Summary of the content on the page No. 1
the
S rc
ou e
Stainless Steel Gas Grill
USE AND CARE GUIDE
MODEL NO.: 720-0050-LP
®
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-913-8999 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
Summary of the content on the page No. 2
TABLE OF CONTENTS SECTION ONE SECTION FIVE Safety Instructions…………………………1~5 Using the Side Burner…………………… Placement of the grill………………………5 16 Care & Maintenance ………………. 16 Care & Maintenance of Side Burner….. SECTION TWO 17 Trouble Shooting………………………… Installation of Side Shelves..………….….6 17~19 Installation of Side Door Handle………….7 SECTION SIX Installation of Battery………………………7 Exploded View…………………………….. 20 Installation of Spi
Summary of the content on the page No. 3
SAFETY INSTRUCTIONS ***** WARNING ***** FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open Lid. 4. If odor continues, immediately call your gas supplier or your fire department. FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2. An LP cylinder not connected for use shall not be stored in the v
Summary of the content on the page No. 4
SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section of this manual. DO NOT USE ALUMINUM FOIL TO LINE THE GRILL RACKS OR GRILL BOTTOM. This can severely upset combustion airflow or trap excessive heat in the control area. INSECT WARNING!!! Spiders and insects can nest in the burners of this and any other grill, and cause the gas to flow improperly. This
Summary of the content on the page No. 5
SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING: Always keep your face and body as far away from the burner as possible when lighting. WARNING: IMPORTANT! BEFORE LIGHTING… Inspect the gas supply hose prior to turning the gas “ON”. If there is evidence of cuts, wear, or abrasion, it must be replaced prior to use. Do not use the grill if the odor of gas is present. Only the pressure regulator and hose assembly supplied with the unit should be used. Never sub
Summary of the content on the page No. 6
SAFETY INSTRUCTIONS CHILDREN SHOULD NOT BE LEFT ALONE OR TESTED IN ACCORDANCE WITH ANSI Z21.58b UNATTENDED IN AN AREA WHERE THE GRILL IS LATEST STANDARD and CGA 1.6b-2002 BEING USED. NEVER ALLOW THEM TO SIT, STANDARD FOR OUTDOOR COOKING GAS STAND OR PLAY ON OR AROUND THE GRILL AT APPLIANCES. THIS GRILL IS FOR OUTDOOR ANY TIME. USE ONLY. DO NOT STORE ITEMS OF INTEREST TO Check your local building codes for the proper CHILDREN AROUND OR BELOW THE GRILL OR IN method of installat
Summary of the content on the page No. 7
SAFETY INSTRUCTIONS When using the grill, do not touch the grill rack, Do not use the grill for cooking excessively fatty burner grate or immediate surroundings as meats or products, which promote flare-ups. Do these areas become extremely hot and could not operate the grill cause burns. Use only dry potholders. Moist or damp potholders on hot surfaces may cause under unprotected combustible construction. Use burns from steam. Do not use a towel or bulky only in well ventilated areas.
Summary of the content on the page No. 8
the Source the Source INSTALLATION OF SIDE SHELVES The screws for the side shelves mount are already screwed into the two sides of the grill. Remove the screws and install the right shelf as shown in the figure below. Repeat the above step to install the left shelf on left side panel. 6
Summary of the content on the page No. 9
the Source h t e Source INSTALLATION OF SIDE DOOR HANDLE Take out the side door handle assembly from hardware bag. Remove the screws from side door handle, (see the figure below), attach on the door handle, and screw into the holes of the side door of the grill. INSTALLATION OF BATTERY In order to install the battery, remove the ignition button housing. Repeat the ignition button housing after battery is installed. Please keep the positive pole facing toward you.
