Summary of the content on the page No. 1
A 200
Hearing Amplifier
Instruction manual
Summary of the content on the page No. 2
Important safety information Important safety information Please read this instruction manual carefully and completely before using the product. Make this instruction manual easily accessible to all users at all times. Always include this instruction manual when passing the product on to third parties. This instruction manual is also available on the Internet at www.sennheiser.com. Preventing health problems Set the volume to a low level when using the product. To protect your hearing,
Summary of the content on the page No. 3
Important safety information To prevent heat accumulation, always ensure that the mains unit is in a safe operating condition and easily accessible, properly plugged into the wall socket and not covered or exposed to direct sunlight for longer periods of time. Only use the mains units, charging cables and accessories recommended by Sennheiser. An overview can be found on www.sennheiser.com. Intended use This product is designed for private domestic use. The personal sound amplifier is suitab
Summary of the content on the page No. 4
Delivery includes Do not mutilate or Switch rechargeable battery- dismantle. powered products off after use. Do not heat above Pack/store charged bat- 70°C/158°F, e.g. do teries so that the terminals not expose to sunlight cannot contact each other – or throw into a fire. danger of shorting out/fire hazard. Immediately remove Do not continue to use rechargeable batteries defective rechargeable from an obviously batteries. defective product. Only use rechargeable Dispose of rechargeable ba
Summary of the content on the page No. 5
Product overview Product overview 1 2 2 7 8 9 6 5 3 A 4 0 1 Ear pads 7 Charging compartment for A 200 2 Microphones 8 DC socket for connection of mains unit 3 Balance control (at the rear) 9 Charging compartment for optional spare rechargeable 4 Battery compartment battery 5 On/off/sound amplification 0 Charging indicator for optional control spare rechargeable battery 6 Indicator for sound A Charging indicator for the A 200’s amplification rechargeable battery Putting the L 200 charger
Summary of the content on the page No. 6
Charging and replacing the rechargeable battery Connecting the charger to the mains EU UK US 8 Connect the connector of the mains unit to the socket8 on the charger (12 V DC). Connect the mains unit to a wall socket. The charger is ready for operation. To disconnect the charger from the mains: Unplug the mains unit from the wall socket. Charging and replacing the rechargeable battery The rechargeable battery can be charged whilst installed in the A 200 or separately in the charging compart
Summary of the content on the page No. 7
Using the A 200 personal sound amplifier Charging the rechargeable battery in the charging compartment at the side of the charger 1 Pull the rechargeable battery out of the A 200’s battery compartment. 2 Insert the rechargeable battery into the charging compartment at the side of the charger. When the rechargeable battery is inserted correctly, the indicator 0 lights up green. 3 Slide the rechargeable battery into the A 200’s battery compart- ment as far as it will go. 1 2 3 0 With a spare BA 1
Summary of the content on the page No. 8
Using the A 200 personal sound amplifier Switching the A 200 on/off Turn the on/off/sound amplification control5 towards ON until you overcome a slight resistance. 5 Adjusting the sound amplification You can choose between 6 different settings for the sound amplification6. Position “1” corresponds to a low sound amplification and position “6” corresponds to a very high sound amplification. Use the control5 to adjust the volume to a sufficient and comfort- able level. If you hear a loud noi
Summary of the content on the page No. 9
Cleaning and maintaining the product Adjusting the balance The balance control allows for right/left volume adjustment. Adjust the balance so that you hear equally well with both ears. If necessary, have the balance adjusted by your hearing aid acoustician. Using a 2 mm slotted screwdriver, turn the balance control3 to the left L or right R in order to increase the volume for the corre- sponding ear. R L 3 Adjusting the bass attenuation The more holes you seal with the sealing tape, the greate
Summary of the content on the page No. 10
Specifications Cleaning and replacing the ear pads The product is supplied with two pairs of ear pads in different fits. You can change to these ear pads to optimize the wearing comfort, if neces- sary. Other spare ear pads are available from your Sennheiser partner. 1 Carefully remove the ear pads from the A 200. 2 Clean the ear pads with warm soapy water and rinse thoroughly. Let the ear pads air dry. 1 2 Specifications A 200 personal sound amplifier Frequency response 200 - 12,000 Hz Max. SP
Summary of the content on the page No. 11
Manufacturer declarations Manufacturer declarations Warranty Sennheiser electronic GmbH & Co. KG gives a warranty of 24 months on this product. For the current warranty conditions, please visit our website at www.sennheiser.com or contact your Sennheiser partner. In compliance with the following requirements: • RoHS Directive (2002/95/EC) • WEEE Directive (2002/96/EC) Please dispose of this product by taking it to your local collec- tion point or recycling centre for such equipment. • Battery D
Summary of the content on the page No. 12
Sennheiser electronic GmbH & Co. KG Am Labor 1, 30900 Wedemark, Germany www.sennheiser.com Printed in Germany, Publ. 04/11, 542699/A01
