Milwaukee ToolsSM806 user manual

Summary of the content on the page No. 1

GENERAL OPERATION: TAKING pH MEASUREMENTS:
• The meter is supplied com- • Always remove the electrode protective
plete with a 9V battery. cap before taking any measurement. If the
Remove the battery com- electrode has been left dry, soak the tip
partment cover on the (bottom 2.5 cm) in M10000 rinse solution
back of the meter and in- for a few minutes to reactivate it.
USER MANUAL
stall the battery while pay-
• Select the pH range with the
ing attention to its polarity.
“RANGE” key.
• Connect the

Summary of the content on the page No. 2

nition of the buffer press the “ON/OFF” but- • The meter will perform automatic calibration, OPTIONAL ACCESSORIES: ton to return to normal mode. and then display “OK” for 1 second before MA9004 pH 4.01 buffer solution, 230 ml bottle returning to normal mode. • For a two point pH calibration, place the MA9006 pH 6.86 buffer solution, 230 ml bottle probe in pH 7.01 buffer (or pH 6.86, if the • The calibration is now complete and the “CAL” MA9007 pH 7.01 buffer solution, 230 ml bottle NIST buffe