Summary of the content on the page No. 1
SU-32HX1
TV STAND/SOPORTE DEL TELEVISOR/
MEUBLE DE TÉLÉVISION
INSTRUCTIONS
The SU-32HX1 TV stand is designed for use only with Sony 32-inch TV
set listed to the right.
SU-32HX1:
INSTRUCCIONES
Este soporte del televisor SU-32HX1 ha sido diseñado para ser usado
KV-32HS420
solamente con el televisor Sony de 82 cm (32 pulg.) notado a la
derecha.
INSTRUCTIONS
Le meuble de télévision SU-32HX1 est conçu pour être utilisé avec un
téléviseur Sony de 82 cm (32 pouces) indiqué à droite.
ASSEMBLED STAND
Summary of the content on the page No. 2
PARTS LIST MODEL : SU-32HX1 LISTA DE PARTES MODELO : SU-32HX1 LISTE DES PIÈCES MODÈLE : SU-32HX1 FRONT PILLAR (LEFT) FRONT PILLAR (RIGHT) Item Description Qty. Part No. PILAR FRONTAL (IZQUIERDO) PILAR FRONTAL (DERECHO) Artículo Descripción Cant. Nro. de parte Réf. Description Qté. N° de pièce PILIER AVANT (GAUCHE) PILIER AVANT (DROIT) Top board 1 Repisa superior 1 XW3728 Panneau supérieur Base board Repisa inferior 2 1 XW3727 Panneau inférieur Rear column Columna trasera 3 1 P0307 Colonne arriè
Summary of the content on the page No. 3
NOTES ON ASSEMBLY REPLACEMENT PARTS INFORMATION (TV stand parts only) You will need a medium size Phillips head screwdriver. Assemble the stand only by the method shown in this Review parts list before assembly. instruction sheet. Please examine all packing material before discarding. Assemble the stand near the location where the stand will be used. If any parts are missing or damaged, identify and refer to The circled letters in the illustrations are the same as those in the “PAR
Summary of the content on the page No. 4
FRONT PILLARS 5 6 2 PILAR FRONTAL 5 6 Fig. 2 PILIER AVANT 5 6 Correct orientation of front pillar (right) displays text on top surface of pillar as shown. Cuando el pilar frontal (derecho) esté orientado correctamente, el texto queda en la superficie superior del pilar, tal como se muestra. 3 Le texte en haut du pilier avant droit est visible quand l’orientation est correcte, comme 5 montré. 2 6 Fig. 1 6 Correct orientation of front pillar (left) displays text on top surface of pilla
Summary of the content on the page No. 5
NOTE / NOTA / NOTE PLEASE DECIDE SHELF POSITION ON EITHER STEP POSITION 1 OR POSITION 2 BASED ON COMPONENTS TO BE INSTALLED. (REFER TO PAGE 14 OF THIS MANUAL). FAVOR DE DECIDIR LA ALTURA DE LA REPISA YA SEA AL PASO POSITION 1 O POSITION 2 DEPENDIENDO DE LOS COMPONENTES QUE SE INSTALARAN. (REFIERASE A LA PAGINA 14 DE ESTE MANUAL). CHOISIR UNE POSITION D’ETAGERE A L’ETAPE POSITION 1 OU POSITION 2 , EN FONCTION DES ELEMENTS A INSTALLER. (PAGE 14 DE CE MANUEL). STEEL BRIDGE F 4 PUENT
Summary of the content on the page No. 6
WHAT YOU NEED HERE LO QUE NECESITA AQUI CE QU’IL FAUT ICI 1 5 G X 2 F 2 ACTUAL SIZE TAMAÑO REAL ÉCHELLE GRANDEUR G x 2 6 2 Insert screw G x 2 from back and tighten 1 as shown. Inserte el tornillo G x 2 desde la parte de Lower steel bridge F onto platforms as shown. atras y apriete con Baje el puente metálico F a los plataformas un desarmador. como muestra la fi gura. Introduisez les vis G x 2 partir de l’arrière et serrez comme indiqu. Abaissez le pont métallique F sur l
Summary of the content on the page No. 7
CAUTION / PRECAUCION / ATTENTION PLEASE INSTALL GLASS SHELF AFTER THE STAND IS SET AT THE FINAL LOCATION. REMOVE GLASS SHELF PRIOR TO MOVING THE STAND. This glass shelf is made of tempered glass. Although it is more shock resistant than ordinary glass, tempered glass may shatter if it is not used properly. • Do not give the glass a sudden shock. • Do not scratch or hit the glass. WARNING LABEL • Do not sit on the glass or use it as a step. • Do not put e
Summary of the content on the page No. 8
NOTE / NOTA / NOTE PLEASE CHOOSE EITHER LOCATION BASED ON SHELF POSITION ON STEP 4 . POR FAVOR ESCOJA LA LOCACIÓN DEPENDIENDO DE LA POSICION DE LA REPISA EN EL PASO 4 . EN CAS DE SELECTION DE LA POSITION 1 D’ETAGERE, ETAPE 4-A , ALLER A L’ETAPE 6-A . EN CAS DE SELECTION DE LA POSITION 2 D’ETAGERE, ETAPE 4-B , ALLER A L’ETAPE 6-B . GLASS SHELF 7 5 REPISA DE VIDRIO 7 ÉTAGÈRE EN VERRE 7 POSITION 1 POSICION 1 WHAT YOU NEED HERE POSITION 1 LO QUE NECESITA AQUI CE QU’IL FAUT ICI 1 5 C
