Panasonic WV-Q151C user manual

Summary of the content on the page No. 1

Ceiling Mount Bracket
Operating Instructions
Model Nos. WV-Q151C/WV-Q151S
Before attempting to connect or operate this product,
please read these instructions carefully and save this manual for future use.
No model number suffix is shown in this manual.

Summary of the content on the page No. 2

• Select an installation area that can support the total weight. CONTENTS If a selected area is too weak to support the total weight, a fall of the product may occur resulting in injury. Installation work shall be started after sufficient reinforcement. Preface ....................................................................................................................................... 2 • Periodic inspections shall be conducted. Precautions .............................................

Summary of the content on the page No. 3

Major Operating Controls and Their Functions Installations Be sure to read "Precautions" on the page xx before installation. The Installation Guide of the network camera, WV-NS202, shall be read as well. Mounting base 1. Remove the decorative cover. Camera mounting q Loosen the fixing screw (unremov- plate able) to be used for cover fall pre- Fixing screw to be used for cover fall prevention vention. Hole for microphone cable Microphone stand* Decorative cover Fixing screw to be used for cover f

Summary of the content on the page No. 4

3. Put Template A (accessory) against the 5. Mount the safety wire angle (accessory) on the 2nd anchor bolt and connect the safe- ø12 mm {1/2"} Ceiling face ceiling and make a hole. (4 positions) ty wire (accessory) to the angle. Upper side q Make 4 holes of 12 mm {1/2"} in diam- q Disconnect the safety wire from the ø160 mm Anchor bolt {6-5/16"} Mark w eter. safety wire angle. w Remove the center part from the tem- w Engage the face marked q with the plate. anchor bolt. w Insert e Bend q Discon

Summary of the content on the page No. 5

FRONT 7. Insert the mounting base into the hole 10. Install the inner shell. Inner shell made in Step 1. Slide the covers located on the both lat- eral sides of the camera and put the inner shell on the camera until the hooks inside the inner shell are held in the holes of the camera (until a click is heard). Important: Put the inner shell down on Cover the camera until the outside cover of Hook the camera cannot be seen from the Put on until a click is opening (from which the camera heard lens

Summary of the content on the page No. 6

LOC LOCK K LOCK LOCK FRONT F FR RO ON NT T FRONT FRONT F FR RO ON NT T FRONT 11. Mount the camera on the camera 14. Mount the camera mounting plate on Camera fixing mounting plate. the mounting base. screw q Put the camera onto the camera q Align the marks (A to A and B to mounting plate with aligning the lock B) between the camera mounting plate of the camera with the guide of plate and mounting base. the camera mounting plate and w Mount the camera mounting plate on Align A with A Rotating por

Summary of the content on the page No. 7

Specifications Ambient temperature: –10 °C- + 50 °C {14 °F - 122 °F} Dimensions: 185 mm {7-5/16"} in diameter x 145 mm {6-7/16"} in height Weight: Approx. 800 g {1.77 lbs.} Finish: Main body: Treatment steel Decorative cover: ABS resin with silver metallic coating Dome cover: Acrylic resin Standard Accessories Operating Instructions (this book) ............................. 1 pc. The following are for installation Safety wire ................................................................. 1 p