Atlas Guardian Pro MLGC240W user manual

Summary of the content on the page No. 1

OPERATION
Mode: On-Time: Works: Day Night
Test 5 Seconds x x
Auto 1, 5, 20 min. x
Manual Until Dawn* x
™
GUARDIAN PRO
Accent 3, 6 Hr, to Dawn x
240 SERIES
* resets to Auto Mode at dawn.
1
Note: When first turned on wait about 1 /2 minutes for
Models MLGC240B
the circuitry to calibrate.
MLGC240W
TEST
Put ON-TIME switch on the sensor bottom to TEST
Features
and the Dual Light Level switch OFF.
• Turns on lighting when motion is detected.
ON-TIME DUAL LIGHT LEVEL
• Automatically turns lighting off.

Summary of the content on the page No. 2

Black to Black Mounting INSTALLATION White to White Strap For easy installation, select an existing light with a wall switch for replacement. 1234567890123456789 Rubber 1 23456789012345678 9 1234567890123456789 Plug Mounting Bolt Wall Mount Eave Mount For under eave installation, the sensor head must Gasket be rotated as shown in the next two steps for proper Junction box ground wire to operation and to avoid the risk of electrical shock. green ground screw on fixture. For eave mount only: ❒ Swi

Summary of the content on the page No. 3

T S O O B ❒ Loosen the clamp screw in Clamp TEST AND ADJUSTMENT the sensor ball joint and gen- Screw tly rotate the sensor. ❒ Turn on the circuit breaker and light switch. ❒ Walk through the coverage Ball 1 NOTE: Sensor has about 1 / minutes warm up 2 area noting where you are Joint period before it will detect motion. When first when the lights turn on. Move 1 turned on, wait about 1 / minutes. 2 the sensor head up, down, or sideways to change the cov- ❒ Turn the RANGE control to the mid positi

Summary of the content on the page No. 4

TROUBLESHOOTING GUIDE If you experience a problem with your Light Control, first follow this guide. For additional assistance write to: Atlas Lighting Products, Inc. • Customer Service Department • P.O. Box 2348 • Burlington, NC 27216 SYMPTOM POSSIBLE CAUSE SYMPTOM POSSIBLE CAUSE Lights will not 1. Light switch is turned off. Lights stay on 1. A flood lamp is positioned too close come on. 2.Flood light is loose or continuously. to the sensor or pointed at nearby burned out. objects that cause h