Summary of the content on the page No. 1
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Otreap Or ’s Mlauna
Hydrostatic Lawn Tractor — LTX1042KW, LTX1045 & LTX1046M
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA Form No. 769-08376
(November 1, 2012)
Summary of the content on the page No. 2
To The Owner 1 Thank You Thank you for purchasing a Cub Cadet Lawn Tractor. It was If applicable, the power testing information used to establish carefully engineered to provide excellent performance when the power rating of the engine equipped on this machine can be properly operated and maintained. found at www.opei.org or the engine manufacturer’s web site. Please read this entire manual prior to operating the equipment. If you have any problems or questions concerning the machine, It i
Summary of the content on the page No. 3
Important Safe Operation Practices 2 WARNING! This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol. HEED ITS WARNING! CALIFORNIA PROPOSITION 65 WARNING! Engine Exhaust, some of its constituents, and certain v
Summary of the content on the page No. 4
12. A missing or damaged discharge cover can cause blade Slope Operation contact or thrown object injuries. Slopes are a major factor related to loss of control and tip-over 13. Stop the blade(s) when crossing gravel drives, walks, or accidents which can result in severe injury or death. All slopes roads and while not cutting grass. require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it. 14. Watch for traffic when operating near or crossing roa
Summary of the content on the page No. 5
Children Service 1. Tragic accidents can occur if the operator is not alert to the Safe Handling of Gasoline: presence of children. Children are often attracted to the machine and the mowing activity. They do not understand 1. To avoid personal injury or property damage use extreme the dangers. Never assume that children will remain where care in handling gasoline. Gasoline is extremely you last saw them. flammable and the vapors are explosive. Serious personal injury can occur when gasolin
Summary of the content on the page No. 6
3. Periodically check to make sure the blades come to Do not modify engine complete stop within approximately (5) five seconds after To avoid serious injury or death, do not modify engine in any operating the blade disengagement control. If the blades way. Tampering with the governor setting can lead to a runaway do not stop within the this time frame, your machine engine and cause it to operate at unsafe speeds. Never tamper should be serviced professionally by an authorized MTD with fa
Summary of the content on the page No. 7
Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manual(s) before attempting to assemble and operate DANGER— ROTATING BLADES Never carry passengers. Never carry children, even with the blades off. DANGER— ROTATING BLADES Always look down and
Summary of the content on the page No. 8
8 Scetion 2 — i namtport Sefa o tioepnra p rcatiec S 15° dashed line Slope Gauge 15° Slope 15° Slope (OK) (TOO STEEP) Figure 1 Figure 2 USE THIS SLOPE GAUGE TO DETERMINE IF A SLOPE IS TOO STEEP FOR SAFE OPERATION! To check the slope, proceed as follows: 1. Remove this page and fold along the dashed line. 2. Locate a vertical object on or behind the slope (e.g. a pole, building, fence, tree, etc.) 3. Align either side of the slope gauge with the object (See Figure 1 and Figure 2 ). 4. Adjust ga
Summary of the content on the page No. 9
Assembly & Set-Up 3 Contents of Crate • One Lawn Tractor • One Oil Drain Tube • One Deck Wash Hose Coupler • One Lawn Tractor Operator’s Manual • One Engine Operator’s Manual CAUTION: Never attempt to move the tractor Tractor Set-Up manually without first opening the hydrostatic relief valve. Doing so will result in serious damage to the Moving The Tractor Manually tractor’s transmission. Your tractor’s transmission is equipped with a hydrostatic relief valve for occasions when it is n
Summary of the content on the page No. 10
Checking Tire Pressure Connecting the Battery Cables CALIFORNIA PROPOSITION 65 WARNING! WARNING! Do not overinflate tires. Check sidewall of tires for maximum psi. Equal tire pressure should Battery posts, terminals, and related accessories be maintained at all times. contain lead and lead compounds, chemicals known to the State of California to cause cancer and The tires on your tractor may be over inflated for shipping reproductive harm. Wash hands after handling. purposes. Reduce the ti
Summary of the content on the page No. 11
Adjusting the Seat Gas and Oil To adjust the position of the seat, pull up and hold the seat The fuel tank is located under the hood. Remove the fuel cap by adjustment lever. Slide the seat forward or rearward to the turning it counterclockwise. Use only clean, fresh (no more than desired position; then release the adjustment lever. Make sure 30 days old), unleaded gasoline. Do not overfill the tank. seat is locked into position before operating the tractor. See The tractor is equipped with
