ASA Electronics AOS-33 user manual

Summary of the content on the page No. 1

Summary of the content on the page No. 2

AOS-33 OPERA TIONS MANUAL IMPORTANT: The VOYAGER Observation System (AOS-33) has been designed to provide years of trouble-free operation Please read this manual thoroughly. This manual contains instructions to ease installation of the camera and monitor. The VOYAGER Observation System is a supple1nentto standard rearview mirror systems, anlj will provide additional rearview visiun wherl installed and maintained properly. The VOYAGER Observation system is not intended in any way to be a substitu

Summary of the content on the page No. 3

AOS.33 Operations Manual BEFORE IN5TALLATtON: 1. This system operates from 10 volts DC to 38 volts DC, negative ground 2. Please install this system according to the instructions in this manual. 3. Do not disassemble the camera or the monitor. This voids the warranty Disassembling the camera Will compromise the waterproof sea! 4. Connect the system to an ignition switched power source. Connection to a battery source will reduce battery life **WARNING** , .It) pTeve"1 e\~t:.1f\C'd\ "'\)t)C". DO N

Summary of the content on the page No. 4

AOS.33 Operations Manual MAINTENANCE: Remove dust and dirt with 'd damp ~oft cloth. Heav;er dirt should be removed with a damp soft cloth and mild deteT9~f)t. Do not use strong cleaning agents containing gasoline, thinner. benzene or alcohol. These substances may damage the exterior surface of the monitor. **CAUTION** , Before drining, be sure no cable or wiring is on the other side. Be sure to dril1 a '6mm l'518l diame\er'110)e on)y 2 Feed as much cable as possible into vehicle and clamp secur~

Summary of the content on the page No. 5

AOS-33 Operations Manual FUNCTIONS Rear of Monitor'AND OPERATION, CONTINUED 1 Power connection' 1 not used 2 Ground -black wire 3 Reverse circuit -blue wire 4 not used 5 not used 6 i-12VDC ignition -red wire 2, Camera A input connection to camera extension cable 3, Camera B input connection to additional camera extension cable 4 External speaker connection center pin is positive audio output. Used to disable the internal speaker and remotely mount a speaker for driver convenience CAMERA COMPONE

Summary of the content on the page No. 6

Summary of the content on the page No. 7

APPROXIMATELY 90 DEGREE FIELD OF VIEW BACK OF VEHICLE, VIEWING A T MONITOR SCREEN FIGURE 2 -Page 6 of 14 -

Summary of the content on the page No. 8

Summary of the content on the page No. 9

Summary of the content on the page No. 10

Summary of the content on the page No. 11

"" ~ 8 ~ O ~ o .., 0\ -f" REAR OF MONITOR

Summary of the content on the page No. 12

1 2 3 1 ~ 6' ?' 1. 4 ::!i ':?: ~.; Monitor Operating Controls and Connections -Page 11 ofl4

Summary of the content on the page No. 13

Mirrorl Nonnal Switch Camera features FIGURE 7 Page 12 of 14 -

Summary of the content on the page No. 14

MARKERS EXAMPLE ~-.~ !-0- 1 . 0--.: --, ~- AGURE 8 -Page 13 of 14 -

Summary of the content on the page No. 15

AOS-33 Operations Manual SPECIFICATIONS: 12 volt DC, negative ground AOS-33 system, 1 camera Rated voltage 10 to 38 volt DC Operating voltage 1.5 amperes Current consumption AOC-75 Camera 0.1 lux Sensitivity NTSC Signal system 1f3" B/VV CCD wfelectronic auto-jris Image sensor 270K piGture elements 110degrees (H). 90degrees M Viewing angle 2.44.. x 1.50" x 1.96.. (W x H x D) Outer dimensions 6.20 cm x 3.81 Gm X 4.98 cm (W x H )( D) 0.8Ibs. Weight 0.'36 Kg NTSC AOM- 70 Monilor Sig"al System Pictur