Summary of the content on the page No. 1
Powered by
AT&T Remote Monitor
STARTER KIT
USER’S MANUAL ///
Summary of the content on the page No. 2
INTRODUCTION TO YOUR HARDWARE INSTALLATION: REMOTE MONITORING STARTER KIT /// Thank you for your purchase of the Remote Monitoring Starter Kit. The XG1000 Controller, a small FOLLOW THE STEPS BELOW SET UP YOUR BASIC REMOTE MONITORING STARTER KIT: dedicated computer, allows you to access and control cameras and other devices in your home, 1. Take the XG1000 Controller AC Power Supply from your Controller box. and make this information available to you wherever you are. You can access the XG100
Summary of the content on the page No. 3
4. Plug the small end of the AC Power Supply into your IPC-1000 IP Camera FOLLOW THE STEPS BELOW SET UP YOUR ENHANNCED REMOTE MONITORING STARTER KIT: AC Adapter port and the other end into an AC electrical outlet. 1. Take the XG1000 Controller AC Power Supply from your Controller box. Plug the small end into the port marked Power on your XG1000 Controller and plug the other end into an AC electrical outlet. Example of completed configurations can be found below. 2. Connect supplied Ethernet
Summary of the content on the page No. 4
4. Bring your IP Camera, AC Power Supply, HomePlug Turbo PLC Ethernet Adapter, CONTROLLER REGISTRATION: and Ethernet Cable to the location in your home that you wish to install your IP Camera. 1. When you purchased your Remote Monitoring system, you created a remote account with a UserID and Password. Using a web browser on a PC connected to the same local Connect one end of the Ethernet Cable to the LAN port of the IP Camera and connect network as your XG1000 Controller, go to site http:/
Summary of the content on the page No. 5
USING THE SYSTEM WITH A CORPORATE FIREWALL /// 4. When the controller registration has completed, you will see a confirmation message as If you are using the Remote Monitoring system in an environment that is protected by a corporate in the following picture. After you successfully register your controller you may be prompted to firewall, you may need to make some settings that will allow you to get the best performance out follow instructions in order to improve performance of your system
Summary of the content on the page No. 6
LIVE VIDEO /// OPTIMIZING YOUR VIDEO PERFORMANCE: For each discovered camera you will see a Snapshot of the view associated with the camera when To ensure that your video performance is optimized you click on the ‘LIVE VIDEO’ tab. This snapshot image is for identifying the camera; it is not updated you can port forward your router. To do so, please in real time. The snapshot view for each camera can be refreshed by clicking the ‘REFRESH’ button in repeat the controller registration process (ref
Summary of the content on the page No. 7
XG1000 CONTROLLER /// BOOT SEQUENCE When the controller is first powered up, the bottom five LED’s on the front panel go INDICATORS: through a boot-up sequence. The lights start out as Red, go to Amber and then Green. There are ten indicators on the front of the controller. The process takes about three minutes. REAR PANEL: The rear panel of the controller contains the ports for cable connections. The bottom round port POWER INDICATOR is for the power. The AC adapter is plugged into this port
Summary of the content on the page No. 8
MOBILE OPTION: You can access the system from just about anywhere with a web-enabled cell phone. Just use your phone’s web browser to download and install the application from http://xanboo.com/mobile/j2me (with a JAVA enabled phone) or from http://xanboo.com/mobile (if your phone is not JAVA enabled) and enter your Remote Monitoring User ID and Password when prompted. Data rates will apply, so you may want to consider subscribing to a data package. I3 I4
Summary of the content on the page No. 9
