Summary of the content on the page No. 1
Catalyst 6500 Series Supervisor Engine Flash PC
Card Installation Note
Product Numbers:
MEM-C6K-FLC16M(=)
MEM-C6K-FLC24M(=)
MEM-C6K-FLC64M(=)
MEM-C6K-ATA-1-64M(=)
This installation note contains the procedure to install a Flash PC card in the Catalyst 6500 series
supervisor engines.
Note The 64-MB ATA Flash PC card (MEM-C6K-ATA-1-64M) requires Supervisor Engine 2 with ROMMON
software release 7.1(1) or later releases. For ROMMON software upgrade details, refer to
http://www.cisco.com/univercd/cc/
Summary of the content on the page No. 2
Contents Contents This installation note contains the following sections: • Supervisor Engine Flash PC Cards, page 2 • Preventing Electrostatic Discharge Damage, page 3 • Installing and Removing a Flash PC Card, page 3 • Using Flash PC Cards, page 6 • Additional Documentation, page 8 • Obtaining Documentation, page 8 • Documentation Feedback, page 9 • Cisco Product Security Overview, page 9 • Obtaining Technical Assistance, page 10 • Obtaining Additional Publications and Information, page 12 S
Summary of the content on the page No. 3
Preventing Electrostatic Discharge Damage Figure 1 Supervisor Engine Flash PC Card Slot Switch load CONSOLE port display PCMCIA LED LINK LEDs WS-X6K-SUP1 Switch Load 100% CONSOLE PORT 1 PORT 2 PORT MODE CONSOLE PCMCIA EJECT 1% SUPERVISOR I CONSOLE PORT MODE switch PCMCIA slot 1000BASE-X GBIC Uplink Ports Status LEDs RESET button For information about using the PCMCIA Flash PC cards, see the “Using Flash PC Cards” section on page 6. Preventing Electrostatic Discharge Damage Follow these g
Summary of the content on the page No. 4
Installing and Removing a Flash PC Card Figure 2 Locating the Flash PC Card Write Protection Switch Flash PC card Flash PC card shown with write write protection protection off Flash PC card To install and remove a Flash PC card (see Figure 3), perform these steps: Note You can insert and remove the Flash PC card with the power on. Step 1 Connect an ESD-preventive strap to the ESD connector on the switch. Step 2 Face the front panel of the switch, and hold the Flash PC card with the connector
Summary of the content on the page No. 5
WS-X5530 100% SUPERVISOR ENGINE I I I PCMCIA EJECT CONSOLE AUX Switch Load WS-X5530 100% SUPERVISOR ENGINE I I I CONSOLE AUX PCMCIA EJECT Switch Load WS-X5530 100% SUPERVISOR ENGINE I I I CONSOLE AUX PCMCIA EJECT Switch Load Installing and Removing a Flash PC Card Figure 3 Installing and Removing a Flash PC Card a b c Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note 78-6507-06 5 SYSTEM STATUS FAN PS2 PS1 ACTIVE RESET SLOT 1 SLOT 0 SYSTEM STATUS FAN PS
Summary of the content on the page No. 6
Using Flash PC Cards Using Flash PC Cards Note An MS-DOS formatted ATA Flash PC card or linear Flash PC card can be accessed successfully (including the dir command) with the Catalyst and Cisco IOS operating systems but will not boot from ROMMON. Note The 16-MB MEM-C6K-FLC16M and 24-MB MEM-C6K-FLC24M linear Flash PC cards are formatted for the Catalyst 6500 series supervisor engines and are ready to use. The MEM-C6K-ATA-1-64M and 64-MB MEM-C6K-FLC64M Flash PC cards are not formatted. You must
Summary of the content on the page No. 7
Using Flash PC Cards Table 1 Commands for Using and Managing Flash Devices Task Command Copy a Flash file to a TFTP server, another copy m/device:filename {tftp | flash | m/device:filename | Flash device, or to the running config} configuration. Copy a file from a TFTP server to a Flash copy tftp {flash | m/device:filename | config} device or to the running configuration. Copy a file from Flash memory to a TFTP copy flash {tftp | m/device:filename | config} server or to a Flash device, or to the running confi
Summary of the content on the page No. 8
Additional Documentation Additional Documentation Refer to the following documents for additional information on supervisor engine Flash devices: • Release Notes for Catalyst 6500 Series and Cisco 7600 Series Internet Router Supervisor Engine 2 ROMMON • Catalyst 6500 Series Software Configuration Guide • Catalyst 6500 Series Command Reference Obtaining Documentation Cisco documentation and additional literature are available on Cisco.com. Cisco also provides several ways to obtain technical as
Summary of the content on the page No. 9
Documentation Feedback Ordering Documentation Beginning June 30, 2005, registered Cisco.com users may order Cisco documentation at the Product Documentation Store in the Cisco Marketplace at this URL: http://www.cisco.com/go/marketplace/ Nonregistered Cisco.com users can order technical documentation from 8:00 a.m. to 5:00 p.m. (0800 to 1700) PDT by calling 1 866 463-3487 in the United States and Canada, or elsewhere by calling 011 408 519-5055. You can also order documentation by e-mail at te
Summary of the content on the page No. 10
Obtaining Technical Assistance Reporting Security Problems in Cisco Products Cisco is committed to delivering secure products. We test our products internally before we release them, and we strive to correct all vulnerabilities quickly. If you think that you might have identified a vulnerability in a Cisco product, contact PSIRT: • Emergencies—security-alert@cisco.com An emergency is either a condition in which a system is under active attack or a condition for which a severe and urgent securi
Summary of the content on the page No. 11
Obtaining Technical Assistance Note Use the Cisco Product Identification (CPI) tool to locate your product serial number before submitting a web or phone request for service. You can access the CPI tool from the Cisco Technical Support & Documentation website by clicking the Tools & Resources link under Documentation & Tools. Choose Cisco Product Identification Tool from the Alphabetical Index drop-down list, or click the Cisco Product Identification Tool link under Alerts & RMAs. The CPI tool
Summary of the content on the page No. 12
Obtaining Additional Publications and Information Obtaining Additional Publications and Information Information about Cisco products, technologies, and network solutions is available from various online and printed sources. • Cisco Marketplace provides a variety of Cisco books, reference guides, documentation, and logo merchandise. Visit Cisco Marketplace, the company store, at this URL: http://www.cisco.com/go/marketplace/ • Cisco Press publishes a wide range of general networking, training a
Summary of the content on the page No. 13
Obtaining Additional Publications and Information • Networking products offered by Cisco Systems, as well as customer support services, can be obtained at this URL: http://www.cisco.com/en/US/products/index.html • Networking Professionals Connection is an interactive website for networking professionals to share questions, suggestions, and information about networking products and technologies with Cisco experts and other networking professionals. Join a discussion at this URL: http://www.cisc
Summary of the content on the page No. 14
Obtaining Additional Publications and Information This document is to be used in conjunction with the Catalyst 6500 Series Software Configuration Guide and the Catalyst 6500 Series Command Reference publications. CCSP, CCVP, the Cisco Square Bridge logo, Follow Me Browsing, and StackWise are trademarks of Cisco Systems, Inc.; Changing the Way We Work, Live, Play, and Learn, and iQuick Study are service marks of Cisco Systems, Inc.; and Access Registrar, Aironet, ASIST, BPX, Catalyst, CCDA, CCD
