Summary of the content on the page No. 1
Use & Care Guide
ModeJ: 415.16139110
I@ @ @
P/N G523-001-010801
Sears Brands Management Corporation
Hoffman Estates, IL 60179 U.S.A.
www.kenmore.com
www.sears.com
Model 464224211 ° Nov-03-10
Summary of the content on the page No. 2
CALIFORNIA PROPOSITION 65 If you smell gas: 1. Combustion by-products produced when using this |. Shut off gas to the appliance. product contain chemicals known to the State of 2. Extinguish any open flame. California to cause cancer, birth defects, and other reproductive harm. 3. Open lld. 2. This product contains chemicals, including lead 4. If odor continues, keep away from the appliance and lead compounds, known to the State of and immediately call your gas supplier or your California to cau
Summary of the content on the page No. 3
For Your Safety. ............................................................. 2 KENMORE ELITE FULL WARRANTY Grill Information Center ............................................. 2 If this grill fails due to a defect in material or workmanship within two years from the date of purchase, call 1-800-4-MY- Product Record Information ........................................ 2 HOME®to arrange for free repair (or replacement if repair proves impossible). Safety Symbols ...............................
Summary of the content on the page No. 4
LP Tank * The LP Tank used with your grill must meet the following requirements: * Use LP Tanks only with these required measurements: 12" f x, II _I (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. • NEVER store a spare LP cylinder under or near the * LP Tanks must be constructed and marked in accordance appliance or in an enclosed area. with specifications for LP Tanks of the U.S. Department of Transportation (DOT) or for Canada, CAN/CSA-B339, tanks, spheres and
Summary of the content on the page No. 5
LP Tank Exchange Connecting Regulator To The LP Tank * Many retailers that sell grills offer you the option of l. LP tank must be properly secured onto grill. (Refer to replacing your empty LP tank through an exchange service. assembly section.) Use only those reputable exchange companies that inspect, precision fill, test and certify their tanks. Exchange your 2. Turn all control knobs to the OFF position. tank only for an OPD safety feature-equlpped tank as 3. Turn LP tank OFF by turning OPD h
Summary of the content on the page No. 6
Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. 2. Be sure regulator is tightly connected to LP tank. 3. Completely open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection. Correct before proceeding by calling Sears for replacement parts at 1-800-4-MY-HOME ®. Hold coupllncj nut and regulator 4. Brush soapy solution onto areas where bubbles are shown in as shown fo
Summary of the content on the page No. 7
Safety Tips • Before opening LPcylinder valve, check the coupling nut for tightness. • When grill is not in use, turn off all control knobs and LP For Safe Use of Your Grill and to Avoid Serious cylinder valve. Injury: • Never move grill while in operation or still hot. " Use long-handled barbecue utensils and oven mitts to avoid • Do not let children operate or play near grill. burns and splatters. • Maximum load for sideburner and side shelf is 10 Ibs. • Keep grill area clear and free from mat
Summary of the content on the page No. 8
Match-Lightlng Main Burner lcjnltor Lighting • Do not lean over grill while lighting. " Open grill lld during Lighting. • Open lld. Turn on gas at LP cylinder. • Do not lean over grill while lighting. • Light Burners one at time. I. Turn OFF all Gas Burner Control Valves. Match Lighting the Main Burners 2. Turn ON gas at LP cylinder. 1. Place match into match holder (hanging from RH side or 3. To ignite any main burner, push in and turn the burner LH side of the cart). control knob to the _ posi
Summary of the content on the page No. 9
Sideburner Ignltor Lighting Do not lean over grill while lighting. CAUTION 1. Open sldeburner lld. Turn ON gas at LP cylinder. 2. Turn sideburner knob to the HI position, push and hold ELECTRONIC IGNITOR button. 3. If sideburner does NOT light within 5 seconds, turn knob SPIDER ALERT! to OFF, wait 5 minutes, then repeat lighting procedure. Match lighting the Side Burner - Figure D 1. Open the sideburner lid during lighting. 2. Place match in match holder. Strike the Match. Position lit match clo
Summary of the content on the page No. 10
Cleaning the Main Burner Assembly General Grill Cleaning Follow these instructionsto clean and/or replace parts of burner " Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not assembly or if you have trouble igniting grill. painted at the factory (and should never be painted). 1. Turn gas off at control knobs and LPTank. Apply a strong solution of detergent and water or use a 2. Remove cooking grates and heat diffusers. grill cleaner with scr
