Pelco E708-24P user manual

Summary of the content on the page No. 1

C415M-J (11/99)
E700 Series
Dust-Tight Enclosure
®
3500 Pelco Way, IMPORTANT SAFEGUARDS AND WARNINGS
Clovis, CA 93612-5699
Prior to installation and use of this product, the following WARNINGS should be observed.
USA
1. Installation and servicing should only be done by qualified service personnel and conform
In North America & Canada:
to all local codes.
Tel (800) 289-9100
FAX (800) 289-9150
2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X ,6 or 6P enclo-
International C

Summary of the content on the page No. 2

INSTALLATION Camera and Lens To install the camera and lens, perform the following steps: 1. Unsnap the two latches holding the rear end plate on the enclosure and slide the camera sled out. 2. Place the camera and lens at the maximum forward position on the sled. Adjust the camera and lens so that they do not extend beyond the track. Attach camera and lens with the 1/4-20 x .500-inch, hex head screws provided. a. An enclosure with a heater, a camera with a low optical centerline, or a camera us

Summary of the content on the page No. 3

BACK COVER CAMERA SLED GLAND FRONT COVER (WINDOW & RING) LATCH LATCH Figure 1. Enclosure Assembly Enclosures with Purge Fittings CAUTION: Do not Purge fittings create internal positive pressure, keeping external contaminants from entering the enclosure. Proper installation requires a filtered compressed air supply up to 35 psi at 10 restrict exhaust out- cfm. A refrigerated air supply will provide additional cooling for the enclosure. Models with let. Pressure may purge fittings come equipped w

Summary of the content on the page No. 4

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or If a warranty repair is required, the Dealer must contact Pelco at (800) 289-9100 or workmanship for a period of one year after the date of shipment. (559) 292-1981 to obtain a Repair Authorization number (RA), and provide the following information: Exceptions to this warranty are as noted below: 1. Model and serial number 2. Date of shipment, P.O. number