Summary of the content on the page No. 1
PCG-FXA53/FXA59
SERVICE MANUAL For American Area
US Model
CanadianModel
Ver 2-2002G
Revision History
S400
Lineup : PCG-FXA59
PCG-FXA53
• Design and specifications are subject to
change without notice.
NOTEBOOK COMPUTER
9-874-549-02
Confidential
Summary of the content on the page No. 2
Information in this document is subject to change without notice. Caution Markings for Lithium/Ion Battery - The following or similar texts shall be provided on battery pack of equipment or in both the Sony, VAIO and CLIE are trademarks or registered trademarks of operating and the service instructions. Sony. Microsoft, Windows, Windows Media, Outlook, Bookshelf and other Microsoft products are trademarks or registered trademarks CAUTION: Danger of explosion if battery is incorrectly replaced. o
Summary of the content on the page No. 3
TABLE OF CONTENTS Section Title Page CHAPTER 1. BLOCK DIAGRAM ............................... 1-1 (to 1-2) CHAPTER 2. FRAME HARNESS DIAGRAM ........ 1-1 (to 1-2) CHAPTER 3. EXPLODED VIEWS AND PARTS LIST ............................................ 3-1 3-1. Main Section .................................................................... 3-2 3-2. FDD Section .................................................................... 3-5 3-3. LCD Section (FXA53 Model) – Made by AC – .............. 3-7 3-
Summary of the content on the page No. 4
108-pin Port Replicator CONNECTOR CN CN PC Card Socket 1 PC Card Socket 2 ADDRESS DATA CTRL SIGNAL CN CN Secondary IDE Bus CHAPTER 1. BLOCK DIAGRAM CPU PCG-FX Series AMD Mobile Athlon XP 1500 + BLOCK DIAGRAM Rev.A (Cache:128KB L1 256KB L2) (FSB 200 MHz) w/ Port Replicator (PCGA-PRFX1) 2001/08/27 LCD Panel 462 PIN PGA SOCKET A 14.1" TFT Main Memory Port Replicator XGA 12 V IN PC133 SO-DIMM CNX-126 256MB X1 (Max.512MB) Card bus LCD Sig VA POWER CIRCUIT Signal CPU-VCC 1 DC-IN SO-DIMM SO-DIMM D
Summary of the content on the page No. 5
CHAPTER 2. FRAME HARNESS DIAGRAM DC-IN USB NETWORK MONITOR PRINTER SERIAL USB PHONE Rear Panel LCD KEY BOARD INVERTER DC FAN FFC LED PL1 CON6 PCN1 CON13 CON11 CON2 CON1 CON3 CNX-150 Board CON21 9 1 (Side-A) 250 2 CON15 10 1 25 50 26 CPU 1 1 49 CON4 99 4 1 CON19 100 2 50 2 CON23 CON9 CON5 VIDEO OUT 1 49 CPU1 FPC CON18 EXTERNAL MICROPHONE CON17 HEADPHONE CON2 MBX-61 Board CON8 (Side-A) CON12 CARD MODEM IEEE 1394 i.LINK 143 29 CON1 1 1 HARD DISK 30 2 144 2 J1 29 1 143 2 30 1 Side 1 3 144 2 CON2 CON
Summary of the content on the page No. 6
CHAPTER 3. EXPLODED VIEWS AND PARTS LIST NOTE: The components identified by mark 0 or • The mechanical parts with no reference number in the dotted line with mark 0 are critical for safety. exploded views are not supplied. Replace only with part number specified. • Items marked “ * ” are not stocked since they are seldom Les composants identifiés par une marque required for routine service. Some delay should be 0 sont critiques pour la sécurité. anticipated when ordering these items. Ne les remp
Summary of the content on the page No. 7
3-1. Main Section Ref.No. Part No. Description Ref.No. Part No. Description 1 X-4623-848-3 [CH]...ASSY BOTTOM (Q) 161 4-654-019-01 GASKET (AV) 3 4-640-837-22 DOOR BATTERY 162 4-654-047-01 SHIELD (AV) * 8 4-651-706-01 HEATSINK BOTTOM 163 4-653-936-01 GASKET (HB/M) 11 4-656-752-01 [CH]...INSULATOR HEATSINK BOTTOM 164 A-8059-275-A COOLING UNIT-3 15 4-643-832-21 DUMMY CARD 165 4-644-667-01 COVER RJ-11 18 A-8049-276-A COMPLETE PWB SWX-74 166 4-654-631-01 GUARD SPK 19 X-4623-389-1 ASSY HOOD KEYBOARD Z
Summary of the content on the page No. 8
