Bosch Appliances LTC9316 user manual

Summary of the content on the page No. 1

LTC9316/00P
Security Systems
Installation Manual
Standard Pole
EN

Summary of the content on the page No. 2

LTC9316/00P Instruction Manual Introduction EN 2 Table of Contents 1 DESCRIPTION 2 2 UNPACKING 2 3 SERVICE 2 4 4 INSTALLATION 3 4.1 Site Preparation 3 4.2. Installation 3 4.3 Mounting the AutoDome™ 4 4 INSTALLATION 1 DESCRIPTION This installation should be made by qualifi ed service personnel and The LTC 9316/00P units are 16 foot steel mounting poles for conform to the National Electrical Code and applicable local codes. use with Unity® Domes, AutoDomes®, an

Summary of the content on the page No. 3

LTC9316/00P Instruction Manual Installation 3 EN 7.778 24" 6" 4X O 1.000 BASED ON A 11.00" B.C. 6" 36" 13.0007.778 4.000 32" 24" 24" O 11.000 4.000 O 3.000 13.000 24" 32" Figure 3 Anchor Bolt Dimensions 36" PV4 Anchor jig (if applicable) NOTE: Prepare the concrete per manufacturer's directions. The concrete must have a compressive ! 8" 8" strength of 3000 psi, and must be fabricated following ACI318-89 requirements. Allow the concrete foundation to cure thoroughly before proceeding with 1

Summary of the content on the page No. 4

LTC9316/00P Instruction Manual Installation 4 EN Access opening plates Bolts or anchor jig Figure 7 Lifting the Pole into Position CAUTION: Pull all slack in the wiring as you lift the pole into position to keep from pinching and possible damage. Pad Figure 5 Placement of Pole on Pad 6. Ensure that the pole is vertical on all sides. Use a bubble level or plumb bob to check. 3. Insert the wiring into the 3" diameter hole in the base of the pole. Be

Summary of the content on the page No. 5

Mount the LTC 9540/xx Wall Bracket Using Adapter Plate These Holes Figure 9 Aligning Adapter Plate with Mounting Plate Figure 11 Mounting the LTC 9540/xx Wall Bracket 5 SPARE PARTS 2. Attach the LTC 9540/xx Wall Bracket adapter plate, using the provided hex head nuts and bolts, flat washers, and Part No. Description lockwashers (see Figure 10). LTC9316AP LTC 9540/xx Wall Arm Adapter Plate Lockwashers Flat Washers 5/16-18 Nuts Figure 10 Attaching the Adapter Plate 3. Attach the LTC 9

Summary of the content on the page No. 6

Bosch Security Systems, Inc. Robert Bosch GmbH Bosch Security Systems B.V. 850 Greenfield Road Geschäftsbereich P.O. Box 80002 Lancaster, PA 17601 EE.UU. Postfach 10 60 50 5600 JB Eindhoven Tel: 800-326-3270 70049 Stuttgart The Netherlands Fax: 1-717-735-6560 Telefax (0711) 811-12 34 Tele +31 40 27 80000 www.boschsecuritysystems.com © 2005 Bosch Security Systems GmbH 3935 890 38012 28 June Data subject to change without notice.