Summary of the content on the page No. 1
GPS Field guide
© WHO 2002
Summary of the content on the page No. 2
09/25/02 GPS_field_guide 8:19 A9/P9 CONTENTS CHAPTER 1: INTRODUCTION TO GPS 1.1 What is GPS ?…………………………………………………………...2 1.2 How does GPS work ?…………………………………………………..3 1.3 Source of GPS signal errors……………………………………………...7 CHAPTER 2: WHY USING GPS IN THE CONTEXT OF THE WHO WHS ? CHAPTER 3: PRESENTATION OF THE GARMIN ETREX GPS UNIT 3.1 Overview of the eTrex unit……………………………………………..10 3.2 Utilisation of the eTrex unit…………………………………………….13 3.2.1 Installation of the batteries………………………………………….13 3.2.
Summary of the content on the page No. 3
09/25/02 GPS_field_guide 8:19 A9/P9 CHAPTER 1: INTRODUCTION TO GPS 1.1 What is GPS? The Global Positioning System (GPS) is a system allowing to precisely identify locations on the earth's surface. The GPS system has 3 parts (Figure 1): The Space segment: a network of 24 satellites placed into orbit (Figure 2). The first GPS satellite was launched in 1978 and a full constellation of 24 satellites was achieved in 1994. Each satellite is built to last about 10 years. Replacements are constantly b
Summary of the content on the page No. 4
09/25/02 GPS_field_guide 8:19 A9/P9 1.2 How does GPS work? GPS satellites circle the Earth twice a day in a very precise orbit at an altitude of around 19 000 Kilometres (Figure 2). This constellation allows any user to access between five and eight satellites from any point on the Earth. Figure 2: The GPS Satellite network Each satellite transmits radio signal information which is tracked and used by the GPS receiver to calculate the user's exact location. The satellite sig
Summary of the content on the page No. 5
09/25/02 GPS_field_guide 8:19 A9/P9 The receiver: 1. Calculates the distance to the first satellite he is able to catch. Let's suppose that the receiver calculates a distance of 17'000 km between this first satellite and the receiver. This will mean that the receiver is located somewhere on a sphere that is centred on this first satellite and that has a radius of 17'000 km (Figure 3). Figure 3 - Sphere indicating the potential location of the GPS receiver with one satellite signal 2. Calculates
Summary of the content on the page No. 6
09/25/02 GPS_field_guide 8:19 A9/P9 3. Repeats the operation mentioned under point 2 with a third satellite. In our example the receiver finds out that it is 20,000 km from the third satellite which narrows its position down even further, to the two points (Figure 5 point b) where the 20,000 km sphere cuts through the circle reported on Figure 4 (corresponding to the intersection of the first two spheres). Figure 5 - Potential locations of the GPS receiver with 3 satellites signals (b) Most of t
Summary of the content on the page No. 7
09/25/02 GPS_field_guide 8:19 A9/P9 1.3 Sources of GPS signal errors Even if today's GPS receivers are extremely accurate, certain atmospheric factors and other sources of error can affect the accuracy of GPS receivers. If most of the sources of error are unavoidable, it is important for the user to be aware of the ones that he can influence and be prepared to take steps to reduce their impact. The greatest source of error is connected to the position of the satellite in the sky when taking the
Summary of the content on the page No. 8
09/25/02 GPS_field_guide 8:19 A9/P9 There may also be sources of signal multipath (i.e on Figure 8) occurring when the GPS signal is reflected off these objects before reaching the receiver. This increases the travel time of the signal and creates errors of distance estimation between the satellite and the receiver. 1 2 1 2 Figure 6 Examples of signal multipath Figure 8 - Example of multipath GPS signal connected to buildings or mountains This underlines the importance for the users to be lo
Summary of the content on the page No. 9
09/25/02 GPS_field_guide 8:19 A9/P9 CHAPTER 2: WHY USING GPS IN THE CONTEXT OF THE WHO WHS ? The first reason for using GPS in the WHS context is the added value it gives to the survey by allowing the geographical dimension to be taken into account without requiring important investment (many GPS receivers are inexpensive, GPS data is free, and survey staff can be trained quickly to their use). By knowing the geographic location of each cluster it will be, for example, easier to go back to the s
Summary of the content on the page No. 10
09/25/02 GPS_field_guide 8:19 A9/P9 CHAPTER 3: THE GARMIN ETREX UNIT The Garmin eTrex GPS receiver has been chosen for the WHO WHS because it is easy to use and inexpensive. Its utilisation in the context of different surveys operated in the field has proven its suitability for this kind of work. This device is completely waterproof, runs for approximately 22 hours on two AA alkaline batteries and can operate under dense tree canopy. The present section describes the receiver as well as the oper
Summary of the content on the page No. 11
09/25/02 GPS_field_guide 8:19 A9/P9 Figure 10 - Back view of the Garmin eTrex device Table 1 describes the elements reported on the Figures 9 and 10 Inside the waterproof case are located a set of electronic components that allow the receiver to perform different operations and to display the final result on the LCD screen through a specific operating system. The case also contains an internal built-in clock and memory that has the capacity to store the data received through the satellite signal
Summary of the content on the page No. 12
09/25/02 GPS_field_guide 8:19 A9/P9 1. Internal GPS Antenna This antenna allows the receiver to track satellites signals. Thus, when using the GPS, the unit should be parallel to the ground and facing upwards. Apart from the cover of the holster nothing should be put on this part of the unit as this may stop satellite signal. 2. LCD Display Screen Screen where all the information is displayed. The LCD Display is one fragile part of the eTRex it may be injured and it must be well protected. 3. Th
Summary of the content on the page No. 13
09/25/02 GPS_field_guide 8:19 A9/P9 3.2 Utilisation of the eTrex unit This section presents the major elements that will be used in the context of the WHO WHS. It introduces you to the basic features of the eTrex as well as some basic definitions of terms in a more detailed way than presented on the Quick Reference guide. 3.2.1 Installation of the batteries To install the batteries, remove the battery cover (Figure 10) by turning the D-ring at the back of the receiver 1/4 turn counter-clockwise.
