American Standard Ravenna 2646 user manual

Summary of the content on the page No. 1

For These Two-Piece Toilets:
INSTALLATION
Ravenna 2642/2648/2646
INSTRUCTIONS
Cadet 2656/2798/2898/2998/3600
Reminiscence 2311/2011
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product
is installed properly, please read these instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAG

Summary of the content on the page No. 2

6 7a 7b For Tanks/Bowls using Speed For all other Tanks/Bowls Connect System (Tank mounting bolts pre-installed). RUBBER WASHER RUBBER RUBBER TANK MTG. TANK MTG. GASKET GASKET BOLTS PRE- BOLTS INSTALLED BOLT CAP CLOSET FLANGE WASHER WASHER NUT NUT CLOSET BOLT INSTALL TANK INSTALL TANK a. Install large rubber gasket over a. Install large rubber gasket over WASHER NUT threaded outlet on bottom of tank threaded outlet on bottom of tank and lower tank onto bowl so that and lower tank onto bo

Summary of the content on the page No. 3

10 11 ARM TOP REFILL TUBE NIPPLE ADJUSTMENTS a. Adjust water level. Water level TANK should be adjusted to level CRITICAL LEVEL LEVER MARK ("C.L.") Fig. 10A indicated on tank by adjusting float MUST BE 1" ABOVE "S" CLIP cup. OVERFLOW PIPE FLOAT CUP See Step 11 for water level FILL adjustment method VALVE FLUSH VALVE WATER LEVEL b. If bowl fails to siphon, an adjustment ADJUSTMENT CLIP may be required with the lift chain. LINK Simply remove the bead chain from VALVE the retainm

Summary of the content on the page No. 4

TROUBLESHOOTING 13 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 13. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: • The end of the refill tube is inserted into overflow pipe, below LIFT ARM LIFT ARM water level in tank. Attach refill tube to overflow pipe using "S" FIRST FIRST clip provided. • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper)