American Standard Townsquare 2555.400 user manual

Summary of the content on the page No. 1

Installation
Instructions
TOWN SQUARE
2555.400
BIDET FITTINGwith EverClean™ Finish
Congratulations on purchasing your American Standard faucet
with EverClean finish found only on American Standard faucets.
EverClean Finish
• One wipe effortlessly removes spots
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful
Certified to comply with ASME A112.18.1M
for the life of the faucet
U.S. Patent No. 5,819,789
• EverClean™ available on: Polished Chro

Summary of the content on the page No. 2

SPRAY INSTALLATION 2 9 Assemble SPRAY BODY (1) to BIDET. 8 Using putty, seal underside of SPRAY PUTTY 7 BODY FLANGE (2) and secure with 1 NUT (3). 6 Thread SPRAY HOSE (4) with SEAL 3 WASHER (5) to SPRAY BODY (1). Connect other end of HOSE (4) with SEAL WASHER (6) to bottom outlet 5 NIPPLE (7) of the TRANSFER VALVE (8). 4 Thread SPRAY CAP (9) onto SPRAY BODY (1). LIFT ROD GUIDE INSTALLATION Unscrew LIFT ROD NUT (1) from LIFT ROD GUIDE (2). 2 Make sure SEAL (3) is seated into ESCUTCHEON of LIFT

Summary of the content on the page No. 3

FINISH DRAIN INSTALLATION 2 Position BIDET fixture and secure to floor. 1 Insert lift rod into lift rod guide. 3 Position EXTENSION ROD (1) onto POP-UP ROD (2) and tighten THUMBSCREW (3). 1 7 Remove one end of CLIP (4) from PIVOT ROD (7) by squeezing ends together while sliding. Insert PIVOT ROD (7) into second or third hole in EXTENSION ROD (1) and reassemble CLIP (4). (EXTENSION ROD (1) may need to be bent.) 5 Adjust STOPPER height by repositioning EXTENSION ROD (1) on POP-UP 4 ROD (2) and tigh

Summary of the content on the page No. 4

TEST INSTALLED FITTING With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks. Operate both handles to flush water lines thoroughly. 3 Turn diverter to rim wash and bidet spray. Operate Lift Rod (3) and fill Bidet with water. Check that DRAIN STOPPER (4) makes a good seal and retains water in Bidet. Adjust stopper height by repositioning Lift Rod (3) with EXTENSION ROD (6) and tightening Thumbscrew (5). Release DRAIN STOPPER (4) and check all drain co

Summary of the content on the page No. 5

Summary of the content on the page No. 6

Summary of the content on the page No. 7

Summary of the content on the page No. 8