Summary of the content on the page No. 12
Controls & Features 4 Systems Indicator Monitor Fuel Tank Cap Ignition Switch Module Choke Control Throttle/Choke Control Fuel Level Indicator Drive Pedal Brake Pedal Reverse Pedal Parking Brake/ Cargo Net Cruise Control Lever Deck Lift Lever Seat Adjustment Lever PTO (Blade Engage) Handle Storage Bin Cup Holder Figure 4-1 The Lawn Tractor controls and features are illustrated in Figure Choke Control 4-1 and described on the following pages. On some models, the Choke is separate from the Th
Summary of the content on the page No. 13
Deck Lift Lever Systems Indicator Monitor/Hour Meter LCD Found on your tractor’s right fender, the deck lift lever is used to change the height of the cutting deck. To use, move the lever to the left, then place in the notch best suited for your application. Ignition Switch Module WARNING! Never leave a running machine unattended. Always disengage When the ignition key is rotated out of the STOP position but not PTO, set parking brake, stop into the START position, the system’s indica
Summary of the content on the page No. 14
Fuel Level Indicator Parking Brake/Cruise Control Lever The Fuel Level Indicator is located on the left side of the tractor’s dash and indicates the amount of fuel in the gas tank. Located in the center of the tractor’s dash panel below the steering wheel, the Parking Brake/Cruise Control lever is used to engage the parking brake and the cruise control Refer to the Operation section of this manual for detailed instructions regarding the parking brake. PTO/Blade Engage Handle NOTE: The park
Summary of the content on the page No. 15
Operation 5 Starting the Engine NOTE: Refer to the Assembly & Set-Up section of this manual for Gasoline and Oil fill-up instructions. TO AVOID SERIOUS INJURY OR DEATH 1. Insert the tractor key into the ignition switch module. • GO UP AND DOWN SLOPES, NOT ACROSS. 2. Place the PTO (Blade Engage) knob in the disengaged (OFF) • AVOID SUDDEN TURNS. position. • DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR TIP. • IF MACHINE STOPS GOING UPHILL, STOP BLADE(S) 3. Engage the tractor’s parking brake.
Summary of the content on the page No. 16
Driving The Tractor Reverse Caution Mode The REVERSE CAUTION MODE position of the key switch module WARNING! Avoid sudden starts, excessive speed allows the tractor to be operated in reverse with the blades (PTO) and sudden stops. engaged. NOTE: Mowing in reverse is not recommended. 1. Lightly press the brake pedal to release the parking brake. WARNING! Use extreme caution while operating Move the throttle lever into the FAST (rabbit) position. the tractor in the REVERSE CAUTION MODE. Al
Summary of the content on the page No. 17
Cruise Control Driving On Slopes WARNING! Never engage the cruise control lever Refer to the SLOPE GAUGE on page 8 to help determine slopes while traveling in reverse. where you may operate the tractor safely. WARNING! Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1⁄2 To set the cruise control: feet every 10 feet). The tractor could overturn and cause serious injury. 1. Slowly press the drive pedal with your right foot until the desired speed is
Summary of the content on the page No. 18
Engaging the PTO Engaging the PTO transfers power to the cutting deck or other (separately available) attachments. To engage the PTO: 1. Move the Throttle/Choke control, or Throttle control lever to the FAST (rabbit) position. 2. Push the PTO/Blade Engage lever forward into the engaged (ON) position. NOTE: Always operate the tractor with the Throttle/Choke control, or Throttle control lever in the FAST (rabbit) position for the most efficient use of the cutting deck or other (separately av
Summary of the content on the page No. 19
Maintenance & Adjustments 6 Maintenance Schedule Before Every Every Every Every Prior Each use 10 Hours 25 Hours 50 Hours 100 Hours to Storing Clean Hood/Dash Louvers P P Check Engine Oil Level P Check Air Filter for Dirty, Loose or Damaged Parts P Clean and Re-oil Air Filter’s Foam Precleaner P Replace Air Filter Element P Change Engine Oil and Replace Oil Filter P Clean Battery Terminals P P Lube Front Axles and Rims P P Clean Engine Cooling Fins P P Lube Front Deck Wheels P P Lube Pedal Piv
Summary of the content on the page No. 20
3. Pop open the protective cap on the end of the oil drain Spark Plug valve to expose the drain port. See Figure 6-1 The spark plug should be cleaned and the gap reset once a season. Refer to the Kohler Owner’s Manual for correct plug type and gap specifications. Hydrostatic Transmission The hydrostatic transmission is sealed at the factory and is maintenance-free. The fluid level cannot be checked and the fluid cannot be changed. Battery CALIFORNIA PROPOSITION 65 WARNING! Battery posts, t
