Summary of the content on the page No. 1
Satellite 2400/2405 Series
General Specifications
2400-S201 2400-S202
PS240U-00UMR7 PS240U-00UMR3
2405-S201 2400-S202
PS240U-00UMRX PS240U-00UMRJ
Processor: Intel Pentium 4 @ 1.60GHz; Integrated co-processor; 256MB expandable to 512MB; 512KB Level 2 cache integrated
on die; 400MHz front side bus clock speed
Memory: 256MB expandable to 512MB; SODIMM expansion memory
128/256/512Mbit PC2100 DDR, 2.5V
Data/Address Bus Width: 64-bit/32-bit; BIOS ROM: Intel FWH4Mbit; Intel 82845MZ
Drive(s): HDD: 30.0G
Summary of the content on the page No. 2
Satellite 2400 Series Exploded 14" TFT Upper View Toshiba TRR Page 2 7/02, Satellite
Summary of the content on the page No. 3
Satellite 2400 Series Exploded 14" TFT Lower View Toshiba TRR Page 3 7/02, Satellite
Summary of the content on the page No. 4
Satellite 2400 Series 14" TFT Part Numbers Ref. # Code Part # Description PIR Comments C1X6 PS240U-00UMR3 2400-S202/30 (00UMR3) S2400-S202/30, WXP Home, 1.60GHz P4, 256MB, CD-RW/DVD, 14 XGA TFT, Modem/LAN, (Wireless Ready) C1X6 PS240U-00UMR3B 2400-S202 (00UMR3B) B-STK S2400-S202/30, WXP Home, 1.60GHz P4, 256MB, CD-RW/DVD, 14 XGA TFT, Modem/LAN, (Wireless Ready), Remf C1X6 PS240U-00UMR7 2400-S201/30 (00UMR7) S2400-S201/30, WXP Pro, 1.60GHz P4, 256MB, CD-RW/DVD, 14 XGA TFT, Modem/LAN, (Wireless Re
Summary of the content on the page No. 5
Satellite 2400 Series Part 14" TFT Numbers, (cont.) Ref. # Code Part # Description PIR Comments 16 C1X8 P000348970 COLOR LCD MODULE CEH Sharp LQ141X1LH83, 14.1 XGA TFT, VF2065P02 16A C1X6 P000350800 FL TUBE 16B C1X6 P000261140 SCREW, M2X2 16C C1X7 P000350810 COVER S 16D C1X6 P000316210 AL TAPE 16E C1X6 P000350820 TAPE 17 C1X6 P000347420 FL INVERTER UA2024P04 18-A C1X6 P000341840 HDD UNIT (30GB) Toshiba, MK30KEF, HDD2169B 18-A-1 C1X6 P000341850 HDD UNIT (30GB) CEH IBM IC25N030ATCS04 (ATD04T), P/N
Summary of the content on the page No. 6
Satellite 2400 Series Part 14" TFT Numbers, (cont.) Ref. # Code Part # Description PIR Comments WIRELESS LAN SW. KNOB For units with letter D stamped on Base in battery compartment area 45-A C1X6 P000348490 45-B C1X6 P000349730 WIRELESS LAN SW. KNOB For units with letter P stamped on Base in battery compartment area 46 C1X6 P000283510 CPU STUD M2.5X6 Stud Screw 47 C1X6 P000309450 HEXA STUD M2.5X14 Stud Screw 48-49 C1X6 (RESERVED) 50 C1X6 P000349610 COVER ASSY For units with letter C stamped on B
Summary of the content on the page No. 7
Satellite 2400 Series 15" Exploded Upper View Toshiba TRR Page 7 7/02, Satellite
Summary of the content on the page No. 8
Satellite 2400 Series Exploded 15" Upper View Toshiba TRR Page 8 7/02, Satellite
Summary of the content on the page No. 9
Satellite 2400 Series 15" TFT Part Numbers Ref. # Code Part # Description PIR Comments C1X9 PS240U-02S4H3 2400-S252/30 (02S4H3) S2400-S252/30, WXP Home, 1.70GHz P4, 256MB, CD-RW/DVD, 15 TFT, Modem/LAN, (W'less Ready) C1X9 PS240U-02S4H3B 2400-S252 (02S4H3B) B-STK S2400-S252/30, WXP Home, 1.70GHz P4, 256MB, CD-RW/DVD, 15 TFT, Modem/LAN, (W'less Ready), Remf C1X9 PS240U-02S4H7 2400-S251/30 (02S4H7) S2400-S251/30, WXP Pro, 1.70GHz P4, 256MB, CD-RW/DVD, 15 TFT, Modem/LAN, (W'less Ready) C1X9 PS240U-0
Summary of the content on the page No. 10
Satellite 2400 Series Part 15" TFT Numbers, (cont.) Ref. # Code Part # Description PIR Comments 13G C1X9 P000302260 T SCREW, M1.7X2.8 13H C1X9 P000350780 TAPE 14 C1X9 P000347410 COLOR LCD MODULE LG.Philips LP150X04(D2), 15.0 XGA TFT, G33C00006110 14A C1Y1 P000350790 FL TUBE SET 15-16 C1X9 (RESERVED) 17 C1X9 P000347420 FL INVERTER UA2024P04 18 C1Y0 P000341840 HDD UNIT (30GB) Toshiba, MK30KEF, HDD2169B 18-1 C1X9 P000341850 HDD UNIT (30GB) IBM IC25N030ATCS04 (ATD04T), P/N: 07N8326, 07N9318, G8BC000
Summary of the content on the page No. 11
Satellite 2400 Series Part 15" TFT Numbers, (cont.) Ref. # Code Part # Description PIR Comments 45-B C1Y1 P000349730 W'LESS LAN SW. KNOB For units with letter P stamped on Base in battery compartment area 46 C604 P000283510 CPU STUD M2.5X6 Stud Screw 47 C1X9 P000309450 HEXA STUD M2.5X14 Stud Screw 48-49 C1X9 (RESERVED) 50 C604 P000347650 COVER ASSY For units with letter C stamped on Base in battery compartment area 50-A C1Y0 P000348500 COVER ASSY For units with letter D stamped on Base in batter
Summary of the content on the page No. 12
Satellite 2400 Series Disassembly Overview The information offered in this section is an overview of the Maintenance Manual, Chapter 4, Replacement Procedures. If you have any questions or concerns regarding the proper procedure please refer to the Mainte- nance Manual through the Toshiba Service and Support Website before you proceed. This section explains how to remove Field Replaceable Units (FRUs). It may not be neces- sary to remove all the FRUs in order to replace one. The chart is a guid
