Avery MONARCH 9465 user manual

Summary of the content on the page No. 1

OPERATING INSTRUCTIONS
The Monarch® 9465™ Four-Station Battery Charger
charges from one to four 7.4V lithium-ion batteries for the
following printers:
♦ Sierra Sport2™ 9460™
♦ Sierra Sport3™ 9433™
♦ Monarch® Pathfinder® Ultra® Silver 6032™
♦ Monarch® Pathfinder® Ultra® Gold 6037™
♦ Monarch® Pathfinder® Ultra® Platinum 6039™
Note: You must charge a battery before using it.
WARNINGS
♦ Use only a Monarch-qualified battery.
♦ The battery could be damaged or explode if placed on
a diff

Summary of the content on the page No. 2

Connecting the Power Supply To connect the power supply: 1. Plug one end of the power supply into a wall electrical outlet. 2. Plug the other end of the power supply into the back of the charger. The Power LED is on when the charger is set up and plugged in. 2 Operating Instructions

Summary of the content on the page No. 3

Charging a Battery To charge a battery, insert the battery into the charger as shown. Charging time can take up to three hours. It takes approximately two hours to reach the 80% level (where it is now usable). To reach 100%, it takes approximately one hour more. Reading the Display Once the charger is plugged into an electrical outlet, the Power LED is on (solid). There are four charging stations and each has its own set of LEDs. Charging LED – flashes when you insert the batte

Summary of the content on the page No. 4

Troubleshooting When an error occurs, the Charging and Complete LEDs blink together. In this case, repeat the charging process. If the error still occurs, repeat the process with a new battery. If there is a problem after the second repeat charge, call Service. In between charges, remove the battery, wait for the lights to stop flashing, then re-insert the battery. Specifications Operating Limits: Temperature 32°F to 104°F (0°C to 40°C) Humidity 5% to 90% non-condensing Storage L