American Standard Retrospect Washstand 9422.020 user manual

Summary of the content on the page No. 1

ASSEMBLY & INSTALLATION
INSTRUCTIONS
RETROSPECT WASHSTAND
9422.020
Thank you for selecting our products...products which have been the benchmarks of fine quality for over 100 years.
To help insure that the installation process will proceed smoothly, please read these instructions carefully before you
begin. Also, review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.
0282.008 RETROSPECT WASHSTAND TOP
Recommended Tools & Materials
9420.020

Summary of the content on the page No. 2

Front 1 Back WASHSTAND ASSEMBLY Thread the two legs with tapered upper ends into the threaded holes at the front of the cabinet. Thread the remaining legs into the two holes at the rear of the cabinet. Hand-tighten each of the four legs. 2 C/L of 2 x 8 SINK AND WASHSTAND INSTALLATION Support Note: If replacing an existing sink be certain to shut and Bracket off water supply before removing old sink. If installing 29" in a new bathroom follow rough-in diagram to locate rough supply, wast

Summary of the content on the page No. 3

5 Connect the trap to drain assembly hand tight to check alignment. It may be necessary to cut off part of the tailpiece (area "B") or part of the horizontal leg of the trap (area "C"). C Connect hot and cold supply lines between the fitting valve and the supply B shut-off valves. Tighten trap joints for watertight assembly. Apply a bead of caulk around the back edge of the sink where it contacts the wall. CARE INSTRUCTIONS: Rinse the product clean with clear water. Dry with a soft cotto