SECO-LARM USA ENFORCER Wireless RF Request-to-Exit Buttons SD-8103GT-PEQ user manual

Summary of the content on the page No. 1

MANUAL

SD-8202GT-PEQ
SD-8103GT-PEQ


Wireless Request-to-Exit Plates




SD-8202GT-PEQ SD-8103GT-PEQ







NOTE: Products with a model number that ends with “Q” or have a round green “Q” sticker represent RoHs compliant products.

Summary of the content on the page No. 2

ENFORCER Wireless Request-to-Exit Plates Introduction: The ENFORCER Wireless RF Request-to-Exit Buttons are the ideal solution for difficult Access Contr ol installations. The RTE plates com bine the very best of SECO-LARM, flexible wireless solutions and reliable access control. The RTE plates are perfect for cement or brick walls, or any other location where it is difficult to run wires. Features: Built-in RF transmitter: Available in 2 different button configurations: - Powered

Summary of the content on the page No. 3

ENFORCER Wireless Request-to-Exit Plates Installation: 1. Find a suitable location for the wireless request-to-exit plate. NOTE: Do not house the plate in a metal box, this will greatly reduce the range. 2. The wireless request-to-exit plate can be either surface mounted or flush mounted. 3. Test the operation of the wireless request-to-exit plate in the location where it will be installed. NOTE: The wireless request-to-exit plate first needs to programmed into the SK-910R receive

Summary of the content on the page No. 4

ENFORCER Wireless Request-to-Exit Plates Troubleshooting: LED is red 9V battery is low, replace with new one LED does not light Check battery connection Replace 9V battery LED lights blue, but does not Check to make sure wireless request-to-exit plate is not activate lock housed in a metal box Test wireless request-to-exit plate closer to the receiver Clear codes from receiver, and re-learn wireless plate transmitter code Also Available from SECO-LARM: Desktop