The Swan Corporation BS-2515 user manual

Summary of the content on the page No. 1

BAR SINKS
BS-1515
TOOLS REQUIRED
• Ruler
• Drill
• Caulk
• Saber Saw
(if counter top
cutout is required)
BS-2515
TRACE COMPLETELY DRAW A 1-1/2 RADIUS DRILL STARTER HOLE CUT INSIDE OF LINE
AROUND EDGE OF SINK AT EACH CORNER INSIDE OF CUTOUT LINE
5/16

CUTOUT LINE
1. If it is necessary to cut out 2. Measure in 5/16
from the 3. Drill starter hole inside of 4. Using a saber saw, cut
inside of cutout line. Trial fit
the counter top, invert sink initial sink outline and draw a cutout line.
sink to c

Summary of the content on the page No. 2

BAR SINKS 8. Connect all faucet supply APPLY CAULK lines, disposal (if available), and drain trap fittings per manufacturer instructions. CHECK FOR LEAKS • Supply user tubes to faucet • Supply riser tubes to shut off valves or lower connections • Fill sink with water and check for leaks around drain • Release water from sink and check for possible leaks • Tighten as needed 5. Fixture hole locations are 6. Apply a bead of caulk (not 7. Attach four (4) sink clips to identified with a gray label in