Summary of the content on the page No. 11
Grill Halogen Light LIGHT OPERATION iNSTRUCTiONS 2. 3. 1. Make sure light switch on the control panel is in the "OFF" position. 2. Connect light plug to an extension cord, then plug the extension cord into the outlet on the wall. 3. Turn the light switch to "ON'. Light cordf for outdoor use = Keep any electrlcal suppJy cord away from any heated surface. = Use the shortesf length extension cord required. Do not connect 2 or more extension cords together Bulb Replacement & Make sure light switch o
Summary of the content on the page No. 12
Cleaning the Lens 1. Prior to cleaning, make sure the light switch is in the "OFF" position and the light plug is disconnected from the power supply. 2. Do nat dean the glass lens when warm. Allow to coal before cleaning. Sudden change in temperature may cause cracking of the glass lens. 3. Use a damp towel to clean the surface of the glass lens. 4. Allow the lens to dry before reconnecting the light plug to the power supply and turning the llght switch to the "ON" position. IIIIIiM PO AN""F Sin
Summary of the content on the page No. 13
1 1 LEFT SIDE SHELF G523-1100-W1 48 1 BOTTOM SHELF G523-0025-W1 2 1 FASCIA, LEFT SHELF G523-OO51-W1 49 2 DOOR MAGNET ASSEMBLY G501-0016-W2 3 1 RIGHT SIDE SHELF G523-1200-W1 50 1 TANK SHELF ASSY G523-4100-W1 4 1 FASCIA, RIGHT SHELF G523-OO52-W1 51 1 LEFT SIDE PANEL G523-0800-W1 5 1 TOP LID G523-O100-W1 52 1 RIGHT SIDE PANEL G523-0900-W1 6 1 INNER INSERT, F/TOP LID G523-OOO1-W1 53 2 LOCKING CASTER G523-0028-W1 7 1 TEMPERATURE GAUGE G518-OO75-W1 54 2 FIXED CASTER G523-0029-W1 8 1 BEZEL, F/TEMPERATU
Summary of the content on the page No. 14
® 14,464224211
Summary of the content on the page No. 15
insert flange on left side shelf into side shelf brackets, shown A. Attach left side shelf rear using two 1/4-20xl/2" screws, 7mm lock washers and 7mm fiat washers, shown Bo Attach left side shelf front using three 1/4-20xl/2" screws, 7mm lock washers and 7mm fiat washers, shown C © 7mm fiat washer 4-20x1/2 '' screw 7mm lock washer y.5 Qty.5 Qty.5 m 1/4-20xl/2" 7mi fiat screw washer 464224211 ° 15
Summary of the content on the page No. 16
insert flange on right side shelf into side shelf brackets, shown A. Attach right side shelf top using two 1/4-20x3/4" screws, 7mm fiat washers, 7mm lock washers and 1/4" nuts, shown B. Attach right side shelf rear using one 1/4-20x3/4" screw, 7mm lock washer and 7mm flat washer, shown C. Attach right side shelf front using two 1/4-20xl/2" screws, 7ram lock washers and 7ram flat washers, shown D. \ screw 4-20x3/4 '' y.3 screw 4-20xl/2" ty.2 7mm flat washer Qty.5 7mm lock washer 7mm lock washer Q
Summary of the content on the page No. 17
Install heat diffusers by sliding one end of each heat diffuser into slots at front of firebox and resting opposite end on pins at back of firebox. Make sure to install the shorter heat diffuser in A position, and install the two longer heat diffusers in B and C position. Heat diffuser Place cooking grates onto the firebox as shown, insert the three wire ends at rear of warming rack into holes in back of firebox. Front wires of warming rack rest on sides of firebox. Wa 464224211 ° 17
Summary of the content on the page No. 18
Place sideburner grate into sideburner shelf, aligning grate legs with holes in shelf. On back of grill, slide grease tray into opening in lower back panel. CAUTION U Failure to install grease tray will cause hot grease to drip from bottom of grill with risk of Nre or property damage. Grease tray 18 ° 464224211
Summary of the content on the page No. 19
H Unscrew electronic ignition cap on cart right side panel. Insert AA battery into ignitor, negative(-) end first. Replace the cap. A_ Battery Electronic Ignition Cap LP TANK IS SOLD SEPARATELY. Fitl and leak check the tank before attaching to grill and regulator (see Use & Care section). Once tank has been filled and checked for leaks, slide tank tray in bottom shelf forward. Fully loosen tank screw at bottom of tank tray. Insert tank into tray with tank valve facing to right side of cart. Secu
Summary of the content on the page No. 20
install door organizers Back of left door: Attach bag hook by inserting wire ends in the holes on the door, shown A. Attach condiment tray by sliding it onto tabs on lower door back panel, shown A. Back of right door: Attach condiment trays by sliding them onto tabs on upper and lower door back panel, shown B. Attach paper towel holder between condiment trays, shown B. 20"464224211