Summary of the content on the page No. 14
09/25/02 GPS_field_guide 8:19 A9/P9 3.2.3 The Garmin eTrex Pages The eTrex operating system is composed of different pages organised in a hierarchical way starting from 4 main pages (Figure 12). The 'NORMAL SKYVIEW SATELLITE' page is one of them. To Switch from one of these main page to the other you have to use the 'PAGE' button. In the context of the WHS we will only need to use two of them: - The 'NORMAL SKYVIEW SATELLITE' page - The 'MENU' page. Figure 12 - The 4 Main pages of the Garmin eT
Summary of the content on the page No. 15
09/25/02 GPS_field_guide 8:19 A9/P9 This information concerns: - The Status of the device. Two type of messages can appear: a) "WAIT…LOCATING SATELLITES" indicating that the receiver is tracking satellite signals. b) "READY TO NAVIGATE" indicating that the receiver has found satellite signals strong enough to know its location and that you can start to use it. - The location accuracy message that is displayed when the device is ready to be used ("ACCURACY"). The value given is an indication of t
Summary of the content on the page No. 16
09/25/02 GPS_field_guide 8:19 A9/P9 You can access to these two pages by pressing the ENTER button from the 'NORMAL SKYVIEW SATELLITE' page in order to open the 'OPTIONS' window. From there you can use the UP and DOWN buttons to highlight the page you want to access and press the ENTER button. Once you have finished working on one of these pages you can come back to the 'NORMAL SKYVIEW SATELLITE' page, pressing the PAGE button again (Figure 14). The 'DISPLAY' page This page allows you to setup t
Summary of the content on the page No. 17
09/25/02 GPS_field_guide 8:19 A9/P9 The 'ADVANCED SKYVIEW SATELLITE' page This page contains the same elements as the 'NORMAL SKYVIEW SATELLITE' page but presented in a different graphical way (Figure 16). This display gives more information about the location of the satellites in the sky (represented as a numbered square) around your location (the point at the centre of the screen). In the Figure 16, the GPS device is surrounded by 9 satellites, 7 of them have a signal strong enough to be recei
Summary of the content on the page No. 18
09/25/02 GPS_field_guide 8:19 A9/P9 Figure 17 - The 'MENU' page There are two options of interest for the WHS on the 'MENU' page: the 'MARK' and 'SETUP' ones. The Figure 18 allows you to visualise how to access to the structure of these two options. Figure 18 - Scheme to access the 'MARK' and 'SETUP' option pages To access to the selected option you have to highlight it in the menu using the 'UP' or 'DOWN' button (on Figure 16 the 'MARK' option is highlighted ) and press the ENTER button. Once y
Summary of the content on the page No. 19
09/25/02 GPS_field_guide 8:19 A9/P9 The 'MARK WAYPOINT' option page Once the GPS receiver has been set-up and that the user has found an open area for the reading, this page will allow the user to visualise his location (Figure 19). The other information or options reported on this page will not be used in the context of the WHS. Figure 19 - the 'MARK WAYPOINT' option page The 'SETUP' option page The 'SETUP' option page (Figure 20) allows the user to customize the eTrex. This page contains a lis
Summary of the content on the page No. 20
09/25/02 GPS_field_guide 8:19 A9/P9 The 'UNITS' setup page This page (Figure 21) allows the user to setup the units of the different parameters. It is important to make sure that this page contains the setting specific to the WHS as indicated in the Figure 21 a) and in the Quick Reference Guide. b) a) Figure 21 - The 'UNITS' page (a) with the scroll down list (b) To change the value or format in a specific field you have to first highlight it using the UP or DOWN button (e.g. the position format