Summary of the content on the page No. 13
Satellite 2400 Series Disassembly Overview, cont. To remove an optional SD card, follow the steps below. 1. Turn the computer right side up. 2. Push the SD card in and release it to pop the card out slightly. 3. Grasp the SD card and remove it. To remove the HDD, follow the steps below. 1. Turn the computer upside down. 2. Remove one M2.5x4 black flat-head screw securing the HDD cover. 3. Lift off the HDD cover. 4. Pull the guide to remove the HDD. Be careful not to damage the connector. 5. Plac
Summary of the content on the page No. 14
Satellite 2400 Series Disassembly Overview, cont. To remove the modem daughter card (MDC), follow the steps below. 1. Turn the computer upside down. 2. Remove one M2.5x4 black flat-head screw. 3. Lift off the modem slot cover. 4. Remove two M2x4 super flat screws securing the MDC. 5. Carefully lift up the MDC to disconnect it from PJ9 (S1400) or PJ125 (S2400) on the system board. 6. Carefully disconnect the modem cable from JP1 on the MDC. To remove the wireless LAN card, follow the steps below.
Summary of the content on the page No. 15
Satellite 2400 Series Disassembly Overview, cont. To remove the keyboard, follow the steps below. 1. Open the display panel. 2. Insert the fingernails of both hands into notches in the keyboard brace and the computer, and pry up to release the brace at twelve points. Remove the brace. 3. Remove one M2.5x4 black flat-head screw securing the metal brace. 4. Remove two M2.5x2.6 black flat-head screws. 5. Rotate the keyboard out and lay it on top " of the palmrest. 6. Disconnect the keyboard cable f
Summary of the content on the page No. 16
Satellite 2400 Series Disassembly Overview, cont. " " # To remove the optical disk drive, follow the steps below. 1. Disconnect the optical disk drive (DVD) from PJ2001 on the system board. 2. Carefully slide the drive to the right to remove it. 3. Remove two M2x5 silver thin flat-head screws and the short metal brace. 4. Remove one M2x3 silver thin flat-head screw and the long metal brace. ! To remove the FDD, follow the steps below. 1. Disconnect the FDD SUMI card from PJ2007 on the system boa
Summary of the content on the page No. 17
Satellite 2400 Series Disassembly Overview, cont. To remove the touch pad, follow the steps below. 1. Disconnect the touch pad SUMI card from PJ2004 on the system board. 2. Remove one M2x5 silver thin flat-head screw securing the touch pad. 3. LIft out the touch pad. 4. Disconnect the touch pad SUMI card from CN1 on the touch pad. ! To remove the battery board, follow the steps below. 1. Disconnect the battery cable from PJ8810. 2. Lift out the battery board. 3. Disconnect the battery cable from
Summary of the content on the page No. 18
Satellite 2400 Series Disassembly Overview, cont. To install the HDD connector board, follow the steps below. 1. Seat the HDD connector board and carefully connect it to PJ2000 on the system board. 2. Secure the HDD connector board with two M2x5 silver thin flat-head screws. 3. Lift out the HDD connector board. CAUTION: Be careful not to damage or pinch the FDD SUMI card when you seat the HDD connec- tor board. Be sure the wireless LAN switch is in the correct position. To remove the RTC batter
Summary of the content on the page No. 19
Satellite 2400 Series Disassembly Overview, cont. To remove the DC-IN cable, follow the steps below. 1. Remove two M2.5x6 black flat-head screws securing the plastic brace. 2. Remove the plastic brace. 3. Disconnect the DC-IN cable from PJ8800 on the system board. 4. Remove the DC-IN cable. ! To remove the cooling fan, follow the steps below. 1. Remove two M2x6 screws securing the metal brace. 2. Remove the metal brace. 3. Disconnect the power cable from PJ8770 (S2400) or PJ770 (S1400) on the sy
Summary of the content on the page No. 20
Satellite 2400 Series Disassembly Overview, cont. To remove the PC card slot, follow the steps below. 1. Lay the system board right side up. 2. Remove four M2x12 screws securing the PC card slot. 3. Lay the system board right side up. 4. Disconnect the PC card slot from PJ3332. ! To remove the speakers, follow the steps below. 1. Lay the top cover and display assembly upside down. 2. Remove four M2.5x5 screws securing the speakers. 3. Remove the tape securing the speaker cables. 4. Free the spea
