Summary of the content on the page No. 1
Residential Gateway
(RG) Battery Backup
REV B
Save this user manual
This manual contains important instructions regarding the
installation and operation of this device. Read this manual
thoroughly before attempting to install or operate this device.
BU3DC001-12V User Manual
Summary of the content on the page No. 2
Table of Contents Page Introduction ..................................................................................................... 3 Safety Information ..................................................................................... 3 System Requirements ............................................................................... 3 Package Contents .................................................................................... 4 Recycling ...............................
Summary of the content on the page No. 3
Introduction This Residential Gateway (RG) Battery Backup, once properly installed and used, SM has been designed to maintain your AT&T U-verse Voice service in the event of a short disruption to your commercial power service. Safety Information CAUTION Incorrect Internal battery battery connection voltage is 12V or replacement DC. creates risk of explosion. Risk of Energy Hazard, internal battery is 12VDC, 7.2 Ampere-hour. Before replacing Incorrect battery connection or replacement
Summary of the content on the page No. 4
Introduction Package Contents You should have received the following: 1 – RG Battery Backup unit (12V sealed lead-acid battery included inside unit ) Recycling UNIT CONTAINS SEALED LEAD-ACID BATTERY. UNIT SHOULD BE RECYCLED. Belkin International, Inc., advocates sound environmental management of used batteries. For battery replacement and recycling information, please call us at 866-539-5791, or visit our website at www.belkin.com/gatewaybattery. 4
Summary of the content on the page No. 5
Controls and Status Indicators Shown below are the controls and indicator lights on the RG Battery Backup. 1 P ower on/off Power on/off switch is located on the back panel. 1 Use this switch to turn the RG Battery Backup on/ off. The unit will not supply power to the AT&T SM U-verse Residential Gateway when power switch is in OFF position. 2 S tatus Indicators Three LED status lights are located on the front panel. 2 The status lights indicate specific conditions of the dev
Summary of the content on the page No. 6
Residential Gateway (RG) Battery Backup REV B Federal Communication Commission Interference Statement Subpart B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc
Summary of the content on the page No. 7
Audible and Visual Alarms The RG Battery Backup alarms to indicate certain events. Front-Panel Visual Audible Description Label Indicator Alarm On A/C Green LED None The RG Battery Backup is lights operating on A/C. Testing Green LED None The RG Battery Backup is conduct- Battery flashes ing a self-test. This procedure is normal and will occur when the self-test is manually initiated and periodically thereafter (see page 8). This procedure will last approximately 5 minutes. On Yellow LE
Summary of the content on the page No. 8
Installation NOTE: Before installation, please inspect the RG Battery Backup. Make sure that nothing inside the package is damaged. The RG Battery Backup must be installed near the Residential Gateway and be easily accessible. STEP 1: Connect to AC Utility Power Make sure that the power switch on the RG Battery Backup is in the OFF position. Plug the A/C cord on the RG Battery Backup directly into a wall outlet. Do not connect the RG Battery Backup into a power strip or surge protector. S
Summary of the content on the page No. 9
Operation Turning off the RG Battery Backup Turn switch to OFF position. The “On A/C” LED light should turn off. To Silence Audible Alarm Turn mute switch to ON (down) position. To Conduct a Self-Test Use the self-test to verify both the operation of the RG Battery Backup and the condition of the battery. Turn the mute switch ON and OFF (down and up), then ON and OFF (down and up) again within five seconds. The RG Battery Backup automatically conducts a self-test every 21 days. NOTE:
Summary of the content on the page No. 10
Battery Replacement Procedure To order a replacement battery or for recycling information call: 866-539-5791 or visit: www.belkin.com/gatewaybattery The RG Battery Backup is designed with an easy-access battery door. Replacement of the battery requires removing the battery door on the rear of the device. No tools are needed. STEP 1: Turn off power switch. Disconnect the RG Battery Backup from power and any connected devices. Remove the battery door on the rear of the RG Battery Backup b
Summary of the content on the page No. 11
Warranty LIMITED THREE (3) YEAR WARRANTY What this warranty covers. SM Belkin International, Inc. warrants to the original AT&T U-Verse subscriber of this Belkin Residential Gateway (RG) Battery Backup Unit (BBU), that the RG BBU shall be free of defects in design, assembly, material, or workmanship. What the period of coverage is. Belkin International, Inc. warrants the Belkin RG BBU for three (3) years from the original date of installation. What will we do to correct problems? RG BBU
Summary of the content on the page No. 12
Technical Specifications Technical Specifications: Input Voltage Range 0 to 140VAC Input Frequency 50/60Hz Nominal Output Voltage 12VDC Max Power 36W Alarms Visual and Audible Operating Temperature 32 to 113 degrees F (0 to 45 degrees C) Battery (@ 77 degrees F, 25 degrees C): Type/Rating 12V/7.2Ah sealed lead-acid battery Replacement Battery F6c127xBAT Part Number Typical Battery Recharge Time 18 hours for a new and fully depleted
