected effectively and compacted into the grassbox. (K) 2. Rear Discharge:- Effectively cuts long grass with no need to empty the grassbox (L) 3. Mulch Plug Fitted:- grass cuttings are finely chopped to return nutrients to your lawn (M). See ‘Mulching Plug’ on page 7. L How to Mow 1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you
Summary of the content on the page No. 9
Cutting Height Adjustment Cutting Height Adjustment Q • Height of cut is adjusted by raising or lowering the wheels using the height adjustment lever (Q) • There are five heights of cut on this product. • NOTE A medium height of cut is recommended for most lawns. The quality of your lawn will suffer and collection will be poor if you cut too low. Starting and Stopping To Start your Lawnmower R S 1. Connect female extension cable connector to the back of the switchbox. (R) 2. Form loop in mains c
Summary of the content on the page No. 10
Caring for your Lawnmower Z1 Z2 Cleaning • USE GLOVES • IMPORTANT:- It is very important that you keep your lawnmower clean. Grass clippings left in any of the air intakes or under the deck could become a potential fire hazard. 1. Remove grass from under the deck with brush. (Z1) Z3 Z4 2. Using a soft brush - remove grass clippings from all air intakes (Z2), the discharge chute (Z3) and the grass box (Z4). 3. Using a soft brush, remove grass clippings from the vision window (Z5). 4. Wipe over t
Summary of the content on the page No. 11
Easi-Reel Cable Winder (XC models only) Y1 Y2 Storing your cable in the Easi-Reel cable winder 1. Insert the female connector into the centre of the cable winder (Y1) 2. Place the cable under the cable guide (Y2) 3. Turn the cable winder (Y3) until all of the cable is wound in.(Y4) Y3 Y4 Unwinding the cable before re-use 1. Pull the cable by the plug and unwind the cable fully. • Ensure that the cable is released from the cable guide (Y2) before using your machine. • Ensure cable is not entangle
Summary of the content on the page No. 12
Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture Failures not covered by guarantee within the guarantee period, Husqvarna UK Ltd., through its * Replacing worn or damaged blades. Authorised Service Repairers will effect the repair or replacement * Failures as a result of not reporting an initial fault. to the customer free of charge providing: * Failures as a result of sudden impact. (a) The fault is reported directly to the Authorised Repairer. * Failu
