Summary of the content on the page No. 1
R
R
E
E
B
B
E
E
W
W
Owners Guide
DANGER
If you smell gas:
1. Shut off gas to the appliance.
Liquid Propane Gas
2. Extinguish any open flames.
3. Open lid
4. If odor continues, keep away from the
appliance and immediately call your gas
supplier or your fire department.
Leaking gas may cause a fire or explosion
which can cause serious bodily injury or
death, or damage to property.
WARNING
1. Do not store spare liquid propane
cylinder within 10 feet (3m) of this
appliance.
2. Do not store or us
Summary of the content on the page No. 2
DANGER Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. WARNINGS Do not store a spare or disconnected liquid propane cylinder under or near this barbecue. Improper assembly may be dangerous. Please carefully follow the assembly instructions in this manual. After a period of storage, and/or nonuse, the Weber Gas Barbecue should be checked for gas le
Summary of the content on the page No. 3
Warranty Weber-Stephen Products Co. (Weber) hereby warrants tornadoes, discoloration due to exposure to chemicals to the ORIGINAL PURCHASER of this Weber Gas Grill either directly or in the atmosphere, is not covered by that it will be free of defects in material and this Limited Warranty. workmanship from the date of purchase as follows: There are no other express warrants except as set forth herein and any applicable implied warranties of Aluminum Castings, lifetime, 1 year paint merchantabili
Summary of the content on the page No. 4
Contents Danger & Warnings ....................................................................... A-2 Warranty ........................................................................................ A-3 General Instructions ...................................................................... A-5 Exploded View ............................................................................... A-6 Parts List ....................................................................................... A-
Summary of the content on the page No. 5
Storage General Instructions • The gas must be turned OFF at the LP cylinder Your Weber Gas Barbecue is a portable outdoor when the Weber Gas Barbecue is not in use. cooking appliance. With the Weber Gas Barbecue you • When the Weber Gas Barbecue is stored indoors, can grill, barbecue, roast and bake with results that are the gas supply must be disconnected and the LP difficult to duplicate with indoor kitchen appliances. cylinder stored outdoors in a well-ventilated space. The closed lid and Fl
Summary of the content on the page No. 6
1 Genesis Gold-B LP 2 3 36 4 5 37 6 7 8 9 38 39 10 40 41 11 42 12 43 13 44 45 14 46 15 16 17 47 18 48 49 19 20 50 41 21 17 22 16 23 24 19 25 26 27 18 28 51 52 29 53 30 31 54 26 55 56 57 32 33 58 59 34 35 A-6
Summary of the content on the page No. 7
1. Hair Pin Cotter 35. Bottom Shelf 2. Hinge Pin 36. Thermometer 3. Left Endcap 37. Right Endcap 4. Shroud 38. Burner Control Knobs 5. 1/4-20 x 1 1/4 inch Bolt 39. Control Panel 6. Handle lock 40. Igniter Button 7. Handle 41. Control Panel Hardware ™ 8. Warm-Up Basket 42. Crossover Tube 9. Warming Rack 43. Front and Back Burners 10. Cooking Grates 44. Center Burner ® 11. Flavorizer Bars 45. Spider Stopper Guards 12. Cooking Box 46. Manifold, Hose and regulator (assembled) 13. 1/4-20 keps nut 47.
Summary of the content on the page No. 8
© 1999 Weber-Stephen Products Co., Weber, the silhouette, and the kettle configuration are registered trademarks ® of Weber-Stephen Products Co., 200 East Daniels Road, Palatine, IL, 60067-6266, U.S.A. This product is covered by one or more United States patents and patents in other nations globally. Printed in the U.S.A. A-8
Summary of the content on the page No. 9
Remove Packaging from Grill Remove Grill from Lower Packaging Remove all tape from packaging. Remove bottom rack from top of packaging. Remove outer box. Pull out WARNING: Lifting the barbecue from the lower bottom tray from cooking box. Remove packaging packaging requires at least two people. material from bottom tray, catch pan holder, catch pan, With two people: lift straight up and over lower and drip pan. packaging and cardboard support. A-9
Summary of the content on the page No. 10
You will need: 1/2 inch bolts (1/4 x 20 x 1/2 inch bolts) - 4 Phillips screwdriver 7/16 open-end or an adjustable wrench Nylon Washers - 4 Flavorizer Bars - 5 Left Work Surface - 1 Cooking Grates - 2 Condiment basket - 1 Right Work Surface - 1 Bottom Shelf - 1 LP Cylinder - 1 Slide Out Buttom Tray - 1 Catch pan holder - 1 Catch Pan - 1 Disposable Drip Pans - 2 A-10
Summary of the content on the page No. 11
Assembly Instructions Install the slide out bottom tray Slide the bottom tray onto the mounting rails under the You will need: the slide out bottom tray(1), catch pan cooking box with finger grip toward you(1). holder(2), catch pan and one disposable drip pan. WARNING: Do not line bottom tray with alumi- num foil. It can cause grease fires by trapping the grease and not allowing grease to flow into the catch pan. (1) (2) Hook the ends of the catch pan holder into the hole in (1) the slide out
