Summary of the content on the page No. 1
TOSHIBA Portégé M200
Portable Personal Computer
User’s Manual
Summary of the content on the page No. 2
Copyright © 2003 by TOSHIBA Corporation. All rights reserved. Under the copyright laws, this manual cannot be reproduced in any form without the prior written permission of TOSHIBA. No patent liability is assumed, with respect to the use of the informa- tion contained herein. TOSHIBA Portégé M200 Portable Personal Computer User’s Manual First edition November 2003 Disclaimer This manual has been validated and reviewed for accuracy. The instructions and descriptions it contains are accurate for t
Summary of the content on the page No. 3
FCC information Product Name : Portégé M200 Model number : PPM20 FCC notice "Declaration of Conformity Information" This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the inst
Summary of the content on the page No. 4
FCC conditions This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. Contact Address: TOSHIBA America Information Systems, Inc. 9740 Irvine Boulevard Irvine, California 92618-1697 Telephone: (949) 583-3000 EU Declaration of Conformity TOSHIBA declares, that the product: PPM20* confor
Summary of the content on the page No. 5
Modem warning notice Conformity Statement The equipment has been approved to [Commission Decision “CTR21”] for pan- European single terminal connection to the Public Switched Telephone Network (PSTN). However, due to differences between the individual PSTNs provided in different countries/regions the approval does not, of itself, give an unconditional assurance of successful operation on every PSTN network termination point. In the event of problems, you should contact your equipment supplier in
Summary of the content on the page No. 6
Japan regulations Region selection If you are using the computer in Japan, technical regulations described in the Telecommunications Business Law require that you select the Japan region mode. It is illegal to use the modem in Japan with any other selection. Redial Up to two redial attempts can be made. If more than two redial attempts are made, the modem will return Black Listed. If you are experiencing problems with the Black Listed code, set the interval between redials at one minute or longe
Summary of the content on the page No. 7
Type of service Your modem is designed to be used on standard-device telephone lines. Connec- tion to telephone company-provided coin service (central office implemented systems) is prohibited. Connection to party lines service is subject to state tariffs. If you have any questions about your telephone line, such as how many pieces of equipment you can connect to it, the telephone company will provide this informa- tion upon request. Telephone company procedures The goal of the telephone compan
Summary of the content on the page No. 8
Fax branding The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device to send any message via a telephone fax machine unless such message clearly contains in a margin at the top or bottom of each transmitted page or on the first page of the transmission, the date and time it is sent and an identification of the business, other entity or individual sending the message and the telephone number of the sending machine or such busines
Summary of the content on the page No. 9
NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termina- tion on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5. 3 The standard connecting arrangement (telephone jack type) for this equipment is jack type(s): USOC RJ11C. The IC regis
Summary of the content on the page No. 10
Notes for use of this device in New Zealand ❑ The grant of a Telepermit for a device in no way indicates Telecom acceptance of responsibility for the correct operation of that device under all operating conditions. In particular the higher speeds at which this modem is capable of operating depend on a specific network implementation which is only one of many ways of delivering high quality voice telephony to customers. Failure to operate should not be reported as a fault to Telecom. ❑ In additio
Summary of the content on the page No. 11
ATS11=90 (DTMF dialing on/off duration=90 ms) ATX2 (Dial tone detect, but not (U.S.A.) call progress detect) ❑ When used in the Auto Answer mode, the S0 register must be set with a value of 3 or 4. This ensures: (a) a person calling your modem will hear a short burst of ringing before the modem answers. This confirms that the call has been successfully switched through the network. (b) caller identification information (which occurs between the first and second ring cadences) is not destroyed.
Summary of the content on the page No. 12
General conditions As required by PTC 100, please ensure that this office is advised of any changes to the specifications of these products which might affect compliance with the relevant PTC Specifications. The grant of this Telepermit is specific to the above products with the marketing description as stated on the Telepermit label artwork. The Telepermit may not be assigned to other parties or other products without Telecom approval. A Telepermit artwork for each device is included from which
Summary of the content on the page No. 13
Table of Contents Preface Manual contents .................................................................................xix Conventions .........................................................................................xx Abbreviations ........................................................................................ xx Icons .................................................................................................... xx Keys ................................................
Summary of the content on the page No. 14
Front with the display open .............................................................. 2-7 Indicators............................................................................................ 2-9 AC adaptor ....................................................................................... 2-12 Chapter 3 Getting Started Setting up your work space .............................................................. 3-2 General conditions........................................................
Summary of the content on the page No. 15
Method 1: Changing the screen orientation using TOSHIBA Accelerometer Utilities ............................................ 4-11 Method 2: Changing the screen orientation using Cross Function Button ............................................................ 4-12 Method 3: Changing the screen orientation using Task Bar ................................................................................. 4-12 Changing to the laptop mode......................................................... 4-13
Summary of the content on the page No. 16
Temporarily using normal keyboard (overlay on) .................................. 5-8 Temporarily using overlay (overlay off) ................................................. 5-9 Temporarily changing modes .............................................................. 5-9 Generating ASCII characters ............................................................ 5-9 Chapter 6 Power and Power-Up Modes Power conditions ............................................................................... 6
Summary of the content on the page No. 17
Chapter 8 Optional Devices PC cards ............................................................................................. 8-2 Inserting a PC card ............................................................................. 8-2 Removing a PC card ........................................................................... 8-3 SD cards ............................................................................................. 8-3 Inserting an SD card .....................................
Summary of the content on the page No. 18
Standby/Hibernation ......................................................................... 9-17 Modem ............................................................................................. 9-17 LAN .................................................................................................. 9-19 Wireless LAN ................................................................................... 9-19 Bluetooth ............................................................................
Summary of the content on the page No. 19
Preface Congratulations on your purchase of the TOSHIBA Portégé M200 computer. This powerful, lightweight notebook computer is designed to provide years of reliable, high-performance computing. This manual tells how to set up and begin using your TOSHIBA Portégé M200 computer. It also provides detailed information on configuring your computer, basic operations and care, using optional devices and troubleshooting. If you are a new user of computers or if you’re new to portable computing, first re
Summary of the content on the page No. 20
User's Manual Chapter 5, The Keyboard, describes special keyboard functions including the keypad overlay and hotkeys. Chapter 6, Power and Power-Up Modes, gives details on the computer’s power resources and battery save modes and how to set a password. Chapter 7, HW Setup, explains how to configure the computer using the HW Setup program. Chapter 8, Optional Devices, describes the optional hardware available. Chapter 9, Troubleshooting, provides helpful information on how to perform some diagnos
