Motorola GPS-100M user manual

Summary of the content on the page No. 1

MemoryLink UltraSync™ GPS-100M
GPS Synchronization Unit
for PTP 600 Series Wireless Ethernet Bridges

Summary of the content on the page No. 2

Contents pg Section 3 introduction 4 System o verview 5 Product Features and Benefits 6 installation The information in this publication is subject to change without notice. Motorola shall not be liable for technical or editorial errors or omissions nor for any damages resulting from the use of this material. Each configuration described may or may not be the only available solution. The description is not a determination of product quality or correctness, nor does it ensure compliance with

Summary of the content on the page No. 3

Introduction The Motorola wi4 Fixed Point-To-Point (PTP) 600 Series Wireless Ethernet Link, which consists of a pair of radios deployed one at each end of the link, operates on a single frequency channel in each direction using Time Division Duplex (TDD). in situations where a number of radios are installed on the same mast or where a large number of links are installed in a sizeable, dense network, it is possible that the performance or throughput of some of the links can be reduced. in som

Summary of the content on the page No. 4

System Overview To meet the high performance standards of a Motorola PTP broadband wireless network, Motorola has partnered with MemoryLink to deploy the MemoryLink UltraSync™ GPS-100M in a Motorola wi4 Fixed Point-to-Point (PTP) 600 Series network. With its integrated GPS receiver and internally-mounted antenna, the UltraSync GPS-100M generates a precise, highly stable, proprietary synchronization signal that is used by the PTP 600 Series radios to time and synchronize transmit and receive

Summary of the content on the page No. 5

product Features and Benefits UltraSync™ GpS-100M Features: • integral GPS receiver – 12 channel • Passes 1000 Base-T protocol • Supports Ethernet cable lengths of up to 330 feet (100 meters) from the PTP 600 PiDU Plus to the UltraSync GPS-100M Eth1/PWr port • r obust enclosure weighing approximately 23 ounces (650 grams) • Small footprint – 5.92” (150 mm) height, 3.95” (100 mm) width and 2.79” (71 mm) depth • i ncludes internally mounted GPS antenna, mounting bracket, screws, Ethernet cable

Summary of the content on the page No. 6

Installation Enabling TDD synchronization is a two-stage process: • install the GPS Synchronization Unit (Motorola part number WB3001) • E nable TDD synchronization mode on the PTP 600 radio and configure related parameters using the PTP 600 Web GUi interface The following are deployment considerations for an UltraSync™ GPS-100M with a PTP 600 Series link: • Fixed-frequency operations only • Fixed TDD operation only – all synchronized links have the same ratio master to slave • n ot presently

Summary of the content on the page No. 7

Installation continued The following diagram shows how to connect the UltraSync™ GPS-100M to the PTP 600 o DU fitted with a Lightning Protection Unit (PTP-LPU): UltraSync GPS-100M deployment diagram with a PTP 600 Series radio and a PTP Lightning Protection Unit The UltraSync GPS-100M sits between the Lightning Protection Unit and the oDU (outdoor unit) of a PTP 600 Series link. one UltraSync GPS-100M is required for each link. The unit receives a stable, accurate timing signal from

Summary of the content on the page No. 8

GpS SYNCHRONIZATION UNIT MOTOwi4™ The wi4 Fixed PTP 600 Series bridges and the wi4 Fixed PTP Lightning Protection Unit are part of Motorola’s Mo To wi4 portfolio of innovative wireless broadband solutions that create, complement and complete iP networks. Delivering iP coverage to virtually all spaces, the Mo To wi4 portfolio includes wi4 Fixed, wi4 Mesh, wi4 indoor and wi4 WiMa X solutions for private and public networks. Motorola, inc., 1303 E. algonquin road, Schaumburg, illinois 60196 U.