Toyota 250-4204 user manual

Summary of the content on the page No. 1

1990 TOYOTA CELICA STWITH 1.6 L ENGINE
THROTTLE LEVER ADAPTOR PACKAG~
250-4204 .
Remove the throttle shaft nut and lock washer from the throttle shaft. Install the Bracket -
1)
Throttle Lever. Reinstall the lock washer and hex nut, and torque the nut to 84 in-lb (7 ft-lb).
Note: Start the nut by hand to prevent cross-threading. Do not over tighten.
,
,..
FI{'; URE 1
-
Loosen This Nut
/
Bracket-Cable
ONLY
I
Bead Chain
1/8. of cable MUST
Connector Cove,\ "
be exposed \
\
,
~~
,\~r1
I
! r R R~ I
-I

Summary of the content on the page No. 2

To use the Snap-In Adaptor, it will be necessary to form threads on the end of the Cruise 6) Control Module Cable. This is accomplished by placing the 1/4" -20 Nut and Washer Assembly on the end of the Cruise Control Module Cable With your fingers, then use a 7/16" box end wrench and turn clockwise, until the desired amount of threads have been formed as shown in Figure 2. Before Threading Cable 01143 ,~ , \ """ f \ NuLand Washer Cruise Control Module ~;embly 114 -20 / Cable \ I ~/ 01150 ~ After