EverFocus COLOR DOME ED200E user manual

Summary of the content on the page No. 1

EVERFOCUS

Color Dome Camera
Operation Instructions



Model No. ED300E/200E




Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.

PRECAUTIONS

1. Do not have camera immersed in water.
2. Do not disassemble

Summary of the content on the page No. 2

PREFACE The ED200/300 color dome camera with vari-focal/fixed Lens Series are compact, CCD Color Cameras. Their stylish appearance can be applied as per installer's ideal locations on the ceiling. The dome camera design with advance digital processing circuitry for middle/high-resolution 1/3" color interlines transfer CCD sensor, it has DIP switch for FL ON/OFF, Mirror ON/OFF, AGC ON/OFF and D/N ON/OFF. The dome camera uses a fixed/vari-focal auto iris lens for discreet surveillance or

Summary of the content on the page No. 3

MAJOR PARTS NAMES AND FUNCTIONS 13 ○ 12 ○ 11 ○ 10 ○ 2

Summary of the content on the page No. 4

1 ○ Camera Cover This cover will protect the camera for avoiding dust and damage. 2 ○ Lens This vari-focal Lens allows users to adjust the Zoom and Focus manually. Built-in fixed lens: 3.6; 4.3; 6.0 or 8.0 mm 3 ○ Base The camera unit sets in the dome base, when it is shipping from the factory. 4 ○ Focus Ring (for vari-focal lens only) To set the focus, and loosen the Focus ring knob, please turn the ring toward or if necessary. 5 ○ Zoom Ring (for vari-focal lens only)

Summary of the content on the page No. 5

12 ○ Power input Please connect the connector of camera to 12VDC or 24VAC power source. 13 ○ Video Output BNC Connector Please connect to the BNC connector of Monitor video in. INSTALLATION 1. Remove the plastic dome cover. 2. Lossen the two screws of the supporting bracket to remove the camera body. 3. Use four screws to fix the camera base on the ceiling. 4. Put the camera body back to the supporting bracket, then tighten the two screws to fix the camera. 5. Connect the B

Summary of the content on the page No. 6

LENS ADJUSTMENT (For Vari-Focal Lens only) Zoom and focus adjustments After the camera is installed, the zoom and focus of the lens must to be adjusted. 1. Loosen the zoom ring knob, and turn the ring towards or if necessary. W side (Zoom out) The viewing range will be wider and the target is smaller. T side (Zoom in) The viewing range will be smaller and the target is larger. 2. Loosen the focus ring knob, and turn the ring towards or if necessary.

Summary of the content on the page No. 7

ADJUSTMENT FL (Flickerless) When picture flicker fiercely, turn FL on, then the camera will stabilize the speed of electronic shutter at 1/100(S)(NTSC) or 1/120(S)(PAL) automatically, and reduce the flicker immediately. The default setting is OFF. Mirror Mirror ON: Set a horizontal image inversion. Mirror OFF: Disable the inversion. Auto Gain Control Adjustment AGC ON: The sensitivity increases automatically when the light is low. AGC OFF: A-low-noise picture is obtained

Summary of the content on the page No. 8

SPECIFICATIONS Type ED200E ED300E Pickup Device 1/3'' SONY Super HAD CCD Video Format NTSC or PAL NTSC: 525 TV lines, 60 fields/sec Scanning System PAL: 625 TV lines, 50 fields/sec. NTSC: 510(H) x 492(V); NTSC: 768(H) x 494(V); Picture Elements PAL: 752(H) x 582(V) PAL: 500(H) x 582(V) Horizontal Resolution 380 TV Lines 520 TV Lines Sensitivity 0.3 Lux/F=1.2 0.4 Lux/F=1.2 S/N Ratio Over 48dB (AGC off) Electronic Shutter 1/50(1/60)~1/100,000 Vari-focal lens, Vari-focal lens, Aut

Summary of the content on the page No. 9

EverFocus Electronics Corp. Head Office: Europe Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Albert-Einstein-Strasse 1 Hsi-Chih, Taipei, Taiwan D-46446 Emmerich, Germany TEL: +886-2-26982334 TEL: 49-2822-9394-0 FAX: +886-2-26982380 www.everfocus.de www.everfocus.com.tw China Office: Room B-05D-1, KESHI PLAZA , Shangdi USA L.A. Office: Information Industry Base, 1801 Highland Ave. Unit A Haidian District, Beijing China Duarte, CA 91010, U.S.A. 100085 TEL: +1-626-844-