B8 B1 B33 J B33 I 187 B1 J 181 185 B1 22 186 B1 30 B32 A B15 N N 25 K M B1 B15 B1 B8 60 19 188 24 Supplied C with 19 164 27 26 B14 B1 136 180 20 147 15 125 124 166 B17 18 182 76 H B8 Supplied 28 136 with 88 88 Supplied 196 29 B8 with 88 123 63 B4 M 20 B4 I B8 194 K 195 76 H B8 149 162 72 B4 148 157 B8 B1 L L C 71 B7 B10 46 F 78 B10 31 D B8 B38 Supplied 197 161 193 B12 165 with 88 191 192 58 B8 57 84 163 161 52 48 81 162 134 B10 33 B31 32 56 B14 B8 E 190 184 B 34 B3 38 B12 183 A 59 11 67 B 184 D
Summary of the content on the page No. 9
3-2. FDD Section MEMO How to use properly the FDD repair parts. Types of service to be provided are different depending on the part No. of the FDD in use. Label FD X-XXX-XXX-XX Label Part No. The service types are shown below depending on the part No. that is printed in the bottom right of the FD label. [Label Part No. : 4-656-805-0 ] [Label Part No. : 4-641-763-3 ] * * 800 800 806 807 804 801 805 802 B1 803 B1 Ref.No. Part No. Description Ref.No. Part No. Description 800 A-8025-674-A FDD UNIT A
Summary of the content on the page No. 10
Ref.No. Part No. Description Ref.No. Part No. Description 3-3. LCD Section (FXA53 Model) – Made by AU – 301 1-476-318-21 INVERTER UNIT ACCESSORIES 302 X-4623-378-1 HINGE LEFT MV ************ 303 X-4623-409-3 ASSY HOU, BEZEL 14SA-Z 304 4-635-277-22 COVER SCREW LOWER 701 A-8048-965-A ASSY WEIGHT SAVER (Z) 303 305 4-635-276-22 COVER SCREW UPPER (Refer to Page 3-4.) 325 0702 1-476-342-41 ADAPTOR, AC 304 305 306 4-637-902-31 LATCH 703 A-8110-712-A BP71A SNT (U) ASSY (S) B8 307 A-8023-466-A ASSY LCD X
Summary of the content on the page No. 11
Ref.No. Part No. Description Ref.No. Part No. Description 3-3-A. LCD Section (FXA59 Model) – Made by SH – 401 1-476-316-11 INVERTER UNIT B8 4-641-726-11 SCREW (M2), SPECIAL HEAD 402 X-4623-380-1 HINGE LEFT 15 B22 4-642-761-01 +P M2X3 LOCK 403 X-4623-448-2 ASSY HOU, BEZEL 15SA-Z B23 4-644-165-01 SCREW (M2.6X4), 0 PLATE P1 MAIN 406 4-637-902-31 LATCH B30 4-643-550-01 +P 2.6X6 LOCK PRECISION TYPE3 407 A-8023-483-A ASSY LCD SXGA+ 15SH (S) 424 408 4-637-903-01 SPRING LATCH 426 424 B22 412 X-4624-622
Summary of the content on the page No. 12
Ref.No. Fig. Part No. Description 3-4. Connector Section (CH Type only) 901 1-779-745-21 [CH]...JACK, DC DC IN connector 902 9-885-018-97 [CH]...CONNECTOR (1.2MM), USB USB connector Bracket I/O 903 9-885-018-98 [CH]...CONNECTOR (1.6MM), USB 902 901 USB connector ∗ Among the parts that are used on the boards of this model, only the connectors that are show in the list can be replaced. (The parts other that the specified connectors cannot be replaced.) 903 ∗Before replacing the connector of refere
Summary of the content on the page No. 13
CHAPTER 4. OTHERS Fig. Part No. Description 4-1. Replacing the CPU 1. Removing the CPU J-2507-309-1 JIG FOR COU 3 5 2 1 6 4 1 Install the special tool in the CPU. 5 Remove the special tool. 2 Insert a flat head (-) screwdriver tip into the 6 The CPU can be removed upward. groove as shown. 3 While holding the special tool, slant the screwdriver in the direction of the arrow. 4 The base under the CPU moves slightly in the direction of the arrow and the CPU lock is released. 2. Installing the C
Summary of the content on the page No. 14
PCG-FXA53/FXA59 (AM) List of PCG-FX Series (As of July, 2002) Service Manual Model Name Part No. PCG-FX190 PCG-FX170 PCG-FX150 9-872-179-11 PCG-FX140 PCG-FX120 PCG-FX190K PCG-FX170K PCG-FX150K 9-872-194-11 PCG-FX140K PCG-FX120K PCG-FX290K 9-874-409-11 PCG-FX290 PCG-FX270K PCG-FX270 PCG-FX250K PCG-FX250 9-874-427-11 PCG-FX240K PCG-FX240 PCG-FX220K PCG-FX220 PCG-FX210 9-874-404-11 PCG-FX215 9-874-432-11 PCG-FX390 PCG-FX370 9-874-495-01 PCG-FX340 PCG-FXA36 PCG-FXA33 9-874-453-01 PCG-FXA32 PCG-FX410
Summary of the content on the page No. 15
Revision History Suffix Ver. Date Contents QM No. First -01 Ver. 1 2002.04.26 Edition -02 Ver. 2 2002.07.01 Front Page (Model Line Up), Page 3-8(a), Page 3-8(b), Back Cover N2002_064K < Remarks > [Confidential] PCG-FXA53/FXA59 (AM)
