Toyota 250-4211 user manual

Summary of the content on the page No. 1

91/92 TOYOTA TERCEL WITH 1.5L FOUR CYLINDER
ENGINE THROTTLE
LEVER ADAPTOR PACKAGE
250-4211
Remove the throttle shaft nut and lock washer from the throttle shaft. Install the Bracket- ThroUle
1)
Lever on the throttle shaft. Reinstall the lock washer and hex nut, and torque the nut to 60- 72 In/
Lbs (5-6 Ft./Lbs), See Figure 1.
NOTE: START NUT BY HAND FIRST TO PREVENT CROSS THREADING. DO NOT
OVERTIGHTEN HEX NUT.
Pln-Self Th ro ttl e Bo dy
Locking" Bracke~- Throttle Pulley Assembly
'\\ Lever -I
(
A

Summary of the content on the page No. 2

T o use the Snap-In Adaptor, it will be necessary to form threads on the end of the Cruise Control 6) Module Cable. This is accomptished by placing the 114"-20 Nut and Washer Assembly on the end of the Cruise Control Module Cable with your fingers, then use a 7116" box end wrench and turn clockwise, until the desired amount of threads have been formed as shown in Figure 2. Before Threading Cable 7116" Box End Wrench ;-; O:s::s:: ---~ 01143 Cruise Control Module Nut and Washer Assembly Cable 1/4-