Summary of the content on the page No. 9
FOR UPPER GLASS SHELF ASSEMBLY POSITION 1 PARA ENSAMBLAR EL DE LA REPISA POSICION 1 POSICION SUPERIOR POUR L’ÉTAGÈRE EN VERRE POSITION 1 SUPÉRIEURE POSITION 1 (pre-installed) POSICION 1 (pre-instalada) I (pré-installée) POSITION 1 3 J x 2 (pre-installed) (pre-instalada) (pré-installée) 7 POSITION 2 FOR LOWER GLASS SHELF ASSEMBLY POSICION 2 PARA ENSAMBLAR EL DE LA REPISA POSICION INFERIOR POSITION 2 POUR L’ÉTAGÈRE EN VERRE INFÉRIEURE (pre-installed) (pre-instalada) I POSITION 2 (pré-install
Summary of the content on the page No. 10
HOLE COVERS 6 HOLE COVERS HOLE COVERS 1 WHAT YOU NEED HERE 5 LO QUE NECESITA AQUI CE QU’IL FAUT ICI 7 2 K x 4 6 ACTUAL SIZE TAMAÑO REAL ÉCHELLE GRANDEUR USE VINYL SEALS K TO COVER THE 4 HOLES NOT IN USE. KEEP REMAINING SEALS FOR FUTURE USE. K x 4 UTILIZE LOS SELLOS DE VINIL K PARA TAPAR LOS 4 HOYOS QUE NO SE UTILIZAN. 3 GUARDE LOS SELLOS SOBRANTES PARA SU USO EN EL FUTURO. VEUILLEZ APPOSER LES SCELLES EN VINYLE K POUR COUVRIR LES 4 TROUS NON UTILISES. GARDEZ LES 2 SCE
Summary of the content on the page No. 11
Carrying the TV / Transportando la TV / Transport de la TV This TV has two holding points (marked ) on each side. The TV is front heavy, please handle with care. Esta TV tiene dos puntos de apoyo (marcados ) en cada lado. El peso de la TV está en el frente, favor de manejarse con cuidado. Cette TV possède deux poignées de support (marque ) sur chaque côté. Cette TV est lourde sur l’avant, manipulé avec precaution s’il vous plait. INCORRECT CORRECT INCORRECTO CORRECTO DO NOT HOL
Summary of the content on the page No. 12
METAL SAFETY BAND 9 METAL SAFETY BAND NOTE: FOLLOWING STEP 9 WILL INCREASE THE STABILITY OF THE FINAL METAL SAFETY BAND TELEVISION/STAND UNIT. NOTA: EL SIGUIENTE PASO 9 INCREMENTARÁ LA ESTABILIDAD DEL CONJUNTO TELEVISOR/SOPORTE. NOTE: L’ÉTAPE 9 CI-DESSOUS AUGMENTE LA STABILITÉ DE L’ENSEMBLE WHAT YOU NEED HERE TÉLÉVISEUR ET MEUBLE. LO QUE NECESITA AQUI CE QU’IL FAUT ICI E ACTUAL SIZE TAMAÑO REAL ÉCHELLE GRANDEUR H 6 3 2 H 1 Attach the metal band H to the TV with the screw E .
Summary of the content on the page No. 13
REAR COVER 10 CUBIERTA TRASERA COUVERCLE DE COLONNE ARRIÈRE WHAT YOU NEED HERE LO QUE NECESITA AQUI CE QU’IL FAUT ICI E x 2 E x 2 ACTUAL SIZE TAMAÑO REAL ÉCHELLE GRANDEUR 3 4 3 4 Insert bottom 2 tabs first. Then swing top portion inwards. Inserte primero las 2 pestañas inferiores. Luego gire la parte superior hacia adentro. Introduisez les 2 pattes inférieures en premier et faites ensuite basculer la partie supérieure vers l’intérieur. 12 13
Summary of the content on the page No. 14
Unit : mm (inches) DIMENSIONS Unidad : mm (pulgadas) DIMENSIONES Unité : mm (pouces) DIMENSIONS 40 3 ( 15 7/8 ) FRONT VIEW 45 4.2 FRONT VIEW ( 1 7 7 /8) FRONT VIEW 66 3.2 ( 26 1/8 ) 8 98 ( 35 1 1/3 2) 9 54. 7 ( 3 7 1 9/3 2) Weight : Approx. 20.4 Kg (45 lbs.) Peso : Aprox. 20.4 Kg (45 lbs.) 564.7 Poids : Approx. 20.4 Kg (45 lbs.) ( 22 7/32) 402.8 ( 15 27/32) 153.5 ( 6 1/32) 1 SIDE VIEW 313.5 SIDE VIEW ( 12 1 1/32) 244.5 2 SIDE VIEW ( 9 5/8) 410 ( 16 5/32) 84.5 672.4 ( 3 5/16) ( 26 15/32) CARRYING
Summary of the content on the page No. 15
SU-32HX1 FOR RESIDENTS OF CANADA POUR LES RÉSIDENTS DU CANADA PARA RESIDENTES DE CANADÁ Please examine all packaging materials before discarding. If any parts are missing or damaged, please review the parts list found in the assembly manual, identify the missing or damaged part, and call the Sony customer service center at 1-877-779-9929. Inspecter tous les matériaux d’emballage avant de les jeter. Si des pièces sont absentes ou défectueuses, consulter la liste des pièces du manuel de monta
Summary of the content on the page No. 16
SU-32HX1 FOR RESIDENTS OF THE UNITED STATES PARA RESIDENTES DE LOS ESTADOS UNIDOS POUR LES RÉSIDENTS DES ÉTATS-UNIS TV Stand S LIMITED WARRANTY Sony Electronics Inc. (“Sony”) warrants this product against defects in material or workmanship, subject to any conditions set forth as follows: 1. This warranty is expressly limited to the replacement of Sony TV Stand parts and components. 2. For a period of 30 days from the date of purchase, Sony will supply parts that are determined to be defectiv