Summary of the content on the page No. 10
the Source INSTALLATION OF SPICE TRAY AND DIVIDING SHELF Place the dividing shelf inside the left door. INSTALLATION OF ROTISSERIE KIT After install the rotisserie motor mount, Assemble the rotisserie skewer as shown in the figure below. 8
Summary of the content on the page No. 11
CLOSE the Source INSTALLATION OF PROPANE TANK Attach regulator to the propane tank by turning the regulator handle clockwise (see the figure below ). Turn off LP supply at cylinder when appliance is not in use. g Put the gas tank into the gas tank pull-out tray. Then tighten up the gas tank fixed pole. 9 OPEN
Summary of the content on the page No. 12
TO MATCH LIGHT THE GRILL If the burner will not light after several attempts then the burner can be match lit. If you’ve just attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. Keep your face and hands as far away from the grill as possible. Insert a lit extended match or lighter through the cooking grids to the burner. Press the control knob and rotate left to the HI setting, continue to press the knob until the burner ignites. Burne
Summary of the content on the page No. 13
GAS HOOK-UP Only the pressure regulator and hose assembly LP Gas Cylinder must be fitted with Overfill supplied with the grill should be used. Any Protection Device (OPD). replacement pressure, regulator and hose LP GAS HOOK-UP: assembly must be specified by the grill Ensure that the black plastic grommets on the LP manufacturer. cylinder valve are in place and that the hose does not This is a liquid propane configured grill. come into contact with the grease tray or the grill
Summary of the content on the page No. 14
LEAK TESTING GENERAL Although all gas connections on the grill are leak local gas supply may make it necessary to adjust the tested at the factory prior to shipment, a complete burners, the flames of the burners Should be visually gas tightness check must be performed at the checked. installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks following the procedures
Summary of the content on the page No. 15
INSTALLER FINAL CHECK Specified clearance maintained 24” from Unit tested and free of leaks. combustibles. User informed of gas supply shut off valve All internal packaging removed. location. Knobs turn freely. Burners are tight and sitting properly on PLEASE RETAIN THESE INSTRUCTIONS FOR orifices. Pressure regulator connected and set for FUTURE REFERENCE. 11.2” W.C. LP gas. Gas connections to grill using hose & regulator assembly provided (pre-set for 11.0” water column
Summary of the content on the page No. 16
OPERATING INSTRUCTIONS General use of the grill and rotisserie motor, and then sliding the grooved bushing into the Each main burner is rated at 12,000 BTU/hr. The main slot at the opposite side of the grill. The thumbscrew grill burners encompass the entire cooking area and for the grooved bushing should be inside the grill are side ported to minimize blockage from falling body. To load the skewer, begin with the bushing grease and debris. Above the burners are stainless screwed on the s
Summary of the content on the page No. 17
LIGHTING INSTRUCTIONS WARNING: IMPORTANT! these conditions exist call our customer service line. If the flame is yellow, it indicates insufficient BEFORE LIGHTING… air. If the flame is noisy and tends to lift away Inspect the gas supply hose prior to turning the from the burner, it indicates too much air. gas “ON”. If there is evidence of cuts, wear, or TO MATCH LIGHT THE GRILL: abrasion, it must be replaced prior to use. Do not If the burner will not light after several attempts
Summary of the content on the page No. 18
USING THE SIDE BURNER control knob counterclockwise to the “HI” position. WARNING: IMPORTANT! If the burner does not light, turn the control knob to USING THE SIDE BURNER: “OFF”. If the smell of gas is detected and the igniter Inspect the gas supply hose prior to turning the is not functioning, immediately turn the control knob gas “ON”. If there is evidence of cuts, wear or “OFF”. Allow 5 minutes for any accumulated gas to abrasion, it must be replaced prior to use. Do not dissipate
Summary of the content on the page No. 19
CARE & MAINTENANCE OF SIDE BURNER SIDE BURNER CLEANING: Clean the exterior of the burner with a wire brush. Clear any clogged burner ports with a straightened paper clip. Never enlarge the burner ports. Never use a wooden toothpick as it may break off and clog the port. STAINLESS STEEL: There are many different stainless steel cleaners available. Always use the mildest cleaning procedure first, scrubbing in the direction of the grain. Do not use steel wool, as it will scratch the su
Summary of the content on the page No. 20
TROUBLE SHOOTING PROBLEM SOLUTION When I light the grill it does not flame --Make sure you have turn on the gas immediately. --Make sure it has spark while you are trying to ignite the burner. --Push in for approximately 5 second before to turn and ignite the grill. --Make sure your burner is clean. Rotisseries burner will not light when --Check to see if debris is blocking the electrode the igniter button is pushed. sparks. --Check to see there is spark that jumps to the bur