Summary of the content on the page No. 12
Install Flavorizer® Bars and Cooking Grates Installing the warming rack You will need: five Flavorizer Bars and two cooking You will need: warming rack. grates. Set the warming rack into the slots at the rear of the Place the Flavorizer Bars side by side in the cooking cooking box. box. Set the cooking grates onto the ledges in the cooking box with the rounded sides up. Install the bottom shelf You will need: Bottom shelf. Set the bottom shelf in place between the two frame connectors underneath
Summary of the content on the page No. 13
Installing work Surfaces & Gas Connection Guidelines Install Left Work Surface Check that all burner valves are off You will need left work surface, two 1/2 inch bolts, two You will need: burner control knobs. nylon washers and a 7/16 inch or adjustable wrench. Valves are shipped in the OFF position, but you should Insert the left work surface tabs in the slots in the check to be sure that they are turned OFF. Put the frame(1). Slip washers on the bolts and insert the bolts knob on each valve. C
Summary of the content on the page No. 14
Hang filled liquid propane cylinder on fuel gauge Important LP Cylinder Information Loosen the tank lock wing nut. Swing the cylinder lock Failure to follow these DANGER statements exactly up. Tighten the wing nut so that the cylinder lock is up may result in a fire causing death or serious injury. and to the side. Hook the liquid propane cylinder onto DANGER the fuel gauge. Loosen the tank lock wing nut. Swing NEVER store a spare LP Cylinder under or near the tank lock down. Tighten the wing
Summary of the content on the page No. 15
Connect filled liquid propane cylinder Remove the control panel WARNING: Make sure that the cylinder valve is (1) Unscrew the two phillips screws, located on the closed. Close by turning clockwise. right edge of the control panel. Remove plastic dust cover from the fuel cylinder valve. (2) Take off the burner control knobs. Screw the regulator coupling onto the tank valve(1), (2) clockwise, or to the right. Hand tighten only. Note: This is a new type of connection. It tightens clockwise and wi
Summary of the content on the page No. 16
Check: Check for gas leaks 1) Hose to manifold connection. DANGER WARNING: If there is a leak a connection(1), Do not use an open flame to check for gas retighten the fitting with a wrench and recheck for leaks. Be sure there are no sparks or open leaks with soap and water solution. flames in the area while you check for If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE. leaks. Sparks or open flames will result in Contact the Customer Service Re
Summary of the content on the page No. 17
Reinstall control panel (after checking for gas Install Right Work Surface leaks) You will need right work surface, two 1/2 inch bolts, (1) Set the control panel in place over both sides of two nylon washers and a 7/16 inch or adjustable the frame. Hold the crossover ignition button up wrench. while setting the control panel in place. Insert the right work surface tabs in the slots In the (2) Line up the control panel with the white plastic frame(1). Slip washers on the bolts and insert the bolt
Summary of the content on the page No. 18
Operating m DANGER: Lighting When the “excess gas flow control” feature is Summary lighting instructions are on the control panel. activated, a small amount of gas I still flowing to the burners. After turning OFF the cylinder knobs, m DANGER wait at least 5 minutes for the gas to clear before Failure to open the lid while igniting the attempting to light the barbecue. Failure to do so barbecue’s burners, or not waiting 5 min- may result in an explosive flame-up, which can utes to allow the gas
Summary of the content on the page No. 19
3) Turn the cylinder on by turning the cylinder valve Manual Lighting counterclockwise. 4) Strike a match and put the flame into the m DANGER matchlight hole in the front of the cooking box. Failure to open the lid while igniting the m WARNING: Do not lean over open barbecue. barbecue’s burners, or not waiting 5 min- Keep your face and body at least one foot away utes to allow the gas to clear if the barbe- from the matchlight hole when lighting the barbe- cue does not light, may result in an ex
Summary of the content on the page No. 20
n The Weber Gas Barbecue should be checked for Cooking gas leaks and any obstructions in the burner tubes m WARNING: Do not move the Weber Gas Barbe- before using. (See Sections: “General Maintenance cue when operating or while barbecue is hot. and Annual Maintenance.”) You can adjust the FRONT and BACK burners as n Check that the areas under the control panel and desired. The control settings: High (H), Medium (M), the slide out bottom tray are free from debris that Low (L), or Off (O) are desc
