Summary of the content on the page No. 1
TM
Soothing Dreams
Monitor
with Remote Control
Model Number: 71597
For proper set-up and use, please read these instructions.
Please keep this instruction sheet for future reference,
as it contains important information.
Transmitter is electrically powered.
Remote control receiver is powered by the AC adaptor (included, plugs
into standard household outlets 120V AC). Remote control receiver
also runs on battery power (9V alkaline battery - not included).
Requires one PR12 light bulb (included
Summary of the content on the page No. 2
2
Summary of the content on the page No. 3
IMPORTANT! CAUTION This product cannot replace responsible adult supervision. • This product is not intended to be used as a medical monitor and its use should not replace adult supervision. • Test sound reception of remote control receiver before first-time use and whenever you change location of transmitter. • To prevent entanglement: - Never place transmitter in a crib or playpen. Keep transmitter and remote control receiver out of baby’s reach. - Never use extension cords with the AC adapt
Summary of the content on the page No. 4
Remote Control Receiver Battery Installation (Optional) 9V (6LR61) SHOWN ACTUAL SIZE Battery Compartment Door • Locate battery compartment door on back of remote control receiver. • Loosen screw in battery compartment door with a Phillips screwdriver. Lift to remove battery compartment door. • Snap terminals of a fresh, 9V alkaline battery into remote control receiver connectors. • Replace battery compartment door and tighten screw. Do not over-tighten. Battery Tips • Remove the battery during
Summary of the content on the page No. 5
BUZZZZ Testing Sound Reception Test transmitter transmission and remote control receiver reception. Power/Volume Dial Power/Volume Power Dial Indicator Power Indicator Place remote control receiver in Place transmitter in room in which room in which you intend to use it. you intend to use it. Rotate transmit- Rotate power/volume dial to turn ter power/volume dial to turn power power on. Adjust remote control on. Turn on a radio. receiver location. • Variable light display lights when Adjust Ch
Summary of the content on the page No. 6
Setup & Use 8 2 3 1 7 1 4 6 5 Back View Transmitter Remote Control Transmitter Receiver 6
Summary of the content on the page No. 7
Setup & Use IMPORTANT! Test sound reception of this monitor before first time use and whenever you change location of transmitter (see page 5). Set transmitter channel switch to same channel as remote 1 control receiver. Place transmitter in same room with child. Point microphone 2 directly toward crib or play area. 3 Unwrap and fully extend power cord for best transmission. Insert power cord plug into wall outlet. 4 Rotate transmitter power/volume dial to turn power on. Power indicator lights
Summary of the content on the page No. 8
Setup & Use 9 11 10 8
Summary of the content on the page No. 9
Setup & Use Place remote control receiver where you will see or hear it. 9 Unwrap and fully extend AC adaptor cord for best reception. 10 Insert AC adaptor jack into remote control receiver socket and plug into wall outlet. Note: To use a 9V alkaline battery for power source, refer to “Remote Control Receiver Battery Installation” instructions on page 4. Rotate remote control receiver power/volume dial to turn 11 power on. Power indicator lights. Rotate power/volume dial to adjust volume. Note
Summary of the content on the page No. 10
Setup & Use Ceiling Light Night Light Ceiling Light Night Light Show with Music or Show with Music Nature Sounds or Nature Sounds • To soothe baby, press and hold soothing button (Soothe) on remote control receiver for about two seconds.Your baby enjoys what you have selected. • Light/music/nature sounds will turn off after approximately five minutes. To turn back on, simply press and hold soothing button (Soothe) on remote control receiver for about two seconds. IMPORTANT! It takes a few se
Summary of the content on the page No. 11
Setup & Use “Wah, Wah, Wah…” “Mommy is coming…” “Mommy is coming…” • To talk to baby, press talk button (Talk) and speak into microphone on remote control receiver. Release talk button (Talk) after you have finished talking. Hint: If light/music/nature sounds are playing when you press talk button (Talk), you will temporarily turn them off. Light/music/nature sounds turn back on after you are finished pressing talk button (Talk). 11
Summary of the content on the page No. 12
Replacing the Light Bulb (Glass Bulb) IMPORTANT! Should light bulb become non-functional, you are advised to remove and replace it. This should be carried out away from child’s sleep or play area. Light Bulb Compartment Door C 1 3 B A Reflector Lens • Loosen screws in light bulb • While pressing lens of reflector compartment door with a A B , lift it from light bulb Phillips screwdriver. compartment cover. • Lift to remove light bulb • Remove and properly discard compartment door. C light
Summary of the content on the page No. 13
Notch Light Bulb Compartment Door 4 6 Tab Groove • At an angle, fit reflector over • Fit light bulb compartment new light bulb. door into back of transmitter. Press light bulb compartment • Align notch in reflector with door to “snap” into place. tab in light bulb receptacle. • Tighten screws in light bulb • Push reflector lens slightly compartment door with and fit reflector edges Phillips screwdriver. Do not into grooves in light bulb over-tighten. compartment cover. 5 • Replace retainer
Summary of the content on the page No. 14
BUZZZZZ Problems & Solutions Circuit Breaker 5 “Ma, ma, ma. Da, da, da…” 3 4 “That doesn’t sound right. Maybe we should check the transmitter.” 6 2 1 14 BUZZZZZ BUZZZZ
Summary of the content on the page No. 15
Problems & Solutions PROBLEMS SOLUTIONS Transmitter power indicator Turn transmitter power on. 1 1 not lit. Power indicator lights. You hear static or buzzing from Make sure channel switches on 2 2 remote control receiver. both transmitter and remote control receiver are set to same channel. Transmitter power indicator Make sure light switch that 3 3 not lit. controls power flow to wall outlet is on. Transmitter power indicator Check transmitter power cord 4 4 not lit. plug-to-outlet connec
Summary of the content on the page No. 16
Problems & Solutions “That’s gotta “Did you read be coming from about…” next door…” PROBLEM You can hear conversations or sounds from other homes. 16
Summary of the content on the page No. 17
“Wah, Wah, Wah…” “That must be Susie next door…” “I better get off the phone, “Wah, Wah, “Wah, Wah, she’s up…” Wah…” Wah…” “Did you read about…” SOLUTION There is signal interference due to other nursery monitors on same channel or cordless telephone use. Change channel switches on both transmitter and remote control receiver to eliminate source of interference. Hints: - Do not use more than one transmitter and one receiver at same time in same household. - Always remember that you are using
Summary of the content on the page No. 18
STATIC Problems & Solutions “Uh-oh, maybe I should move closer to the house.” SOLUTION PROBLEM You hear static or buzzing because Move remote control receiver remote control receiver is out of closer to transmitter. range of transmitter. Note: Range varies depending on surrounding conditions such as noise levels, physical obstruc- tions and signal interference. Hint: If you cannot hear your child and all four dots do not light, your remote control receiver battery is weak. Replace remote control
Summary of the content on the page No. 19
Care Excess dirt in transmitter and remote control receiver microphone will hamper transmission of sound. Clean outer surface of transmitter and remote control receiver with a cloth lightly dampened with a mild cleaning solution. Never immerse transmitter, remote control receiver or AC adaptor. FCC Note (United States Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide re
Summary of the content on the page No. 20
One (1) Year Limited Warranty Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York 14052 warrants that the Soothing Dreams™ Monitor with Remote Control is free from all defects in material and workmanship when used under normal conditions for a period of one (1) year from the date of purchase. Should the product fail to perform prop- erly, we will repair or replace it at our option, free of charge. Purchaser is respon- sible for shipping the product to Consumer Relations at the address
